Investigation of Performance and Emission Characteristics on a Large-Bore Spark-Ignition Natural Gas Engine with Scavenged Prechamber and Miller Cycle Attribute
Publication: Journal of Energy Engineering
Volume 143, Issue 5
Abstract
Adoption of methane scavenged prechamber has been considered as a promising solution to extend the lean limit of large-bore natural gas engines. In this paper, the effects of prechamber energy fraction, Miller cycle, excess air ratio, intake temperature, fuel methane number, and engine load are examined by a full set of experiments and detailed analysis on a single-cylinder large-bore natural gas engine. The results indicate that brake thermal efficiency (BTE) could be improved by increasing prechamber energy fraction, reducing excess air ratio, and using fuel with a higher methane number. It is also observed that brake thermal efficiency is higher at higher engine loads. Moreover, knock intensity is shown to be higher at higher prechamber energy fractions, higher intake temperatures, and lower methane numbers. For a methane scavenged prechamber engine, the cyclic variation of indicated mean effective pressure is maintained at a low level, attributed to the strong ignition energy. However, reducing air excess ratio and utilizing valve timing with a higher Miller degree are capable of reducing cyclic variation to a lower level. Additionally, carbon monoxide (CO) emissions are lower at higher prechamber energy fractions, higher excess air ratios, and lower Miller degree, which first increases and then decreases with the increase of methane number. Hydrocarbon emissions could be controlled by increasing intake temperature, reducing prechamber energy fraction and excess air ratio, and using a higher Miller degree. Meanwhile, lower NOx emissions can be obtained by raising prechamber energy fraction and excess air ratio. It is also deduced that implementation of higher Miller degree has positive effect on NOx reduction.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge financial support from the National Natural Science Foundation of China (51576116).
References
Attard, W. P., and Parsons, P. (2010). “Flame kernel development for a spark initiated pre-chamber combustion system capable of high load, high efficiency and near zero NOx emissions.” SAE Int. J. Engines, 3(2), 408–427.
Baumgartner, L. S., Wohlgemuth, S., Zirngibl, S., and Wachtmeister, G. (2015). “Investigation of a methane scavenged prechamber for increased efficiency of a lean-burn natural gas engine for automotive applications.” SAE Int. J. Engines, 8(2), 921–933.
Betz, G., and Zellbeck, H. (1983). “Das Mahle Ki -Meter zur quantitativen Bestimmung der Klopfintensität.” Motortechnische Zeitschrift MTZ, 44(6), 231–234 (in German).
Charlton, S. J., Jager, D. J., Wilson, M., and Shooshtarian, A. (1990). “Computer modelling and experimental investigation of a lean burn natural gas engine.”, Society of Automotive Engineers International, Warrendale, PA.
Chiera, D., Ahrens, D., Polley, N., Petruska, D., Riley, M., and Hampson, G. J. (2011). “Lean limit extension for high BMEP gas engines via novel electronic ignition and prechamber plug: Higher efficiency and lower NOx in open chamber engines.” Proc., ASME 2011 Internal Combustion Engine Division Fall Technical Conf., American Society of Mechanical Engineers, New York, 31–45.
Debnath, B., Bora, B., Sahoo, N., and Saha, U. (2014). “Influence of emulsified palm biodiesel as pilot fuel in a biogas run duel fuel diesel engine.” J. Energy Eng., 140(3), .
Draper, C. S. (1938). “Pressure waves accompanying detonation in the internal combustion engine.” J. Aeronaut. Sci., 5(6), 219–226.
Gingrich, J. W., Olsen, D. B., Puzinauskas, P., and Willson, B. D. (2006). “Precombustion chamber NOx emission contribution to an industrial natural gas engine.” Int. J. Engine Res., 7(1), 41–49.
Hickling, R., Feldmaier, D. A., Chen, F. H., and Morel, J. S. (1983). “Cavity resonances in engine combustion chambers and some applications.” J. Acoust. Soc. Am., 73(4), 1170–1178.
Jamrozik, A. (2015). “Lean combustion by a pre-chamber charge stratification in a stationary spark ignited engine.” J. Mech. Sci. Technol., 29(5), 2269–2278.
Kammerstätter, S., and Sattelmayer, T. (2012). “Influence of prechamber-geometry and operating-parameters on cycle-to-cycle variations in lean large-bore natural gas engines.” Proc., ASME 2012 Internal Combustion Engine Division Spring Technical Conf., American Society of Mechanical Engineers, New York, 111–120.
Kirkpatrick, A., Kim, G. H., and Olsen, D. (2005). “CFD modeling of the performance of a prechamber for use in a large bore natural gas engine.” Proc., ASME 2005 Internal Combustion Engine Division Spring Technical Conf., American Society of Mechanical Engineers, New York, 397–403.
Korakianitis, T., Namasivayam, A. M., and Crookes, R. J. (2011). “Natural-gas fueled spark-ignition (SI) and compression-ignition (CI) engine performance and emissions.” Prog. Energy Combust. Sci., 37(1), 89–112.
Kubesh, J., King, S. R., and Liss, W. E. (1992). “Effect of gas composition on octane number of natural gas fuels.”, Society of Automotive Engineers International, Warrendale, PA.
Murase, E., Ono, S., Hanada, K., and Oppenheim, A. K. (1994). “Pulsed combustion jet ignition in lean mixtures.”, Society of Automotive Engineers International, Warrendale, PA.
Olsen, D. B., Adair, J. L., and Willson, B. D. (2005). “Precombustion chamber design and performance studies for a large bore natural gas engine.” Proc., ASME 2005 Internal Combustion Engine Division Spring Technical Conf., American Society of Mechanical Engineers, New York, 415–428.
Olsen, D. B., and Kirkpatrick, A. T. (2008). “Experimental examination of prechamber heat release in a large bore natural gas engine.” J. Eng. Gas Turb. Power, 130(5), 052802–052809.
Peterson, M. B., Barter, G. E., West, T. H., and Manley, D. K. (2014). “A parametric study of light-duty natural gas vehicle competitiveness in the United States through 2050.” Appl. Energy, 125(7), 206–217.
Poompipatpong, C., and Cheenkachorn, K. (2011). “A modified diesel engine for natural gas operation: Performance and emission tests.” Energy, 36(12), 6862–6866.
Raihan, M. S., Guerry, E. S., Dwivedi, U., Srinivasan, K. K., and Krishnan, S. R. (2014). “Experimental analysis of diesel-ignited methane dual-fuel low-temperature combustion in a single-cylinder diesel engine.” J. Energy Eng., 141(2), .
Rakopoulos, C. D., Rakopoulos, D. C., Giakoumis, E. G., and Dimaratos, A. M. (2010). “Investigation of the combustion of neat cottonseed oil or its neat bio-diesel in a HSDI diesel engine by experimental heat release and statistical analyses.” Fuel, 89(12), 3814–3826.
Rakopoulos, D. C., Rakopoulos, C. D., and Giakoumis, E. G. (2015). “Impact of properties of vegetable oil, bio-diesel, ethanol and n-butanol on the combustion and emissions of turbocharged HDDI diesel engine operating under steady and transient conditions.” Fuel, 156(9), 1–19.
Rakopoulos, D. C., Rakopoulos, C. D., Giakoumis, E. G., and Dimaratos, A. M. (2013). “Studying combustion and cyclic irregularity of diethyl ether as supplement fuel in diesel engine.” Fuel, 109(7), 325–335.
Rakopoulos, D. C., Rakopoulos, C. D., Giakoumis, E. G., Komninos, N. P., Kosmadakis, G. M., and Papagiannakis, R. G. (2016a). “Comparative evaluation of ethanol, n-butanol, and diethyl ether effects as biofuel supplements on combustion characteristics, cyclic variations, and emissions balance in light-duty diesel engine.” J. Energy Eng., .
Rakopoulos, D. C., Rakopoulos, C. D., and Kyritsis, D. C. (2016b). “Butanol or DEE blends with either straight vegetable oil or biodiesel excluding fossil fuel: Comparative effects on diesel engine combustion attributes, cyclic variability and regulated emissions trade-off.” Energy, 115(11), 314–325.
Roethlisberger, R. P., and Favrat, D. (2003). “Investigation of the prechamber geometrical configuration of a natural gas spark ignition engine for cogeneration. Part I: Numerical simulation.” Int. J. Therm. Sci., 42(3), 223–237.
Ruter, M. D., Olsen, D. B., Scotto, M. V., and Perna, M. A. (2012). “NOx reduction from a large bore natural gas engine via reformed natural gas prechamber fueling optimization.” Fuel, 91(1), 298–306.
Scholl, D., Davis, C., Russ, S., and Barash, T. (1998). “The volume acoustic modes of spark-ignited internal combustion chambers.”, Society of Automotive Engineers International, Warrendale, PA.
Shah, A., Tunestal, P., and Johansson, B. (2012). “Investigation of performance and emission characteristics of a heavy duty natural gas engine operated with pre-chamber spark plug and dilution with excess air and EGR.” SAE Int. J. Engines, 5(4), 1790–1801.
Shah, A., Tunestal, P., and Johansson, B. (2014). “Effect of relative mixture strength on performance of divided chamber ‘avalanche activated combustion’ ignition technique in a heavy duty natural gas engine.”, Society of Automotive Engineers International, Warrendale, PA.
Shah, A., Tunestal, P., and Johansson, B. (2015). “Effect of pre-chamber volume and nozzle diameter on pre-chamber ignition in heavy duty natural gas engines.”, Society of Automotive Engineers International, Warrendale, PA.
Wellander, R., et al. (2014). “Study of the early flame development in a spark-ignited lean burn four-stroke large bore gas engine by fuel tracer PLIF.” SAE Int. J. Engines, 7(2), 928–936.
Yang, B., Xi, C., Wei, X., Zeng, K., and Lai, M. C. (2015). “Parametric investigation of natural gas port injection and diesel pilot injection on the combustion and emissions of a turbocharged common rail dual-fuel engine at low load.” Appl. Energy, 143(4), 130–137.
Information & Authors
Information
Published In
Journal of Energy Engineering
Volume 143 • Issue 5 • October 2017
Copyright
©2017 American Society of Civil Engineers.
History
Received: Nov 22, 2016
Accepted: Jan 12, 2017
Published online: Apr 19, 2017
Discussion open until: Sep 19, 2017
Published in print: Oct 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.