Steel Aggregate Swelling Potential in Layers of Road Pavements
Publication: Journal of Environmental Engineering
Volume 144, Issue 9
Abstract
Steel slag, one of the by-products from the production of steel, is crushed, sized properly, and treated in relation to its volume swelling potential to be used as a highly resistant aggregate called steel aggregate or steel gravel. This study analyzes the swelling mechanisms of steel aggregate. By laboratory testing, the volumetric swelling potential in samples of steel aggregate and samples of lateritic soil and steel aggregate mixtures was determined in two different proportions: 90% soil steel aggregate (M9010); and 80% soil steel aggregate, by weight (M8020). This analysis is part of a project that assesses the feasibility of the utilization of this coproduct in the construction industry in Brazil. Average swelling values of 0.92, 0.73, and 0.61% were obtained from the steel aggregate samples and from the M9010 and M8020 mixture samples, respectively. According to Brazilian and Japanese standard volumetric swelling limits, all tested materials are suitable for the use of paving as an alternative to the use of natural aggregates.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge the support of the following agencies: the Brazilian Council for Scientific and Technological Development (CNPq) (Grant No. 304721/2017-4), the Coordination for the Improvement of Higher Level Personnel (CAPES), the Support Research of the Federal District Foundation (FAP-DF), the Brazilian Transport Infrastructure Department (DNIT), the Brazil Steel Institute (BSI), and the University of Brasilia (UnB) for funding this research.
References
ABNT (Brazilian Association of Technical Standards). 1986. Soil samples: Preparation for compaction tests and characterization tests. NBR 6457-86. Rio de Janeiro, Brazil: ABNT.
ABNT (Brazilian Association of Technical Standards). 1987. “Soil—California bearing ratio.”. Rio de Janeiro, Brazil: ABNT.
ABNT (Brazilian Association of Technical Standards). 2015. Execution of sub-base and base stabilized granulometrically with steel aggregate for road paving. NBR 16364. Rio de Janeiro, Brazil: ABNT.
ASTM. 1998. Standard specification for graded aggregate material for bases or subbases for highways or airports. ASTM D2940-98. West Conshohocken, PA: ASTM.
Castelo Branco, V. T. 2004. “Characterization of asphalt mixtures with the use of steel slag as aggregate.” Master’s dissertation, Dept. of Civil Engineering, Federal Univ. of Rio de Janeiro.
da Silva, E. A. 1991. “Use of steel slag in road paving.” In 28th Annual Paving Meeting. Rio de Janeiro, Brazil: Brazilian Paving Association.
DNIT (National Department of Transport Infrastructure). 2009. Road paving: Artificial aggregate—Evaluation of the expansion potential of steel slag. ME 113. Rio de Janeiro, Brazil: DNIT.
DNIT (National Department of Transport Infrastructure). 2016. Soils—Determination of the California Support Index using unworked samples—Test method. ME 172. Rio de Janeiro, Brazil: DNIT.
DNIT (National Department of Transport Infrastructure). 2013. Soils—Compaction using unworked samples. ME 164. Rio de Janeiro, Brazil: DNIT.
Graffitti, D. F. 2002. “Evaluation of free lime content in electric steel slag.” Master’s dissertation, Dept. of Civil Engineering, Federal Univ. of Rio Grande do Sul.
IABR (Brazilian Steel Institution). 2014. Sustainability report 2014. Rio de Janeiro, Brazil: IABR.
JSA (Japanese Standards Association). 2013. Iron and steel slag for road construction. JIS A 5015. Tokyo: JSA.
Koryak, M., L. J. Stafford, R. J. Reilly, and M. P. Magnuson. 2002. “Impacts of steel mill slag leachate on the water quality of a small Pennsylvania stream.” J. Freshwater Ecol. 17 (3): 461–465. https://doi.org/10.1080/02705060.2002.9663921.
Krass, K., C. Kellermann, and M. Rohleder. 1999. “Abfall, Aufbereitung und Verwertung von Recycling-Baustoffen und industriellen Nebenprodukten im Wirtschaftsjahr 1997-Teil 2: Industrielle Nebenprodukte.” Strasse und Autobahn 50 (9): 473–478.
Machado, A. T. 2000. “Comparative study of test methods for evaluation of steel slag expandability.” Master’s dissertation, Dept. of Civil Engineering, Univ. of São Paulo Polytechnic School.
Maharaj, C., D. White, R. Maharaj, and C. Morin. 2017. “Re-use of steel slag as an aggregate to asphaltic road pavement surface.” Cogent Eng. 4 (1): 1416889. https://doi.org/10.1080/23311916.2017.1416889.
Mayes, W. M., P. L. Younger, and J. Aumônier. 2008. “Hydrogeochemistry of alkaline steel slag leachates in the U.K.” Water Air Soil Pollut. 195 (1–4): 35–50. https://doi.org/10.1007/s11270-008-9725-9.
Motz, H., and J. Geiseler. 2001. “Products of steel slags an opportunity to save natural resources.” Waste Manage. 21 (3): 285–293. https://doi.org/10.1016/S0956-053X(00)00102-1.
Özkök, E., A. P. Davis, and A. H. Aydilek. 2015. “Treatment methods for mitigation of high alkalinity in leachates of aged steel slag.” J. Environ. Eng. 142 (2): 04015063. https://doi.org/10.1061/(ASCE)EE.1943-7870.0001024.
PennDOT (Pennsylvania Department of Transportation). 1978. Test method for evaluation of the steel slag expansion potential. PTM 130. Harrisburg, PA: PennDOT.
Proctor, D. M., et al. 2000. “Physical and chemical characteristics of blast furnace, basic oxygen furnace, and electric arc furnace steel industry slags.” Environ. Sci. Technol. 34 (8): 1576–1582. https://doi.org/10.1021/es9906002.
Roadcap, G. S., W. R. Kelly, and C. M. Bethke. 2005. “Geochemistry of extremely alkaline () groundwater in slag-fill aquifers.” Ground Water 43 (6): 806–816. https://doi.org/10.1111/j.1745-6584.2005.00060.x.
Rohde, L. 2002. “Electric steel slag in granular layers of pavements: Laboratory study.” Master’s dissertation, Dept. of Civil Engineering, Federal Univ. of Rio Grande do Sul.
Silva, P. 2001. “Concrete reinforcement study of portland cement at the experimental circular road of the institute of highway research.” Ph.D. thesis, Dept. of Civil Engineering, Federal Univ. of Rio de Janeiro.
Timothy, R. 1992. Steel slag aggregates in Bituminous mixtures. Springfield, VA: Bureau of Bridge and Roadway Technology, Pennsylvania Dept. of Transportation.
USGS. 1997. Mineral industry surveys: Slag-iron and steel, annual review—1997. Reston, VA: USGS.
Wu, S., Y. Xue, Q. Ye, and Y. Chen. 2007. “Utilization of steel slag as aggregates for stone mastic asphalt (SMA) mixtures.” Build Environ. 42 (7): 2580–2585. https://doi.org/10.1016/j.buildenv.2006.06.008.
Xue, Y., S. Wu, H. Hou, and J. Zha. 2006. “Experimental investigation of basic oxygen furnace slag used as aggregate in asphalt mixture.” J. Hazard. Mater. 138 (2): 261–268. https://doi.org/10.1016/j.jhazmat.2006.02.073.
Yildirim, I. Z., and M. Prezzi. 2015. “Geotechnical properties of fresh and aged basic oxygen furnace steel slag.” J. Mater. Civ. Eng. 27 (12): 04015046. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001310.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Dec 9, 2016
Accepted: Mar 30, 2018
Published online: Jun 25, 2018
Published in print: Sep 1, 2018
Discussion open until: Nov 25, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.