Experimental Research of a New Steam Heat Pump System for Recovering Industrial Waste Heat
Publication: Journal of Energy Engineering
Volume 143, Issue 5
Abstract
In accordance with current industrial waste heat and heat requirements, a new steam heat pump system used for recovering industrial waste heat is proposed in this paper which consists of a vapor compression–type high-temperature heat pump (VCHTHP) and an injector heat pump. As the experimental results show, if the primary steam is superheated vapor at 300°C and 3.5 MPa, and the secondary steam is 0.20–0.22 MPa, then compressible steam with a condensing temperature of approximately 160°C can be obtained with a maximum entrainment ratio of 0.39. Through a combination of the VCHTHP and the injector heat pump, the entire heat pump system can recover waste heat from industrial sewage at a temperature of 80°C to produce compressible steam with a condensing temperature of approximately 160°C and a coefficient of performance (COP) of the optimum condition of 1.19. If the compressible steam is used to heat the reboilers in a chemical plant, 28% more high-pressure steam can be saved compared with that from the original heating system, with power consumption only taking 32.5% of the recovered heat.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the 973 National Key Basic Research Program of China (No. 2015CB251403) and the Tianjin Natural Science Foundation (16JCYBJC20500).
References
Bor, D. M., Infante, C. A., and Kiss, A. A. (2015). “Low grade waste heat recovery using heat pumps and power cycles.” Energy, 89(9), 864–873.
Cao, X. Q., Yang, W. W., Zhou, F., and He, Y. L. (2014). “Performance analysis of different high-temperature heat pump systems for low-grade waste heat recovery.” Appl. Therm. Eng., 71(7), 291–300.
Chen, C. H., Cao, J. F., and Hou, C. J. (2014). “Application of steam jet type heat pump in chemical plant.” Chem. Fert. Des., 52(3), 55–57.
Chinese Academy of Sciences. (2011). “Policy and technology research of industrial energy saving.” Energy and Technology Reference, Beijing.
Cui, G. M., He, Y. M., Liu, J. P., Chong, D. T., and Yan, J. J. (2014). “Thermal economic study on regenerative heating system with injector pump.” J. Eng. Thermophys., 35(3), 521–524.
He, Y. N., Cao, F., Jin, L., Wang, X. L., and Xing, Z. W. (2015). “Experimental study on the performance of a vapor injection high temperature heat pump.” Int. J. Refrig., 60(8), 1–8.
Li, M. Q., Wang, J. F., He, W. F., Wang, B., Ma, S. L., and Dai, Y. P. (2013). “Experimental evaluation of the regenerative and basic organic Rankine cycles for low-grade heat source utilization.” J. Energy Eng., 190–197.
Li, M. Q., Wang, J. F., Li, S. L., and Dai, Y. P. (2015). “Experimental study and numerical simulation of a regenerative ORC utilizing low-grade heat source.” J. Energy Eng., 04014011.
Li, S. L., and Dai, Y. P. (2015). “Thermo-economic analysis of waste heat recovery ORC using zeotropic mixtures.” J. Energy Eng., 04014050.
Lu, H. Y., Price, L., and Zhang, Q. (2016). “Capturing the invisible resource: Analysis of waste heat potential in Chinese industry.” Appl. Energ., 161(10), 497–511.
Ma, G. Y., Cai, J. J., Zheng, W. W., and Dong, H. (2012). “Analytical research on waste heat recovery and utilization of China’s iron & steel industry.” EnergyProcedia, 14, 1022–1028.
Manolakos, D., Kosmadakis, G., Kyritsis, S., and Papadakis, G. (2009). “On site experimental evaluation of a low-temperature solar organic Rankine cycle system for RO desalination.” Solar Energy, 83(5), 646–656.
Md, S. R., et al. (2016). “Efficient energy consumption in industrial sectors and its effect on environment: A comparative analysis between G8 and Southeast Asian emerging economies.” Energy, 97(2), 82–89.
Oluleye, G., Jobson, M., Smith, R., and Perry, S. J. (2016). “Evaluating the potential of process sites for waste heat recovery.” Appl. Energy, 161(1), 627–646.
Sag, N. B., and Ersoy, H. K. (2016). “Experimental investigation on motive nozzle throat diameter for an ejector expansion refrigeration system.” Energy Convers. Manage., 124(9), 1–12.
Shi, G. H., Wang, S. L., and Jing, Y. Y. (2013). “Evaluation of a double-stage coupled heat pump for heating: Performance optimization and case study.” J. Energy Eng., 198–206.
Sokurov, E., and Giggle, H. M. (1977). Injector, Science Press, China.
Sun, F. T., Fu, L., Sun, J., and Zhang, S. G. (2014). “A new ejector heat exchanger based on an injector heat pump and a water-to-water heat exchanger.” Appl. Energy, 121(5), 245–251.
Wang, X., Yu, J. L., and Xing, M. B. (2015). “Performance analysis of a new ejector enhanced vapor injection heat pump cycle.” Energy Convers. Manage., 100(8), 242–248.
Wu, X. K., Xing, Z. W., He, Z. L., Wang, X. L., and Chen, W. Q. (2016). “Performance evaluation of a capacity-regulated high temperature heat pump for waste heat recovery in dyeing industry.” Appl. Therm. Eng., 93(1), 1193–1201.
Xia, H. D., Zhang, H. L., Xu, Y. J., Chen, H. H., and Tan, C. Q. (2011). “Investigations on industrial energy saving potential and counter measures in China.” J. Eng. Thermophys., 32(12), 1992–1996.
Xu, X., Wang, Y. C., and Zhang, B. (2014). “Cogeneration heating system based on injector heat pumps.” CIESC J., 65(3), 1025–1032.
Zhang, B., Wang, Y. C., Kang, L. S., and Lv, J. S. (2013). “Study of an innovative ejector heat pump-boosted district heating system.” Appl. Thermal Eng., 58(1–2), 98–107.
Zhang, K., Shen, S. Q., Yang, Y., and Tian, X. W. (2012). “Experimental investigation of adjustable ejector performance.” J. Energy Eng., 125–129.
Zhang, Y. F., Kong, L. T., Yu, X. H., Zhang, Y., and Gao, Y. (2016). “Theoretical and experimental study of a high temperature heat pump refrigerant.” J. Tianjin Univ., 49(3), 314–319.
Zhao, Y., et al. (2014a). “A comparative study of energy consumption and efficiency of Japanese and Chinese manufacturing industry.” Energy Policy, 70(7), 45–56.
Zhao, Y., Yang, Z., Luo, E., and Zhou, Y. (2014b). “Travelling-wave thermoacoustic high-temperature heat pump for industrial waste heat recovery.” Energy, 77(12), 397–402.
Zheng, Z. T., Xu, Y., Dong, J. H., Zhang, L. F., and Wang, L. P. (2016). “Design and experimental testing of a ground source heat pump system based on energy-saving solar collector.” J. Energy Eng., 04015022.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Oct 30, 2016
Accepted: Feb 6, 2017
Published online: May 31, 2017
Published in print: Oct 1, 2017
Discussion open until: Oct 31, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.