Experimental and Theoretical Investigation of Flywheel-Based Energy Storage in Off-Grid Power Plants Using Renewables
Publication: Journal of Energy Engineering
Volume 142, Issue 1
Abstract
The objective of this work is to investigate, from both experimental and simulation points of view, the feasibility of a flywheel energy storage system (FESS) for buffering energy when implemented in off-grid (autonomous) electricity production. Toward this aim, a prototype FESS was built and measured to identify its optimal design and operational characteristics as they have been obtained theoretically. After simulating two different materials and shapes for the rotating mass, the hollow aluminum cylindrical design found to provide excellent energy storage results. By identifying the storage capacity of a prototype laboratory-scale FESS, it is also found that such a device can be promoted as a uninterruptible power supply system to cover peak loads during limited time periods. Finally, the scale of the project found to be a crucial parameter for its feasibility.
Get full access to this article
View all available purchase options and get full access to this article.
References
Akella, A. K., Sharma, M. P., and Saini, R. P. (2007). “Optimum utilization of renewable energy sources in a remote area.” Renewable Sustainable Energy Rev., 11(5), 894–908.
Arghandeh, R., Pipattanasomporn, M., and Rahman, S. (2012). “Flywheel energy storage systems for ride-through applications in a facility microgrid.” IEEE Trans. Smart Grid, 3, 1955–1962.
Bekele, G., and Tadesse, G. (2012). “Feasibility study of small hydro/PV/wind hybrid system for off-grid rural electrification in Ethiopia.” Appl. Energy, 97, 5–15.
Bleijs, J. A. M., Hardan, F., and Ruddell, A. J. (2000). “Flywheels energy storage system for wind power smoothing in weak and autonomous networks.” Proc., Wind Power for the 21st Century Conf., Kassel, Germany, 270–273.
Bolund, B., Bernhoff, H., and Leijon, M. (2007). “Flywheel energy and power storage systems.” Renewable Sustainable Energy Rev., 11(2), 235–258.
Boretti, A. (2010). “Comparison of fuel economies of high efficiency diesel and hydrogen engines powering a compact car with a flywheel-based kinetic energy recovery systems.” Int. J. Hydrogen Energy, 35(16), 8417–8424.
Brown, D. R., and Chvala, W. D. (2005). “Flywheel energy storage: An alternative to batteries for UPS systems.” Energy Eng., 102, 7–26.
Celik, A. N. (2002). “Optimization and techno-economic analysis of autonomous photovoltaic-wind hybrid energy systems in comparison to single photovoltaic and wind systems.” Energy Convers. Manage., 43(18), 2453–2468.
Clarke, R. E., Giddey, S., and Badwal, S. P. S. (2010). “Stand-alone PEM water electrolysis system for fail safe operation with a renewable energy source.” Int. J. Hydrogen Energy, 35(3), 928–935.
Farret, F. A., and Simoes, M. G. (2006). Integration of alter native sources of energy, Wiley, New York.
Ichihara, T., et al. (2005). “Fabrication and evaluation of superconducting magnetic bearing for 10 kW h-class flywheel energy storage system.” Physica C, 426–431, 752–758.
Kaldellis, J. K., Zafirakis, D., and Kavadias, K. (2009). “Techno-economic comparison of energy storage systems for island autonomous electrical networks.” Renewable Sustainable Energy Rev., 13(2), 378–392.
Ledjeff, K. (1990). “Comparison of storage options for photovoltaic systems.” Int. J. Hydrogen Energy, 15(9), 629–633.
Liu, H., and Jiang, J. (2007). “Flywheel energy storage—An upswing technology for energy sustainability.” Energy Build., 39(5), 599–604.
Niiyama, K., Yagai, T., Tsuda, M., and Hamajima, T. (2008). “Optimization of hybrid power system composed of SMES and flywheel MG for large pulsed load.” Physica C, 468(15–20), 2111–2114.
Olszewski, M. (1988). “Application of advanced flywheel technology for energy storage on space station.” J. Power Sources, 22(3–4), 313–320.
Peter, J. H., and Euan, J. B. (2008). “Energy-storage technologies and electricity generation.” Energy Policy, 36(12), 4352–4355.
Prodromidis, G. N., and Coutelieris, F. A. (2011). “A comparative feasibility study of stand-alone and grid connected RES-based systems in several Greek islands.” Renewable Energy, 36(7), 1957–1963.
Prodromidis, G. N., and Coutelieris, F. A. (2012). “Simulation of economical and technical feasibility of battery and flywheel hybrid energy storage systems in autonomous projects.” Renewable Energy, 39(1), 149–153.
REN21 Steering Committee. (2011). “Renewables 2011 global status report.” 〈www.REN21.net/〉.
Shabani, B., and Andrews, J. (2011). “An experimental investigation of a PEM fuel cell to supply both heat and power in a solar-hydrogen RAPS system.” Int. J. Hydrogen Energy, 36(9), 5442–5452.
Sreeraj, E. S., Chatterjee, K., and Bandyopadhyay, S. (2010). “Design of isolated renewable hybrid power systems.” Sol. Energy, 84(7), 1124–1136.
Suzuki, Y., Koyanagi, A., Kobayashi, M., and Shimada, R. (2005). “Novel applications of the flywheel energy storage system.” Energy, 30(11–12), 2128–2143.
Tripathy, S. C. (1992). “Simulation of flywheel energy storage system for city buses.” Energy Convers. Manage., 33(4), 243–250.
Tripathy, S. C. (1994). “Electric drive for flywheel energy storage.” Energy Convers. Manage., 35(2), 127–138.
Ulleberg, Ø., Nakken, T., and Eté, A. (2010). “The wind/hydrogen demonstration system at Utsira in Norway: Evaluation of system performance using operational data and updated hydrogen energy system modeling tools.” Int. J. Hydrogen Energy, 35(5), 1841–1852.
Wang, Y., Ronilaya, F., Chen, X., and Roskilly, A. P. (2013). “Modelling and simulation of a distributed power generation system with energy storage to meet dynamic household electricity demand.” Appl. Therm. Eng., 50(1), 523–535.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Apr 15, 2014
Accepted: Oct 20, 2014
Published online: Dec 1, 2014
Discussion open until: May 1, 2015
Published in print: Mar 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.