ACMEG-T: Soil Thermoplasticity Model
Publication: Journal of Engineering Mechanics
Volume 135, Issue 9
Abstract
This paper addresses an advanced and unified thermomechanical constitutive model for soils. Based on experimental evidence showing the nonlinear and irreversible thermomechanical responses of saturated soils, the constitutive equations of the developed model, Advanced Constitutive Model for Environmental Geomechanics-Thermal effect (ACMEG-T), are presented. In the context of elastoplasticity and critical state theory, the model uses the multimechanism plasticity and bounding surface theory. Nonlinear thermoelasticity is joined with two coupled thermoplastic dissipative processes. The yield functions, the dissipative potentials and the plastic multipliers are introduced. Attention is particularly focused on the coupling between both plastic mechanisms, an isotropic and a deviatoric one, which are in agreement with the consistency condition for multiple dissipation. As far as isotropic mechanism is concerned, a unique thermomechanical yield surface reproduces the thermoplasticity observed at low and intermediate overconsolidation ratios, as well as the plasticity under mechanical loading in an framework unifying mechanical and thermal hardenings. Finally, the efficiency of ACMEG-T is proven by validation tests on drained and undrained thermomechanical paths.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was partially funded by the Swiss State Secretariat for Education and Research SER, Grant No. UNSPECIFIEDOFES C04.0021.
References
Abuel-Naga, H. M., Bergado, D. T., and Bouazza, A. (2007). “Thermally induced volume change and excess pore water pressure of soft Bangkok clay.” Eng. Geol. (Amsterdam), 89(1–2), 144–154.
Abuel-Naga, H. M., Bergado, D. T., Ramana, G. V., Grino, L., Rujivipat, P., and Thet, Y. (2006). “Experimental evaluation of engineering behavior of soft Bangkok clay under elevated temperature.” J. Geotech. Geoenviron. Eng., 132(7), 902–910.
Brandl, H. (2006). “Energy foundations and other thermo-active ground structures.” Geotechnique, 56(2), 81–122.
Burger, A., Recordon, E., Bovet, D., Cotton, L., and Saugy, B. (1985). “Thermique des nappes souterraines.” Presses polytechniques universitaires romandes, PPUR, Lausanne, Switzerland.
Campanella, R., and Mitchell, J. (1968). “Influence of temperature on soil behavior.” J. Soil Mech. and Found. Div., 94, 709–734.
Cekerevac, C., and Laloui, L. (2004). “Experimental study of the thermal effects on the mechanical behaviour of a clay.” Int. J. Numer. Analyt. Meth. Geomech., 28, 209–228.
Cui, Y. J., Sultan, N., and Delage, P. (2000). “A thermomechanical model for saturated clays.” Can. Geotech. J., 37, 607–620.
Dafalias, Y., and Herrmann, L. (1980). “A bounding surface soil plasticity model.” Proc., Int. Symp. Soils under Cyclic Transient Loading, G. N. Pande and O. C. Zienkiewicx, eds., Balkema, Rotterdam, 335–345.
Eriksson, L. G. (1989). “Temperature effects on consolidation properties of sulphide clays.” Proc., 12th Int. Conf. on Soil Mechanics and Foundation Engineering, Rio de Janeiro, Balkema, Rotterdam, Brookfield, 2087–2090.
Hueckel, T., and Borsetto, M. (1990). “Thermo-plasticity of saturated soils and shales: Constitutive equations.” J. Geotech. Engrg., 116(12), 1778–1796.
Hueckel, T., and Pellegrini, R. (1992). “Effective stress and water pressure in saturated clays during heating-cooling cycles.” Can. Geotech. J., 29, 1095–1102.
Hujeux, J. C. (1979). “Calcul numérique de problèmes de consolidation élastoplastique.” Ph.D. thesis, Ecole Centrale de Paris, Paris.
Jamin, F. (2003). “Contribution à l'étude du transport de matière et de la rhéologie dans les sols non saturés à différentes températures.” Ph.D. thesis, Université Montpellier II, Montpellier, France.
Koiter, W. T. (1960). “General theorems for elastic-plastic solids.” Progress in solid mechanics, I. N. Sneddon and R. Hill, eds., North-Holland, Amsterdam, The Netherlands, 167–221.
Laloui, L. (1993). “Modélisation du comportement thermo-hydro-mécanique des milieux poreux anélastique.” Ph.D. thesis, Ecole Centrale de Paris, Paris.
Laloui, L., and Cekerevac, C. (2003). “Thermo-plasticity of clays: An isotropic yield mechanism.” Comput. Geotech., 30(8), 649–660.
Laloui, L., and Cekerevac, C. (2008a). “Non-isothermal plasticity model for cyclic behaviour of soils.” Int. J. Numer. Analyt. Meth. Geomech., 32(5), 437–460.
Laloui, L., and Cekerevac, C. (2008b). “Numerical simulation of the non-isothermal mechanical behaviour of soils.” Comput. Geotech., 35(5), 729–745.
Laloui, L., and Modaressi, H. (2002). “Modelling of the thermo-hydro-plastic behaviour of clays.” Hydromechanical and thermohydromechanical behaviour of deep argillaceous rock, Balkema, Rotterdam, The Netherlands, 161–170.
Laloui, L., Moreni, M., and Vulliet, L. (2003). “Behavior of a dual-purpose pile as foundation and heat exchanger.” Can. Geotech. J., 40(2), 388–402.
Laloui, L., Nuth, M., and Vulliet, L. (2006). “Experimental and numerical investigations of the behaviour of a heat exchanged pile.” Int. J. Numer. Analyt. Meth. Geomech., 30, 763–781.
Lewis, R. W., and Schrefler, B. A. (1987). The finite element method in the deformation and consolidation of porous media, Wiley, New York.
Mandel, W. (1965). “Généralisation de la théorie de Koiter.” Int. J. Solids Struct., 1, 273–295.
Mitchell, J. K. (1976). Fundamentals of soil behavior, Wiley, New York.
Mitchell, J. K., McMillan, J., Green, S., and Sisson, R. (1982). “Field testing of cable backfill systems.” Underground cable thermal backfill, Pergamon, New York, 19–33.
Modaressi, H., and Laloui, L. (1997). “A thermo-viscoplastic constitutive model for clays.” Int. J. Numer. Analyt. Meth. Geomech., 21(5), 313–315.
Moritz, L. (1995). “Geotechnical properties of clay at elevated temperatures.” Swed. Geotech. Inst., 47.
Prager, W. (1958). “Non-isothermal plastic deformation.” Proc., Section of Sciences-B, Vol. 61, Koninlijke Nederlandse Akademie van Wetenschapen, 176–182.
Rizzi, E., Maier, G., and Willam, K. (1996). “On failure indicators in multi-dissipative materials.” Int. J. Solids Struct., 33(20–22), 3187–3214.
Roscoe, K. H., and Burland, J. B. (1968). “On the generalized stress-strain behaviour of ‘wet’ clay.” Engineering plasticity, J. Heyman and F. A. Leckie, eds., Cambridge University Press, Cambridge, England, 535–609.
Tidfors, M., and Sällfors, G. (1989). “Temperature effect on preconsolidation pressure.” Geotech. Test. J., 12, 93–97.
Vulliet, L., Laloui, L., and Schrefler, B. (2002). Environmental geomechanics, EPFL, Lausanne, Switzerland.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Mar 4, 2008
Accepted: Nov 18, 2008
Published online: Mar 5, 2009
Published in print: Sep 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.