Secondary Catalytic Reaction of Circulating Ash on the Primary Volatiles of Coal Pyrolysis
Publication: Journal of Energy Engineering
Volume 143, Issue 5
Abstract
In view of the polygeneration technology of coal pyrolysis/circulating fluidized bed combustion, circulating ash and coal were layered in the pyrolysis reactor to investigate the secondary catalytic reaction of circulating ash on the primary volatiles of coal pyrolysis. The influence factors of the location types of ash and coal, the mass ratio of ash to coal, ash composition, and ash particle size were studied. Increasing the mass ratio of ash to coal increases the number of the catalytic active sites. Circulating ash rich in significantly promotes the increase of gas product yield and the decrease of liquid product yield. Circulating ash increases the yields of and but decreases the yield significantly. The yields of and for Zhaotong brown coal increase more than Shenmu bituminous coal. Combined with the thermogravimetric analyzer–mass spectrometer, the secondary catalytic effect of circulating ash on the primary volatiles of coal pyrolysis is evidenced mainly in the promotion of hydrocracking reaction of large molecular hydrocarbons. This study may provide reference for the optimization of the industrial scale of coal pyrolysis by solid heat carrier.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Natural Science Foundation of China (Grant No. 21376142).
References
Chi, J., Zhang, S., Yang, Y., Wang, B., and Xiao, Y. (2016). “Performance prediction of a transport gasifier-based IGCC system with capture under uncertainties.” J. Energy Eng.,.
Cramer, B. (2004). “Methane generation from coal during open system pyrolysis investigated by isotope specific, Gaussian distributed reaction kinetics.” Org. Geochem., 35(4), 379–392.
Das, T. K. (2001). “Evolution characteristics of gases during pyrolysis of maceral concentrates of Russian coking coals.” Fuel, 80(4), 489–500.
Ding, L., Zhou, Z., Guo, Q., Huo, W., and Yu, G. (2015). “Catalytic effects of additive on coal pyrolysis and gasification.” Fuel, 142, 134–144.
Ding, L., Zhou, Z., Guo, Q., Lin, S., and Yu, G. (2015). “Gas evolution characteristics during pyrolysis and catalytic pyrolysis of coals by TG-MS and in a high-frequency furnace.” Fuel, 154, 222–232.
Eriksson, M., and Golriz, M. R. (2005). “Radiation heat transfer in circulating fluidized bed combustors.” Int. J. Therm. Sci., 44(4), 399–409.
Fang, M., Wang, Q., Li, C., Luo, Z., and Cen, K. (2014). “Experimental research on CFB coal pyrolysis and combustion polygeneration technology.” J. Plasma Fusion Res., 71, 1212–1219.
Folgueras, M. B., and Díaz, R. M. (2010). “Influence of and lime added to ludge on sludge-coal pyrolysis.” Energy, 35(12), 5250–5259.
Kopyscinski, J., Lam, J., Mims, C. A., and Hill, J. M. (2014). “ catalyzed steam gasification of ash-free coal: Studying the effect of temperature on carbon conversion and gas production rate using a drop-down reactor.” Fuel, 128, 210–219.
Krzywanski, J., and Nowak, W. (2016). “Artificial intelligence treatment of SO2 emissions from CFBC in air and oxygen-enriched conditions.” J. Energy Eng., .
Li, C., Sathe, C., Kershaw, J. R., and Pang, Y. (2000). “Fates and roles of alkali and alkaline earth metals during the pyrolysis of a Victorian brown coal.” Fuel, 79(3-4), 427–438.
Liang, P., Jiang, W., Zhang, Y., Wang, X., and Zhu, J. (2016). “Effect of circulating ash on sulfur conversion characteristics in the coal polygeneration process.” Fuel Process. Technol., 150, 16–22.
Liang, P., Zhang, Y., Jiang, W., Wei, A., Liu, T., and Wu, J. (2015). “Simulation study of Shenmu coal pyrolysis by gas heat carrier based on a moving bed.” Energy Fuels, 29(11), 7727–7733.
Lievens, C., et al. (2013). “A study of slow pyrolysis of one low rank coal via pyrolysis-GC/MS.” Fuel Process. Technol., 116, 85–93.
Liu, Q., Hu, H., Zhou, Q., Zhu, S., and Chen, G. (2004). “Effect of inorganic matter on reactivity and kinetics of coal pyrolysis.” Fuel, 83(6), 713–718.
Porada, S. (2004). “The reactions of formation of selected gas products during coal pyrolysis.” Fuel, 83(9), 1191–1196.
Qu, X., Liang, P., Zhang, R., Gan, Z., and Bi, J. C. (2010). “Sulfur transformation in the process of circulating fluidized bed combustion combined with coal pyrolysis.” Energy Fuels, 24(9), 5023–5027.
Rakopoulos, C. D., Kakaras, E. C., Kyritsis, D. C., and Rakopoulos, D. C. (2016). “Advanced combustion and fuel technologies for economical and environmentally friendly power generation in engines and power plants: Issues and challenges.” J. Energy Eng., .
Shen, Y., Zhao, P., Shao, Q., Ma, D., Takahashi, F., and Yoshikawa, K. (2014). “In-situ catalytic conversion of tar using rice husk char-supported nickel-iron catalysts for biomass pyrolysis/gasification.” Appl. Catal. B-Environ., 152–153, 140–151.
Skodras, G., and Sakellaropoulos, G. (2002). “Mineral matter effects in lignite gasification.” Fuel Process. Technol., 77, 151–158.
Tang, J., and Wang, J. (2016). “Catalytic steam gasification of coal char with alkali carbonates: A study on their synergic effects with calcium hydroxide.” Fuel Process. Technol., 142, 34–41.
Wang, M., Li, Z., Huang, W., Yang, J., and Xue, H. (2015). “Coal pyrolysis characteristics by TG-MS and its late gas generation potential.” Fuel, 156, 243–253.
Wen, W., and Cain, E. (1984). “Catalytic pyrolysis of a coal tar in a fixed-bed reactor.” Ind. Eng. Chem. Process Des. Dev., 23(4), 627–637.
Wu, D., Liu, G., and Sun, R. (2014). “Investigation on structural and thermodynamic characteristics of perhydrous bituminous coal by fourier transform infrared spectroscopy and thermogravimetry/mass spectrometry.” Energy Fuels, 28(5), 3024–3035.
Xiao, R., Zhang, S., Peng, S., Shen, D., and Liu, K. (2014). “Use of heavy fraction of bio-oil as fuel for hydrogen production in iron-based chemical looping process.” Int. J. Hydrogen Energy, 39(35), 19955–19969.
Zhu, T., Zhang, S., Huang, J., and Wang, Y. (2000). “Effect of calcium oxide on pyrolysis of coal in a fluidized bed.” Fuel Process. Technol., 64(1–3), 271–284.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Oct 11, 2016
Accepted: Jan 17, 2017
Published online: Mar 25, 2017
Discussion open until: Aug 25, 2017
Published in print: Oct 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.