Effects of Electrostatic Voltage and Polarity on Diffusion-Controlled Propane Flame for Enhanced Efficiency
Publication: Journal of Energy Engineering
Volume 144, Issue 2
Abstract
In this study, the direct current (DC) electric field effect on the diffusion-swirling flame dynamics and flame temperature profiles was investigated experimentally with the aim of establishing the feasibility of electric control of combustion in controlling the heat transfer rate and formation. It was observed that with an increase in voltage and change in polarity, the flame configuration, such as shape, size, and length, changes as a result of drastic change in temperature profile for the fuel lean case along the combustor length. Although air flow was turbulent, generating an irregularly dynamic flame, the applied voltage and polarity made the temperature profile more uniform throughout the combustor. Consequently, it was observed that the applied electric field played a vital role in manipulating the flame significantly in terms of flame shape, size, temperature distribution, and flame behavior. Hence by varying the applied voltage from 0 to 2 kV with positive and negative polarities, a field-enhanced reduction in flame temperature was obtained due to increased convective heat transfer to the cooling water, which finally led to lowering thermal formation during the fuel combustion. In the current experimental case the maximum reduction was approximately 30%. A clear difference in sooting behavior was also observed depending on the polarity. While the soot particles accumulated on the injector base away from the positive electrode, they stuck to the negative electrode.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was financially supported by the seed money project of the KUSTAR-KAIST Institute, KAIST, South Korea.
References
Afanas’ev, V. V. (1999). “Active control of combustion stability by means of an electric discharge.” Combust. Explosion Shock Waves, 35(3), 252–260.
ANSYS Maxwell 2D [Computer software]. ANSYS, Canonsburg, PA.
Barmina, I., Descnickis, A., Meijere, A., and Zake, M. (2007). “Active electric control of emissions from swirling combustion.” Adv. Combust. Aerothermal Technol., 405–412.
Barmina, I., Kolmichovs, A., Valdmanis, R., and Zake, M. (2015). “Control of combustion dynamics by an electric field.” Chem. Eng. Trans., 43, 973–978.
Barmina, I., Purmalis, M., Valdmanis, J., and Zake, M. (2010). “Electric field effects on the combustion characteristics of renewable fuel.” Int. Scientific Colloquium Modelling for Material Processing, Latvian Council of Sciences, Riga, Latvia.
Berman, C. H., Gill, R. J., and Calcote, H. F. (1991). “NOx reduction in flames stabilized by an electric field.” ASME Fossil Combustion Symp. 3rd Energy-Sources Technology Conf., ASME, New York.
Calcote, H. F., and Keil, D. G. (1988). “Ion-molecule reactions in sooting acetylene-oxygen flames.” Combust. Flame, 74(2), 131–146.
Collins, M. M., Cooper, C. D., Dietz, J. D., Clausen, C. A., III, and Tazi, L. M. (2001). “Pilot-scale evaluation of injection to control emissions.” J. Environ. Eng., 329–336.
Eraslan, A. N., and Brown, R. C. (1988). “Chemiionization and ion-molecule reactions in fuel-rich acetylene flames.” Combust. Flames, 74(1), 19–37.
Fang, J., Wu, X., Duan, H., Li, C., and Gao, Z. (2015). “Effects of electric fields on the combustion characteristics of lean burn methane-air mixtures.” Energies, 8(4), 2587–2605.
Farraj, A. R. D., AL-Naeemy, A. M., Al-Khateeb, A. N., and Kyritsis, D. C. (2017). “Laminar non-premixed counterflow flames manipulation through the application of external direct current fields.” J. Energy Eng., 04017002.
Fialkov, A. B. (1997). “Investigations on ions in flames.” Prog. Energy Combust. Sci., 23(5), 399–528.
Glassman, I. (1977). Combustion, Academic Press, New York.
Heinsohn, R. J., Wilhelm, C. F., and Becker, P. M. (1970). “Effect of electric fields on ducted diffusion flames.” Combust. Flame, 14(3), 341–349.
Karnani, S., and Dunn-Rankin, D. (2015). “Detailed characterization of DC electric field effects on small non-premixed flames.” Combust. Flame, 162(7), 2865–2872.
Kim, M. K., Chung, S. H., and Kim, H. H. (2012). “Effect of the electric fields on the stabilization of premixed, laminar Bunsen flames at low AC frequency: Bi-ionic wind effect.” Combust. Flame, 159(3), 1151–1159.
Lu, J., Ren, X., and Cao, L. (2015). “Studies on characteristics and formation of soot nanoparticles in an ethylene/air inverse diffusion flame.” J. Energy Eng., 04015041.
Onischuk, A. A., et al. (2001). “Coulomb interactions in soot particle formation.” J. Aerosol Sci., 32, 71–82.
Pederson, T., and Brown, R. C. (1993). “Simulation of electric field effects in premixed methane flames.” Combust. Flames, 94(4), 433–448.
Rickard, M., Dunn-Rankin, D., Weinberg, F., and Carleton, F. (2005). “Characterization of ionic wind velocity.” J. Electrostat., 63(6–10), 711–716.
Sorokin, A., Vancassel, X., and Mirabel, P. (2003). “Emission of ions and charged soot particles by aircraft engines.” Atmos. Chem. Phys., 3(2), 325–334.
Weinberg, F. J., Dunn-Rankin, D., Carleton, F. B., Karnani, S., Markides, C., and Zhai, M. (2013). “Electrical aspects of flame quenching.” Proc. Combust. Inst., 34(2), 3295–3301.
Won, S., Ryu, S., Kim, M., Cha, M., and Chung, S. (2008). “Effect of electric fields on the propagation speed of tribrachial flames in coflow jets.” Combust. Flame, 152(4), 496–506.
Information & Authors
Information
Published In
Journal of Energy Engineering
Volume 144 • Issue 2 • April 2018
Copyright
©2018 American Society of Civil Engineers.
History
Received: Aug 9, 2017
Accepted: Sep 26, 2017
Published online: Jan 18, 2018
Published in print: Apr 1, 2018
Discussion open until: Jun 18, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.