Effects of Flow Rate and Gas Species on Microbubble and Nanobubble Transport in Porous Media
Publication: Journal of Environmental Engineering
Volume 143, Issue 7
Abstract
Transport of microbubbles and nanobubbles (MNBs) in porous media has drawn increasing attention as a promising technology for soil and groundwater remediation. Understanding the transport mechanisms of MNBs in soils is essential to optimize MNB-based remediation techniques. In this study, effects of flow rates and bubble gas species on transport characteristics of MNBs were investigated in columns packed with glass beads. Microbubbles and nanobubbles were created by either air or oxygen injection to the columns at different flow rates. All results showed marked entrapment of MNBs inside the columns and relatively higher retardation of MNBs with smaller bubble size. The entrapment was enhanced for air-based MNBs under lower flow rate. A convection-dispersion model including bubble attachment could well capture the obtained effluent curves for MNB transport at high flow conditions. For low flow conditions, a model including bubble attachment-detachment and straining terms best described the data. The fitted model parameters suggested that irreversible straining is an important deposition mechanism for MNB transport in porous media.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by Grant-in-Aid for Scientific Research of JSPS (No. 26709033, 16H04411), and Grant-in-Aid for Exploratory Research for Research Institute for Sustainable Humanosphere, Kyoto University, Japan. The authors would especially like to thank Professor Ohshita and Dr. Liu from the Graduate School of Agricultural and Life Sciences at the University of Tokyo for their assistance with zeta potential measurements.
References
Bradford, S. A., Šimůnek, J., Bettahar, M., van Genuchten, M. Th., and Yates, S. R. (2003). “Modeling colloid attachment, straining and exclusion in saturated porous media.” Environ. Sci. Technol., 37(10), 2242–2250.
Bradford, S. A., and Torkzaban, S. (2008). “Colloid transport and retention on in unsaturated porous media: A review of interface-, collector-, and pore-scale processes and models.” Vadose Zone J., 7(2), 667–681.
Choi, Y. J., Park, J. Y., Kim, Y. J., and Nam, K. (2008). “Flow characteristics of microbubble suspensions in porous media as an oxygen carrier.” Clean Soil Air Water, 36(1), 59–65.
Chu, L. B., Xing, X. H., Yu, A. F., Zhou, Y. N., Sun, X. L., and Jurcik, B. (2007). “Enhanced ozonation of simulated dyestuff wastewater by microbubbles.” Chemosphere, 68(10), 1854–1860.
Jauregi, P., and Varley, J. (1999). “Colloidal gas aphrons: Potential applications in biotechnology.” Trends Biotechnol., 17(10), 389–395.
Jenkins, K. B., Michelsen, D. L., and Novak, J. T. (1993). “Application of oxygen microbubbles for in situ biodegradation of p-xylene-contaminated groundwater in a soil column.” Biotechnol. Prog., 9(4), 394–400.
Kretzschmar, R., Barmettler, K., Grolimund, D., Yan, Y. D., Borkovec, M., and Sticher, H. (1997). “Experimental determination of colloid deposition rates and collision efficiencies in natural porous media.” Water Resour. Res., 33(5), 1129–1137.
Li, X., Zhang, P., Lin, C. L., and Johnson, W. P. (2005). “Role of hydrodynamics drag on microsphere deposition and re-entrainment in porous media under unfavorable conditions.” Environ. Sci. Technol., 39(11), 4012–4020.
Litton, G. M., and Olson, T. M. (1993). “Colloid deposition rates on silica bed media and artifacts related to collector surface preparation methods.” Environ. Sci. Technol., 27(1), 185–193.
Rothmel, R. K., Peters, R. W., Martin, E. S., and Deflaun, M. F. (1998). “Surfactant foam/bioaugmentation technology for in situ treatment of TCE-DNAPLs.” Environ. Sci. Technol., 32(11), 1667–1675.
Sharma, A., Kawamoto, K., Moldrup, P., de Jonge, L. W., and Komatsu, T. (2011). “Transport and deposition of suspended soil colloids in saturated sand columns.” J. Hazard. Toxic Radioact. Waste, 275–284.
Šimůnek, J., and van Genuchten, M. Th. (2008a). “Modeling nonequilibrium flow and transport processes using HYDRUS.” Vadose Zone J., 7(2), 782–797.
Šimůnek, J., and van Genuchten, M. Th. (2008b). The HYDRUS-1D software package for simulating the one-dimensional movement of water, heat, and multiple solutes in variably saturated media: Version 3.3, Dept. of Environmental Science, Univ. of California Riverside, Riverside, CA.
Takahashi, M. (2005). “Zeta potential of microbubbles in aqueous solutions: Electrical properties of the gas-water interface.” J. Phys. Chem. B, 109(46), 21858–21864.
Takahashi, M., Chiba, K., and Li, P. (2007). “Free-radical generation from collapsing microbubbles in the absence of a dynamic stimulus.” J. Phys. Chem. B, 111(6), 1343–1347.
Ushikubo, F. Y., et al. (2010). “Evidence of the existence and the stability of nano-bubbles in water.” Colloids Surf., A, 361(1), 31–37.
Wan, J., Veerapaneni, S., Gadelle, F., and Tokunaga, T. (2001). “Generation of stable microbubbles and their transport through porous media.” Water Resour. Res., 37(5), 1173–1182.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 143 • Issue 7 • July 2017
Copyright
©2017 American Society of Civil Engineers.
History
Received: Sep 21, 2016
Accepted: Dec 8, 2016
Published online: Mar 7, 2017
Published in print: Jul 1, 2017
Discussion open until: Aug 7, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.