Mixed-Mode I–II Cracking Characterization of Mortar Using Phase-Field Method
Publication: Journal of Engineering Mechanics
Volume 143, Issue 7
Abstract
There have been many studies on mortar single-mode cracking behavior under tensile loading, however, the mixed-mode cracking is still not fully understood. In this paper, the mortar Mixed-Mode I–II cracking behavior is investigated by decomposing the total fracture energy into Mode I component and Mode II component. The total fracture energy is then put into the modified nonconserved Allen–Cahn equation to simulate the cracking process. Two types of cracking experiments, namely, internal inclined cracking test and single-edge cracking test, are conducted to verify the simulation results. It is discovered that the phase-field method simulation could satisfactorily capture the Mixed-Mode I–II cracking behavior of mortar.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research performed in this paper is supported by National Natural Science Foundation of China (No. 41372320), Natural Science Foundation of Shandong Province (ZR2015EQ009), the Fundamental Research Funds for the Central Universities (06500036), and the Open Fund of State Key Laboratory of Disaster Reduction in Civil Engineering (SLDRCE15-03).
References
Aggelis, D., Mpalaskas, A., and Matikas, T. (2013). “Investigation of different fracture modes in cement-based materials by acoustic emission.” Cem. Concr. Res., 48, 1–8.
Akono, A., Reis, P., and Ulm, F. (2011). “Scratching as a fracture process: From butter to steel.” Phys. Rev. Lett., 106(20), 204302.
ASTM. (2012). “Standard test method for linear-elastic plane-strain fracture toughness of metallic materials.”, West Conshohocken, PA.
Backers, T., and Stephansson, O. (2012). “ISRM suggested method for the determination of mode II fracture toughness.” Rock Mech. Rock Eng., 45(6), 1011–1022.
Bascoul, A., and Turatsinze, A. (1994). “Microstructural characterization of mode-I crack opening in mortar.” Mater. Struct., 27(2), 71–78.
Cirak, F., Ortiz, M., and Pandolfi, A. (2005). “A cohesive approach to thin-shell fracture and fragmentation.” Comput. Methods Appl. Mech. Eng., 194(21), 2604–2618.
COMSOL Multiphysics 5.0 [Computer software]. COMSOL, Burlington, MA.
Das, S., Kizilkanat, A., and Neithalath, N. (2015). “Crack propagation and strain localization in metallic particulate-reinforced cementitious mortars.” Mater. Des., 79, 15–25.
Eastgate, L. O., Sethna, J. P., Rauscher, M., Cretegny, T., Chen, C. S., and Myers, C. R. (2002). “Fracture in mode I using a conserved phase-field model.” Phys. Rev. E, 65(3), 036117.
Farhidzadeh, A., Mpalaskas, A., Matikas, T., Farhidzadeh, H., and Aggelis, D. (2014). “Fracture mode identification in cementitious materials using supervised pattern recognition of acoustic emission features.” Constr. Build. Mater., 67(B), 129–138.
Ferretti, E., Casadio, E., and Di Leo, A. (2008). “Masonry walls under shear test: A CM modeling.” Comput. Model. Eng. Sci., 30(3), 163–189.
Francfort, G., and Marigo, J. (1998). “Revisiting brittle fracture as an energy minimization problem.” J. Mech. Phys. Solids, 46(8), 1319–1342.
Ge, Z., Wang, Y., Hou, Y., Sun, W., and Sun, R. (2015). “Evaluation of fracture in mortar subject to tension loading using phase field model and three point bending test.” Mater. Des., 86, 121–128.
Golewski, G., and Sadowski, T. (2014). “An analysis of shear fracture toughness and microstructure in concretes containing fly-ash.” Constr. Build. Mater., 51(31), 207–214.
Griffith, A. A. (1921). “The phenomena of rupture and flow in solids.” Philos. Trans. R. Soc., A, 221(582–593), 163–198.
Hou, Y., et al. (2016a). “Coupled Navier–Stokes phase-field model to evaluate the microscopic phase separation in asphalt binder under thermal loading.” J. Mater. Civ. Eng., .
Hou, Y., Sun, W., Huang, Y., Ayatollahi, M., Wang, L., and Zhang, J. (2016b). “Diffuse-interface model to investigate the asphalt concrete cracking subjected to shear loading at a low temperature.” J. Cold Reg. Eng., .
Hou, Y., Wang, L., Pauli, T., and Sun, W. (2015). “Investigation of the asphalt self-healing mechanism using a phase-field model.” J. Mater. Civ. Eng., 623(3), 1–3.
Hou, Y., Wang, L., Yue, P., Pauli, T., and Sun, W. (2014). “Modeling mode I cracking failure in asphalt binder by using nonconserved phase-field model.” J. Mater. Civ. Eng., 684–691.
Kuhn, C., and Muller, R. (2010). “A continuum phase field model for fracture.” Eng. Fract. Mech., 77(18), 3625–3634.
Mauroux, T., Benboudjema, F., Turcry, P., Ait-Mokhtar, A., and Deves, O. (2012). “Study of cracking due to drying in coating mortars by digital image correlation.” Cem. Concr. Res., 42(7), 1014–1023.
Miehe, C., Hofacker, M., and Welschinger, F. (2010a). “A phase field model for rate-independent crack propagation: Robust algorithmic implementation based on operator splits.” Comput. Methods Appl. Mech. Eng., 199(45–48), 2765–2778.
Miehe, C., Welschinger, F., and Hofacker, M. (2010b). “Thermodynamically consistent phase-field models of fracture: Variational principles and multi-field FE implementations.” Int. J. Numer. Methods Eng., 83(10), 1273–1311.
Miller, R., Castro-Montero, A., and Shah, S. (1991). “Cohesive crack models for cement mortar examined using finite-element analysis and laser holographic measurements.” J. Am. Ceram. Soc., 74(1), 130–138.
Nguyen, T., et al. (2016). “On the choice of numerical parameters in the phase field method for simulating crack initiation with experimental validation.” Int. J. Fract., 197(2), 213–226.
Nguyen, T., Yvonnet, J., Zhu, Q., Bornert, M., and Chateau, C. (2015). “A phase field method to simulate crack nucleation and propagation in strongly heterogeneous materials from direct imaging of their microstructure.” Eng. Fract. Mech., 139, 18–39.
Nunes, L., and Reis, J. (2012). “Estimation of crack-tip-opening displacement and crack extension of glass fiber reinforced polymer mortars using digital image correlation method.” Mater. Des., 33, 248–253.
Reeder, J. R. (1992). NASA technical memorandum 104210: An evaluation of mixed-mode delamination failure criteria, National Aeronautics and Space Administration, Langley Research Center, Hampton, VA.
Rice, J. (1968). “A path independent integral and approximate analysis of strain concentration by notches and cracks.” J. Appl. Mech., 35(2), 379–386.
Rouchier, S., Woloszyn, M., Foray, G., and Roux, J. (2013). “Characterisation of concrete and mortar cracking by digital image correlation and acoustic emission.” Eur. J. Environ. Civ. Eng., 17(6), 467–477.
Sagar, R., Prasad, B., and Kumar, S. (2012). “An experimental study on cracking evolution in concrete and cement mortar by the b-value analysis of acoustic emission technique.” Cem. Concr. Res., 42(8), 1094–1104.
Schneemayer, A., Schranz, C., Kolbitsch, A., and Tschegg, E. (2014). “Fracture-mechanical properties of mortar-to-brick interfaces.” J. Mater. Civ. Eng., .
Su, R., Chen, H., and Kwan, A. (2012). “Incremental displacement collocation method for the evaluation of tension softening curve of mortar.” Eng. Fract. Mech., 88, 49–62.
Tschegg, E., Jamek, M., and Schouenborg, B. (2008). “Fracture properties of marble-mortar compounds.” Bull. Eng. Geol. Environ., 67(2), 199–208.
Turatsinze, A., and Bascoul, A. (1996). “Restrained crack widening in mode I crack propagation for mortar and concrete.” Adv. Cem. Based Mater., 4(3), 77–92.
Wise, S. M., Lowengrub, J. S., Kim, J. S., and Johnson, W. C. (2004). “Efficient phase-field simulation of quantum dot formation in a strained heteroepitaxial film.” Superlattices Microstruct., 36(1), 293–304.
Wu, Z., Yang, S., Hu, X., and Zheng, J. (2007). “Analytical method for pullout of anchor from anchor-mortar-concrete anchorage system due to shear failure of mortar.” J. Eng. Mech., 1352–1369.
Xu, Y., and Reinhardt, H. (2005). “Shear fracture on the basis of fracture mechanics.” Otto Graf J., 16, 21–78.
Yang, S., Hu, X., Leng, K., and Liu, Y. (2014). “Correlation between cohesive crack-tip local fracture energy and peak load in mortar beams.” J. Mater. Civ. Eng., 26(10), .
Yue, P., Zhou, C., Feng, J., Ollivier-Gooch, C. F., and Hu, H. H. (2006). “Phase-field simulation of interfacial dynamics in viscoelastic fluids using finite elements with adaptive meshing.” J. Comput. Phys., 219(1), 47–67.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Feb 23, 2016
Accepted: Nov 4, 2016
Published online: Feb 22, 2017
Published in print: Jul 1, 2017
Discussion open until: Jul 22, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.