Emission Reduction Operating Parameters for a Dual-Fuel Diesel Engine Run on Biogas and Rice-Bran Biodiesel
Publication: Journal of Energy Engineering
Volume 143, Issue 4
Abstract
Biogas has great potential as a clean alternative fuel for dual-fuel diesel engines. The present work is aimed at investigating the operating parameters such as compression ratio (CR) and injection timing (IT) for a dual-fuel diesel engine run on biogas and rice-bran biodiesel. The motivation behind this investigation is to obtain a diesel equivalent performance together with a reduction in emission. To achieve this, a single-cylinder, direct-injection, variable-compression-ratio diesel engine is modified into a dual-fuel diesel engine by incorporating a venturi gas mixer at the inlet manifold. A set of combinations composed of CRs of 17, 17.5, and 18 and ITs of 23°, 26°, 29°, and 32° before top dead center (BTDC) at different loading conditions are considered. The combination of BTDC and is found to produce a maximum brake thermal efficiency of 25.88% and a liquid fuel replacement of 82.75% at 100% load. On average, there is a reduction of carbon monoxide as well as hydrocarbon emissions by 11.64 and 14.21%, respectively. On the other hand, for the same setting, there is an increase of oxides of nitrogen emissions by 39%.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work reported here forms a part of the Defence Research Laboratory, DRDO, Tezpur, Assam, India, sponsored research project “Utilization of Biowaste for Generating Power in Diesel Engines.” The financial support extended is gratefully acknowledged.
References
Agarwal, A. K., Srivastava, D. S., Dhar, A., Maurya, R. K., Shukla, P. C., and Singh, A. P. (2013). “Effect of fuel injection timing and pressure on combustion, emissions and performance characteristics of a single cylinder diesel engine.” Fuel, 111, 374–383.
Banapurmath, N. R., Tewari, P. G., Yaliwal, V. S., Kambalimath, S., and Basavarajappa, Y. H. (2009). “Combustion characteristics of a 4-stroke CI engine operated on Honge oil, Neem and rice bran oils when directly injected and dual fuelled with producer gas induction.” Renewable Energy, 34(7), 1877–1884.
Bari, S. (1996). “Effect of carbon dioxide on the performance of biogas/diesel duel-fuel engine.” Renewable Energy, 9(1–4), 1007–1010.
Bedoya, I. D., Arrieta, A. A., and Cadavid, F. J. (2009). “Effects of mixing system and pilot fuel quality on diesel—Biogas dual fuel engine performance.” Bioresour. Technol., 100(24), 6624–6629.
Bora, B. J., Debnath, B. K., Gupta, N., Saha, U. K., and Sahoo, N. (2013). “Investigation on the flow behaviour of a venturi type gas mixer designed for dual fuel diesel engines.” Int. J. Emerging Technol. Adv. Eng., 3(3), 202–209.
Bora, B. J., and Saha, U. K. (2015). “Theoretical performance limits of a biogas–diesel powered dual fuel diesel engine for different combinations of compression ratio and injection timing.” J. Energy Eng., .
Bora, B. J., Saha, U. K., Chatterjee, S., and Veer, V. (2014). “Effect of compression ratio on performance, combustion and emission characteristics of a dual fuel diesel engine run on raw biogas.” Energy Convers. Manage., 87, 1000–1009.
Boulifi, N. E., Bouaid, A., Martinez, M., and Aracil, J. (2013). “Optimization and oxidative stability of biodiesel production from rice bran oil.” Renewable Energy, 53, 141–147.
Carlucci, A. P., Colangelo, G., Ficarella, A., Laforgia, D., and Strafella, L. (2014). “Improvements in dual-fuel biodiesel-producer gas combustion at low loads through pilot injection splitting.” J. Energy Eng., .
Debnath, B. K., Bora, B. J., Gupta, N., Saha, U. K., and Sahoo, N. (2014). “Influence of emulsified palm biodiesel as pilot fuel in a biogas run dual fuel diesel engine.” J. Energy Eng., .
Dhole, A. E., Yarasu, R. B., Lata, D. B., and Priyam, A. (2014). “Effect on performance and emissions of a dual fuel diesel engine using hydrogen and producer gas as secondary fuels.” Int. J. Hydrogen Energy, 39(15), 8087–8097.
Elnajjar, E., Mohammad, O., and Mohamed, S. (2013). “Experimental investigation of dual engine performance using variable LPG composition fuel.” Renewable Energy, 56, 110–116.
Evangelista, J. P. C., Chellappa, T., Coriolano, A. C. F., Fernandes, V. J., Souza, L. D., and Araujo, A. S. (2012). “Synthesis of alumina impregnated with potassium iodide catalyst for biodiesel production from rice bran oil.” Fuel Process. Technol., 104, 90–95.
Fraioli, V., Mancaruso, E., Migliaccio, M., and Vaglieco, B. M. (2014). “Ethanol effect as premixed fuel in dual-fuel CI engines: Experimental and numerical investigations.” Appl. Energy, 119, 394–404.
Giakoumis, E. G. (2013). “A statistical investigation of biodiesel physical and chemical properties and their correlation with the degree of unsaturation.” Renewable Energy, 50, 858–878.
Gunawan, S., Maulana, S., Anwar, K., and Widjaja, T. (2011). “Rice bran, a potential source of biodiesel production in Indonesia.” Ind. Crops Prod., 33(3), 624–628.
Hasan, A. P., AbdulWakila, M., and Kafy, M. A. (2014). “Prospect of rice bran for biodiesel production in Bangladesh.” Proc. Eng., 90, 746–752.
Heywood, J. B. (1988). Internal combustion engine fundamentals, McGraw-Hill, New York, 509–511.
Jindal, S., Nandwanaa, B. P., Rathore, N. S., and Vashistha, V. (2010). “Experimental investigation of the effect of compression ratio and injection pressure in a direct injection diesel engine running on Jatropha methyl ester.” Appl. Thermal Eng., 30(5), 442–448.
Kasim, N. S., Tsai, T., Gunawan, S., and Ju, Y. (2009). “Biodiesel production from rice bran oil and supercritical methanol.” Bioresour. Technol., 100(8), 2399–2403.
Lei, H., et al. (2010). “In situ production of fatty acid methyl ester from low quality rice bran: An economical route for biodiesel production.” Fuel, 89(7), 1475–1479.
Lin, L., Ying, D., Chaitep, S., and Vittayapadung, S. (2009). “Biodiesel production from crude rice bran oil and properties as fuel.” Appl. Energy, 86(5), 681–688.
Luijten, C. C. M., and Kerkhof, E. (2011). “Jatropha oil and biogas in a dual fuel CI engine for rural electrification.” Energy Convers. Manage., 52(2), 1426–1438.
Moffat, R. J. (1982). “Contributions to the theory of single-sample uncertainty analysis.” ASME J. Fluids Eng., 104(2), 250–264.
MohamedMusthafa, M., Sivapirakasam, S. P., and Udayakumar, M. (2011). “Comparative studies on fly ash coated low heat rejection diesel engine on performance and emission characteristics fueled by rice bran and pongamia methyl ester and their blend with diesel.” Energy, 36(5), 2343–2351.
Namasivayam, A. M., Korakianitis, T., Crookes, R. J., Bob-Manuel, K. D. H., and Olsen, J. (2010). “Biodiesel, emulsified biodiesel and dimethyl ether as pilot fuels for natural gas fuelled engines.” Appl. Energy, 87(3), 769–778.
Pandey, A. (2009). Biodiesel from rice bran oil handbook of plant-based bio-657 fuels, CRC Press, Boca Raton, FL.
Qi, D. H., Chen, B., and Zhang, D. (2016). “Combustion and exhaust emissions characteristics of a dual-fuel compression ignition engine operated with diesel fuel and liquefied petroleum gas.” J. Energy Eng., .
Rakopoulos, D. C (2012). “Heat release analysis of combustion in heavy-duty turbocharged diesel engine operating on blends of diesel fuel with cottonseed or sunflower oil sand their bio-diesel.” Fuel, 96, 524–534.
Rakopoulos, D. C., Rakopoulos, C. D., and Giakoumis, E. G. (2015). “Impact of properties of vegetable oil, bio-diesel, ethanol and n-butanol on the combustion and emissions of turbocharged HDDI diesel engine operating under steady and transient conditions.” Fuel, 156, 1–19.
Rakopoulos, D. C., Rakopoulos, C. D., Giakoumis, E. G., and Dimaratos, A. M. (2013). “Studying combustion and cyclic irregularity of diethyl ether as supplement fuel in diesel engine.” Fuel, 109, 325–335.
Ryu, K. (2013). “Effects of pilot injection timing on the combustion and emissions characteristics in a diesel engine using biodiesel-CNG dual fuel.” Appl. Energy, 111, 721–730.
Sahoo, B. B. (2011). “Clean development mechanism potential of compression ignition diesel engines using gaseous fuels in dual fuel mode.” Ph.D. thesis, Centre for Energy, IIT Guwahati, Guwahati, India.
Sahoo, B. B., Sahoo, N., and Saha, U. K. (2012). “Effect of : CO ratio in syngas on the performance of a dual fuel diesel engine operation.” Appl. Therm. Eng., 49, 139–146.
Saravanan, S., and Nagarajan, G. (2014). “Comparison of influencing factors of diesel with crude rice bran oil methyl ester in multi response optimization of emission.” Ain Shams Eng. J., 5(4), 1241–1248.
Saravanan, S., Nagarajan, G., and Rao, G. L. N. (2009). “Feasibility analysis of crude rice bran oil methyl ester blend as a stationary and automotive diesel engine fuel.” Energy Sustainab. Dev., 13(1), 52–55.
Saravanan, S., Nagarajan, G., Rao, G. L. N., and Sampath, S. (2010). “Combustion characteristics of a stationary diesel engine fuelled with a blend of crude rice bran oil methyl ester and diesel.” Energy, 35(1), 94–100.
Saravanan, S., Nagarajan, G., and Sampath, S. (2013). “Combined effect of injection timing, EGR and injection pressure in NOx Control of a stationary diesel engine fuelled with crude rice bran oil methyl ester.” Fuel, 104, 409–416.
Sayin, K., and Gumus, M. (2011). “Impact of compression ratio and injection parameters on the performance and emissions of a DI diesel engine fueled with biodiesel-blended diesel fuel.” Appl. Thermal Eng., 31(16), 3182–3188.
Sayin, K., Uslu, M., and Canakci, M. (2008). “Influence of injection timing on the exhaust emissions of a dual-fuel CI engine.” Renewable Energy, 33(6), 1314–1323.
Singh, R. N., Singh, S. P., and Pathak, B. S. (2007). “Investigation on operation of CI engine using producer gas and rice bran oil in mixed fuel mode.” Renewable Energy, 32(9), 1565–1580.
Sinha, S., Agarwal, A. K., and Garg, S. (2008). “Biodiesel development from rice bran oil: Transesterification process optimization and fuel characterization.” Energy Convers. Manage., 49(5), 1248–1257.
Stone, R. (1985). Introduction to internal combustion engines, 2nd Ed., Macmillan Press Limited, London, 504–509.
Tira, H. S., et al. (2014). “Influence of fuel properties, hydrogen, and reformate additions on diesel-biogas dual-fueled engine.” J. Energy Eng., A4014003-1–A4014003-13.
Wang, Y., Xiao, F., Zhao, Y., Li, D., and Lei, X. (2015). “Study on cycle-by-cycle variations in a diesel engine with dimethyl ether as port premixing fuel.” Appl. Energy, 143, 58–70.
Yoon, S. H., and Lee, C. S. (2011). “Experimental investigation on the combustion and exhaust emission characteristics of biogas—Biodiesel dual-fuel combustion in a CI Engine.” Fuel Process. Technol., 92(5), 992–1000.
Yusaf, T. F., Buttsworth, D. R., Saleh, K. H., and Yousif, B. F. (2010). “CNG-diesel engine performance and exhaust emission analysis with the aid of artificial neural network.” Appl. Energy, 87(5), 1661–1669.
Zhou, J. H., Cheung, C. S., and Leung, C. W. (2014). “Combustion, performance, regulated and unregulated emissions of a diesel engine with hydrogen addition.” Appl. Energy, 126, 1–12.
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Apr 22, 2016
Accepted: Jul 22, 2016
Published online: Nov 4, 2016
Discussion open until: Apr 4, 2017
Published in print: Aug 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.