Impact of Pavement Roughness and Deflection on Fuel Consumption Using Energy Dissipation
Publication: Journal of Engineering Mechanics
Volume 145, Issue 10
Abstract
The transportation sector contributes up to 27% of the total greenhouse gas (GHG) emissions in the United States; on-road transportation is responsible for 84% of the entire sector, implying that vehicles are a major cause of global warming. To understand the fuel energy dissipated through a vehicle’s suspension and tires, researchers have recently examined stochastic pavement models combined with mechanics-based vehicle models. These approaches assume the pavement is nondeformable with a certain random roughness level. In this paper, a pavement–vehicle interaction model is developed that can accommodate both road roughness and the deflection of rigid pavement. A quarter-car model is considered to represent the vehicle, a filtered white noise model is used to characterize the road roughness, and a two-elastic layered foundation (Euler–Bernoulli beam for the top pavement and Winkler foundation for the subgrade) is employed to simulate the rigid pavement. Subsequently, an augmented state-space representation is formulated for the entire pavement–vehicle system. The Lyapunov equation governing the covariance of the response is solved to obtain the energy dissipation of the vehicle’s suspension and tires. Finally, examples are presented and compared with the nondeformable pavement model to understand the impact of rigid pavement deformation on vehicle fuel energy dissipation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was partially funded by a grant (19DRMS-B146826-02) from the Development of Customized Contents Provision Technology for Realistic Disaster Management Based on Spatial Information program funded by the Ministry of the Interior and Safety of the Korean government and the Illinois State Toll Highway Authority (ISTHA). The authors are representatives of the Illinois Center for Transportation (ICT). The contents of this report reflect the views of the authors, who are solely responsible for the facts and the accuracy of the data presented herein. The contents do not necessarily reflect the official view of the Tollway or ICT. This paper does not constitute a standard, specification, or regulation.
References
AASHTO. 1993. AASHTO guide for design of pavement structures. Washington, DC: AASHTO.
Akbarian, M., S. Moeini-Ardakani, F. J. Ulm, and M. Nazzal. 2012. “Mechanistic approach to pavement-vehicle interaction and its impact on life-cycle assessment.” Transp. Res. Rec. 2306 (1): 171–179.https://doi.org/10.3141/2306-20.
Bay, J. A., K. H. Stokoe, and J. D. Jackson. 1995. “Development and preliminary investigation of a rolling dynamic deflectometer.” Transp. Res. Rec. 1473 (1): 43–54.
Chatti, K., and I. Zaabar. 2012. Estimating the effects of pavement condition on vehicle operating costs. Washington, DC: Transportation Research Board.
Davis, S. C., S. E. Williams, and R. G. Boundy. 2018. Transportation energy data book: Edition 36.1. Oak Ridge, TN: Oak Ridge National Laboratory.
Dimitrovová, Z., and J. N. Varandas. 2009. “Critical velocity of a load moving on a beam with a sudden change of foundation stiffness: Applications to high-speed trains.” Comput. Struct. 87 (19): 1224–1232.https://doi.org/10.1016/j.compstruc.2008.12.005.
Ellner, N. S., and E. L. Wachspress. 1968. “New ADI model problem applications.” In Proc., 1986 ACM Fall Joint Computer Conf., 528–534. Los Alamitos, CA: IEEE Computer Society Press.
Gillespie, T. D., M. W. Sayers, and L. Segel. 1980. Calibration of response-type pavement roughness measuring systems. Washington, DC: Transportation Research Board.
Hammarling, S. J. 1982. “Numerical solution of the stable, non-negative definite Lyapunov equation.” IMA J. Numer. Anal. 2 (3): 303–323. https://doi.org/10.1093/imanum/2.3.303.
Hardy, M. S. A., and D. Cebon. 1993. “Response of continuous pavements to moving dynamic loads.” J. Eng. Mech. 119 (9): 1762–1780. https://doi.org/10.1061/(ASCE)0733-9399(1993)119:9(1762).
Hardy, M. S. A., and D. Cebon. 1994. “Importance of speed and frequency in flexible pavement response.” J. Eng. Mech. 120 (3): 463–482. https://doi.org/10.1061/(ASCE)0733-9399(1994)120:3(463).
Johannesson, P., and I. Rychlik. 2013. “Laplace processes for describing road profiles.” Procedia Eng. 66: 464–473. https://doi.org/10.1016/j.proeng.2013.12.099.
Kim, R. E., S. Kang, B. F. Spencer, I. L. Al-Qadi, and H. Ozer. 2016. “New stochastic approach of vehicle energy dissipation on nondeformable rough pavements.” J. Eng. Mech. 143 (4): 04016118. https://doi.org/10.1061/(ASCE)EM.1943-7889.0001192.
Kim, S. M., J. M. Roesset, and K. H. Stokoe II. 1999. “Numerical simulation of rolling dynamic deflectometer tests.” J. Transp. Eng. 125 (2): 85–92. https://doi.org/10.1061/(ASCE)0733-947X(1999)125:2(85).
Kropáč, O., and M. Peter. 2008. “Indicators of longitudinal unevenness of roads in the USA.” Int. J. Veh. Des. 46 (4): 393–415.https://doi.org/10.1504/IJVD.2008.020306.
Kropáč, O., and M. Peter. 2011. “Deterioration model of longitudinal road unevenness based on its power spectral density indices.” Road Mater. Pavement Des. 9 (3): 389–420. https://doi.org/10.1080/14680629.2008.9690125.
Kuo, C., and T. Tsai. 2014. “Significance of subgrade damping on structural evaluation of pavements.” Road Mater. Pavement Des. 15 (2): 455–464. https://doi.org/10.1080/14680629.2014.884016.
LaBarre, R. T., R. T. Forbes, and S. Andrew. 1969. The measurement and analysis of road surface roughness. Nuneaton, UK: Motor Industry Research Association.
Lee, H. P. 1994a. “Dynamic response of a beam with intermediate point constraints subject to a moving load.” J. Sound Vib. 171 (3): 361–368.https://doi.org/10.1006/jsvi.1994.1126.
Lee, H. R. 1994b. “Runway roughness effects on new aircraft types.” In Proc., ASCE 94 Journal of the Aero-Space Transport Division, 1–17. Reston, VA: ASCE.
Li, S. H., and J. Y. Ren. 2013. “The second-responses method for simulation of vehicle-pavement dynamical interaction.” In Proc., 2nd Int. Conf. on Civil Engineering and Building Materials (CEBM 2012). Boca Raton, FL: CRC Press.
Lighthill, J. 1958. Introduction to Fourier analysis and generalized functions. London: Cambridge University Press.
Liu, Y., L. Sun, K. Liang, and L. Xu. 2014. “A method of acquiring dynamic road roughness based on vehicle-road vertical coupling.” Open Autom. Control Syst. J. 6 (1): 616–620. https://doi.org/10.2174/1874444301406010616.
Louhghalam, A., A. Mehdi, and F. Ulm. 2015a. “Roughness-induced pavement-vehicle interactions: Key parameters and impact on vehicle fuel consumption.” In Proc., 94th Annual Meeting. Washington, DC: Transportation Research Board.
Louhghalam, A., M. Tootkaboni, and F.-J. Ulm. 2015b. “Roughness-induced vehicle energy dissipation: Statistical analysis and scaling.” J. Eng. Mech. 141 (11): 04015046. https://doi.org/10.1061/(ASCE)EM.1943-7889.0000944.
Lutes, L. D., and S. L. J. Hu. 1986. “Non-normal stochastic response of linear systems.” J. Eng. Mech. 112 (2): 127–141. https://doi.org/10.1061/(ASCE)0733-9399(1986)112:2(127).
Mammetti, M., D. Gallegos, A. Freixas, and J. Muñoz. 2013. The influence of rolling resistance on fuel consumption in heavy-duty vehicles. Warrendale, PA: SAE International.
PCA (Portland Cement Association). 1984. Thickness design for concrete highway and street pavements. Skokie, IL: Portland Cement Association.
Robson, J. D. 1979. “Road surface description and vehicle response.” Int. J. Veh. Des. 1 (1): 25–35. https://doi.org/10.1080/00423117708968527.
Sandberg, U. 2011. Rolling resistance basic information and state-of-the-art on measurement methods. Linköping, Sweden: Swedish National Road and Transport Research Institute.
Sayers, M. W., and S. M. Karamihas. 1998. The little book of profiling. New York: Univ. of Michigan.
Soong, T. T., and M. Grigoriu. 1993. Random vibration of mechanical and structural systems. Englewood Cliffs, NJ: Prentice-Hall.
Sun, L., and X. Deng. 1998. “Predicting vertical dynamic loads caused by vehicle-pavement interaction.” J. Transp. Eng. 124 (5): 470–478. https://doi.org/10.1061/(ASCE)0733-947X(1998)124:5(470).
Sun, L., and T. W. Kennedy. 2002. “Spectral analysis and parametric study of stochastic pavement loads.” J. Eng. Mech. 128 (3): 318–327. https://doi.org/10.1061/(ASCE)0733-9399(2002)128:3(318).
Sun, L., and F. Luo. 2008. “Steady-state dynamic response of a Bernoulli-Euler beam on a viscoelastic foundation subject to a platoon of moving dynamic loads.” J. Vib. Acoust. 130 (5): 051002.https://doi.org/10.1115/1.2948376.
USEIA (US Energy Information Administration). 2017. “Power sector carbon dioxide emissions fall below transportation sector emissions.” Accessed December 19, 2017. https://www.eia.gov/todayinenergy/detail.php?id=29612.
USEIA (US Energy Information Administration). 2018. “Monthly energy review (report no. DOE/EIA-0035).” Accessed April 26, 2018. https://www.eia.gov/totalenergy/data/monthly/pdf/mer.pdf.
Wachspress, E. L. 1988. “Iterative solution of the Lyapunov matrix equation.” Appl. Math. Lett. 1 (1): 87–90. https://doi.org/10.1016/0893-9659(88)90183-8.
Xu, L. 2015. “Typical values of Young’s elastic modulus and Poisson’s ratio for pavement materials.” Accessed May 6, 2018. https://www.academia.edu/15702729/Typical_Values_of_Youngs_Elastic_Modulus_and_Poissons_Ratio_for_Pavement_Materials.PDF.
Ziyadi, M., H. Ozer, S. Kang, and I. L. Al-Qadi. 2018. “Vehicle energy consumption and an environmental impact calculation model for the transportation infrastructure systems.” J. Cleaner Prod. 174 (Feb): 424–436. https://doi.org/10.1016/j.jclepro.2017.10.292.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Sep 25, 2018
Accepted: Feb 11, 2019
Published online: Aug 5, 2019
Published in print: Oct 1, 2019
Discussion open until: Jan 5, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.