Numerical Simulation of Near-Field Dredging Plumes: Efficiency of an Environmental Valve
Publication: Journal of Environmental Engineering
Volume 141, Issue 12
Abstract
Numerical simulations of the sediment-air-water buoyant jet released through the hopper dredgers’ overflow shaft have been performed. The release of sediments into the marine environment due to skimming the excess water from the dredging vessel’s hopper can lead to increased turbidity and adverse effects on the adjacent environment. Base-case simulations have been validated using in situ field observations. Simulations have been performed using the large-eddy simulation technique, which allows including the effect of large turbulent structures on the sediment dispersion. The complex nature of the flow field poses challenges for numerical simulations, such as the presence of propeller jets and three different phases: water, sediment, and air bubbles. The model has been applied to simulate the effect of a so-called environmental valve, which reduces air inclusion. This valve has been used in the past, but its efficiency as a function of the boundary conditions was never analyzed before. It is shown in this article that this type of valve can be very effective in reducing the generated turbidity, but only under given combinations of dredging speed, sediment concentration, overflow shaft diameter and overflow-stern distance.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors wish to thank the Agentschap voor Innovatie door Wetenschap en Technologie (IWT) and International Marine and Dredging Consultants (IMDC) for funding this work.
References
ANSYS Fluent 14.5 [Computer software]. Canonsburg, PA, Ansys.
Bel F’Dhila, R., and Simonin, O. (1992). “Eulerian prediction of a turbulent bubbly flow downstream a sudden pipe expansion.” 6th Workshop on Two-Phase Flow Prediction, Erlangen, Germany.
Bray, R. N. (2008). Environmental aspects of dredging, CRC Press, Leiden.
Carrica, P., Drew, D., Bonetto, F., and Lahey Jr., R. (1999). “A polydisperse model for bubbly two-phase flow around a surface ship.” Int. J. Multiphase Flow, 25(2), 257–305.
Decrop, B., De Mulder, T., Toorman, E., and Sas, M. (2015). “Large-eddy simulations of turbidity plumes in crossflow.” Eur. J. Mech., B/Fluids, 53, 68–84.
Decrop, B., and Sas, M. (2014). “Challenges in the acoustic measurements of dredging plumes.” Particles in Europe 2014, Sequoia Scientific, Bellevue, WA, 35–41.
Decrop, B., Sas, M., De Mulder, T., and Toorman, E. (2014). “Large-eddy simulations of a sediment-laden buoyant jet resulting from dredgers using overflow.” Int. Conf. on Hydroscience and Engineering, Bundesanstalt für Wasserbau, 737–744.
de Wit, L., Talmon, A., and van Rhee, C. (2014). “3D CFD simulations of trailing suction hopper dredger plume mixing: Comparison with field measurements.” Mar. Pollut. Bull., 88(1), 34–46.
de Wit, L., van Rhee, C., and Talmon, A. (2015). “Influence of important near field processes on the source term of suspended sediments from a dredging plume caused by a trailing suction hopper dredger: The effect of dredging speed, propeller, overflow location and pulsing.” Environ. Fluid Mech., 15(1), 41–66.
Ervine, D. (1998). “Air entrainment in hydraulic structures: A review.” Proc. ICE Water Marit. Energy, 130(3), 142–153.
Fischer, H. B. (1979). Mixing in inland and coastal waters, Academic Press, San Diego.
Fric, T., and Roshko, A. (1994). “Vortical structure in the wake of a transverse jet.” J. Fluid Mech., 279(1), 1–47.
Germano, M., Piomelli, U., Moin, P., and Cabot, W. H. (1991). “A dynamic subgrid-scale eddy viscosity model.” Phys. Fluids A, 3(7), 1760–1765.
Hough, G., and Ordway, D. (1964). The generalized actuator disk, Therm Advanced Research, Ithaca, NY.
Ishii, M., and Hibiki, T. (2006). Thermo-fluid dynamics of two-phase flows, Springer, New York.
Issa, R. I. (1986). “Solution of the implicitly discretised fluid flow equations by operator-splitting.” J. Comput. Phys., 62(1), 40–65.
Jirka, G. H. (2006). “Integral model for turbulent buoyant jets in unbounded stratified flows Part 2: Plane jet dynamics resulting from multiport diffuser jets.” Environ. Fluid Mech., 6(1), 43–100.
Kelso, R. M., Lim, T., and Perry, A. E. (1996). “An experimental study of round jets in cross-flow.” J. Fluid Mech., 306(1), 111–144.
Kim, S. (2004). “Large eddy simulation using unstructured meshes and dynamic subgrid-scale turbulence models.”, American Institute of Aeronautics and Astronautics (AIAA), Reston VA.
Kolmogorov, A. N. (1941). “The local structure of turbulence in incompressible viscous fluid for very large Reynolds numbers.” Dokl. Akad. Nauk SSSR, 30(4), 299–303.
Lam, W., et al. (2006). “Simulations of a ship’s propeller wash.” The 16th Int. Offshore and Polar Engineering Conf., International Society of Offshore and Polar Engineers.
Lam, W.-H., Hamill, G., Robinson, D., and Raghunathan, S. (2010). “Observations of the initial 3D flow from a ship’s propeller.” Ocean Eng., 37(14), 1380–1388.
Leonard, A. (1974). “Energy cascade in large-eddy simulations of turbulent fluid flows.” Turbulent diffusion in environmental pollution, Vol. 1, 237–248.
Leonard, B., and Mokhtari, S. (1990). “ULTRA-SHARP nonoscillatory convection schemes for high-speed steady multidimensional flow.” Lewis Research Center, Cleveland.
Lilly, D. (1992). “A proposed modification of the Germano subgrid-scale closure method.” Phys. Fluids A Fluid Dyn., 4(3), 633.
Manninen, M., Taivassalo, V., and Kallio, S. (1996). “On the mixture model for multiphase flow.” Technical Research Centre of Finland, VTT Publications, Espoo, Finland, 288.
Mathey, F., Cokljat, D., Bertoglio, J.-P., and Sergent, E. (2006). “Specification of LES inlet boundary condition using vortex method.” Prog. Comput. Fluid Dyn., 6(1), 58–67.
Morsi, S., and Alexander, A. (1972). “An investigation of particle trajectories in two-phase flow systems.” J. Fluid Mech., 55(2), 193–208.
Odar, F., and Hamilton, W. S. (1964). “Forces on a sphere accelerating in a viscous fluid.” J. Fluid Mech., 18(2), 302–314.
PIANC (Permanent International Association of Navigation Congresses). (2010). “Dredging and port construction around coral reefs.” The World Association for Waterborne Transport Infrastructure, Brussels, Belgium.
Pope, S. B. (2000). Turbulent flows, Cambridge University Press, Cambridge.
Pope, S. B. (2004). “Ten questions concerning the large-eddy simulation of turbulent flows.” New J. Phys., 6(1), 35.
Saremi, S. (2014). “Density-driven currents and deposition of fine materials.” Ph.D. thesis, DTU Mechanical Engineering, Dept. of Mechanical Engineering, Lyngby, Denmark.
Smagorinsky, J. (1963). “General circulation experiments with the primitive equations. I: The basic experiment.” Mon. Weather Rev., 91(3), 99–164.
Smith, S. J., and Friedrichs, C. T. (2011). “Size and settling velocities of cohesive flocs and suspended sediment aggregates in a trailing suction hopper dredge plume.” Cont. Shelf Res., 31(10), S50–S63.
Spearman, J., De Heer, A., Aarninkhof, S., and Van Koningsveld, M. (2011). “Validation of the TASS system for predicting the environmental effects of trailing suction hopper dredgers.” Terra et Aqua, 125, 14–22.
Van Parys, M., et al. (2001). “Environmental monitoring of the dredging and relocation operations in the coastal harbours in Belgium: MOBAG 2000.” EADA, Kuala Lumpur, Malaysia.
Versteeg, H. K., and Malalasekera, W. (2007). An introduction to computational fluid dynamics: the finite volume method, Prentice Hall, Essex, England.
Visonneau, M., Queutey, P., and Deng, G. (2006). “Model and full-scale free-surface viscous flows around fully-appended ships.” Proc., European Conf. on Computational Fluid Dynamics (ECCOMAS CFD), TU Delft, Delft, Netherlands, 5–8.
Zhang, W., and Zhu, D. Z. (2013). “Bubble characteristics of air-water bubbly jets in crossflow.” Int. J. Multiphase Flow, 55, 156–171.
Zimmermann, N., Melotte, J., Breugem, W. A., Sas, M., and Lehay, D. (2010). “Monitoring the behaviour of sediments disposed by a TSHD in the external estuary of the Loire.” Proc., WODCON XIX Conf., EADA, Kuala Lumpur, Malaysia.
Zorn, T., Heimann, J., and Bertram, V. (2010). “CFD analysis of a Duct’s effectiveness for model scale and full scale.” 13th Numerical Towing Tank Symp., Univ. Duisburg, Duisburg, Germany.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jan 20, 2015
Accepted: Apr 28, 2015
Published online: Jul 14, 2015
Published in print: Dec 1, 2015
Discussion open until: Dec 14, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.