Numerical Investigation of NOx Emissions for a Flexible Greek Lignite–Fired Power Plant
Publication: Journal of Energy Engineering
Volume 142, Issue 2
Abstract
This work simulates the Megalopolis IV power plant boiler operation in terms of NOx emissions for a wide range of thermal loads, and with different operational patterns of the firing system, i.e., different numbers and variation of the open burners’ positions. This work provides feedback on thermal loads that are lower than the current technical minimum () using numerical tools (CFD software packages) for both 40 and 35% partial-loads. For the lowest investigated load, it also examines contemporary combusting systems, with the simultaneous firing of raw and stored dry lignite to achieve flame stability. The results of the current study primarily focus on the effect of lower than 100% boiler operation on the NOx emissions because the majority of works in literature investigates boiler NOx emissions only under full-load conditions. Furthermore, it focuses on the variation of the NOx emissions among different partial-load conditions and the influence of the firing system operational patterns on these. To reduce the required computational resources, the decoupled approach is adopted, which distinguishes the main combustion mechanisms from the NOx emission mechanisms themselves. The results indicate that the NOx emissions concentration reduced at 6% dry oxygen molar concentration at the main furnace outlet surface increases as the thermal load gets lower. The results also prove the direct relation between temperature values and NOx emissions because the highest NOx concentrations are tracked in the hot spot areas; primarily attributed to thermal NOx production mechanisms. Additionally, the firing system operational pattern for each specific thermal load affects the NOx emissions concentration, as the results regarding the 35% partial-load case imply. In particular, for the 35% partial-load case, the even distribution and injection of stored dry lignite from all six vapor burners result in lower NOx concentrations compared to the case for which the injection of the stored dry lignite happens through the inlets of the two open vapor burners. In conclusion, the results of this work can provide valuable information about the boiler performance in terms of its NOx emissions behavior under partial-load conditions, and provide potential measures that can be implemented for NOx emissions reduction, especially under low-thermal conditions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the financial support of the General Secretariat for Research and Technology / Ministry of Education and Religious Affairs through the “Bilateral Research & Technology Cooperation Greece-Germany 2013-2015” Program/Grant Nr. ΓΓET GER_2597 (COALEEP Project—http://www.coaleep.com/). Additionally, the help of Mr. Papapavlou from PPC S.A. for the provision of important technical details is acknowledged.
References
Barnes, F. J., Bromly, J. H., Edwards, T. J., and Madngezewsky, R. (1988). “NOx emissions from radiant gas burners.” J. Inst. Energy, 155, 184–188.
Baum, M. M., and Street, P. J. (1971). “Predicting the combustion behaviour of coal particles.” Combust. Sci. Technol., 3(5), 231–243.
Benim, A. C., and Syed, K. J. (1998). “Laminar flamelet modelling of turbulent premixed combustion.” Appl. Math. Modell., 22(1–2), 113–136.
Bosoaga, A., et al. (2006). “The combustion of pulverised low grade lignite.” Fuel, 85(10–11), 1591–1598.
Burnard, K., Jiang, J., Li, B., Brunet, G., and Bauer, F. (2014). “Emissions reduction through upgrade of coal-fired power plants.” International Energy Agency, France.
Cheng, P. (1964). “Two-dimensional radiating gas flow by a moment method.” AIAA J., 2(9), 1662–1664.
Cheremisinoff, N. P., and Davletshin, A. R. (2015). Hydraulic fracturing operations: Handbook of environmental management practices, Wiley, NJ.
Choi, C. R., and Kim, C. N. (2009). “Numerical investigation on the flow, combustion and NOx emission characteristics in a tangentially fired pulverized-coal boiler.” Fuel, 88(9), 1720–1731.
De Soete, G. G. (1975). “Overall reaction rates of NO and formation from fuel nitrogen.” Symp. Int. Combust., 15(1), 1093–1102.
Díez, L. I., Cortés, C., and Pallarés, J. (2008). “Numerical investigation of NOx emissions from a tangentially-fired utility boiler under conventional and overfire air operation.” Fuel, 87(7), 1259–1269.
Engleman, V. S., Bartok, W., Longwell, J. P., and Edelman, R. B. (1973). “Experimental and theoretical studies of NOx formation in a jet-stirred combustor.” Symp. Int. Combust., 14(1), 755–765.
Filkoski, R. V., Petrovski, I. J., and Karas, P. (2006). “Optimization of pulverised coal combustion by means of CFD/CTA modeling.” Therm. Sci., 10(3), 161–179.
FLUENT version 15.0 [Computer software]. ANSYS, Canonsburg, PA.
Glarborg, P., Jensen, A. D., and Johnsson, J. E. (2003). “Fuel nitrogen conversion in solid fuel fired systems.” Prog. Energy Combust. Sci., 29(2), 89–113.
Graus, W., Roglieri, M., Jaworski, P., and Alberio, L. (2008). “Efficiency and capture-readiness of new fossil power plants in the EU.” MVV Consulting, Ultrecht, Netherlands.
Guide, A. F. (2006). “20.1.3 thermal NOx formation.” 〈https://www.sharcnet.ca/Software/Fluent6/html/ug/node763.htm〉 (May 4, 2015).
Hammond, G. P., and Spargo, J. (2014). “The prospects for coal-fired power plants with carbon capture and storage: A UK perspective.” Energy Convers. Manage., 86, 476–489.
Hanson, R., and Salimian, S. (1984). “Survey of rate constants in the N/H/O system.” Combustion chemistry, W. Gardiner, Jr., ed., Springer, New York, 361–421.
Hayhurst, A. N., and Lawrence, A. D. (1996). “The amounts of NOx and N2O formed in a fluidized bed combustor during the burning of coal volatiles and also of char.” Combust. Flame, 105, 341–357.
Hill, S. C., and Douglas Smoot, L. (2000). “Modeling of nitrogen oxides formation and destruction in combustion systems.” Prog. Energy Combust. Sci., 26(4–6), 417–458.
Karampinis, E., Nikolopoulos, N., Nikolopoulos, A., Grammelis, P., and Kakaras, E. (2012). “Numerical investigation Greek lignite/cardoon co-firing in a tangentially fired furnace.” Appl. Energy, 97, 514–524.
Kastanaki, E., and Vamvuka, D. (2006). “A comparative reactivity and kinetic study on the combustion of coal–biomass char blends.” Fuel, 85(9), 1186–1193.
Kuang, M., Li, Z., Zhu, Q., and Zhang, H. (2013). “Characterization of gas/particle flows with respect to staged-air ratio for a down-fired supercritical utility boiler with multiple injection and multiple staging: A lab-scale study.” Int. J. Therm. Sci., 70, 154–165.
Kumar, N., Besuner, P., Lefton, S., Agan, D., and Hilleman, D. (2012). “Power plant cycling costs.” National Renewable Energy Labatory, Sunnyvale, CA.
Levy, J. M., Chan, L. K., Sarofim, A. F., and Beér, J. M. (1981). “NO/char reactions at pulverized coal flame conditions.” Symp. Int. Combust., 18(1), 111–120.
Li, K., Thompson, S., and Peng, J. (2004). “Modelling and prediction of NOx emission in a coal-fired power generation plant.” Control Eng. Pract., 12(6), 707–723.
Liu, C., Hui, S., Zhang, X., Wang, D., Zhuang, H., and Wang, X. (2015a). “Influence of type of burner on NO emissions for pulverized coal preheating method.” Appl. Therm. Eng., 85, 278–286.
Liu, G., Chen, Z., Li, Z., Li, G., and Zong, Q. (2015b). “Numerical simulations of flow, combustion characteristics, and NOx emission for down-fired boiler with different arch-supplied over-fire air ratios.” Appl. Therm. Eng., 75, 1034–1045.
Lucquiaud, M., Fernandez, E. S., Chalmers, H., Dowell, N. M., and Gibbins, J. (2014). “Enhanced operating flexibility and optimised off-design operation of coal plants with post-combustion capture.” Energy Procedia, 63, 7494–7507.
MHPSE (Mitsubishi Hitachi Power Systems Europe). (2014). “Spatial arrangement of evaporators and super-heaters in Megalopolis IV.” Duisburg, Germany.
MHPSE (Mitsubishi Hitachi Power Systems Europe). (2015). “Current and modified milling and feeding system.” Duisburg, Germany.
Myllyvirta, L., Schaible, C., and Holland, M. (2015). “Health and economic implications of alternative emission limits for coal-fired power plants in the EU.” Greenpeace, Hamburg, Germany.
Nikolopoulos, A., Malgarinos, I., Nikolopoulos, N., Grammelis, P., Karellas, S., and Kakaras, E. (2014). “Corrigendum to “A decoupled approach for NOx-N2O 3-D CFD modeling in CFB plants” [Fuel 115 (2014) 401–415].” Fuel, 119, 335.
Nikolopoulos, N., et al. (2013). “Parametric investigation of a renewable alternative for utilities adopting the co-firing lignite/biomass concept.” Fuel, 113, 873–897.
Nikolopoulos, N., Nikolopoulos, A., Karampinis, E., Grammelis, P., and Kakaras, E. (2011). “Numerical investigation of the oxy-fuel combustion in large scale boilers adopting the ECO-scrub technology.” Fuel, 90(1), 198–214.
Siegel, R., and Howell, J. R. (1992). Thermal radiation heat transfer, CRC Press, Washington, DC.
Stanmore, B. R., and Visona, S. P. (2000). “Prediction of NO emissions from a number of coal-fired power station boilers.” Fuel Process. Technol., 64(1–3), 25–46.
Thomas, M. K. (1997). “The release of nitrogen oxides during char combustion.” Fuel, 76(6), 457–473.
Warnatz, J. (2001). “NOx formation in high temperature processes.” Univ. of Stuttgart, Germany.
Winter, F., Wartha, C., Löffler, G., and Hofbauer, H. (1996). “The NO and N2O formation mechanism during devolatilization and char combustion under fluidized-bed conditions.” Symp. Int. Combust., 26(2), 3325–3334.
Xu, M., Azevedo, J. L. T., and Carvalho, M. G. (2000). “Modelling of the combustion process and NOx emission in a utility boiler.” Fuel, 79(13), 1611–1619.
Zhang, J., Ito, T., Okada, T., Oono, E., and Suda, T. (2013). “Improvement of NOx formation model for pulverized coal combustion by increasing oxidation rate of HCN.” Fuel, 113, 697–706.
Zhang, X., Zhou, J., Sun, S., Sun, R., and Qin, M. (2015). “Numerical investigation of low NOx combustion strategies in tangentially-fired coal boilers.” Fuel, 142, 215–221.
Zhou, H., Mo, G., Yang, Y., Si, D., and Cen, K. (2014). “Numerical investigation of gas-solid two-phase flow in a tiny-oil ignition cyclone burner for a 300-MW down-fired pulverized coal-fired boiler.” J. Energy Eng., 04013010.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jun 16, 2015
Accepted: Sep 18, 2015
Published online: Dec 22, 2015
Discussion open until: May 22, 2016
Published in print: Jun 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.