Design and Characterization of a Turbulence Chamber for Scalar Flux Measurements at a Sediment-Water Interface
Publication: Journal of Environmental Engineering
Volume 141, Issue 3
Abstract
A turbulence chamber designed specifically for the laboratory study of environmental scalar fluxes at sediment-water interfaces was developed and fully characterized. The turbulent flow field was documented using particle image velocimetry (PIV), with particular emphasis on turbulence characterization. The chamber is capable of reproducing a wide range of turbulence levels covering 6 orders of magnitude of the dissipation rate of turbulent kinetic energy (). Its performance range includes conditions similar to low energy environments such as lake and reservoir bottom boundary layers (BBLs), verified by comparison to field data. The chamber is forced by three peristaltic pumps plumbed to six equispaced orifices on the top cap of the chamber, forming a closed system. The pumps drive either a momentum source (a jet) in the vertical direction or a momentum sink. The pumps operate continuously, but randomly change direction to generate a horizontally homogeneous turbulent region near the sediment-water interface. Measured turbulence intensities show a quadratic relationship with pump speed (rpm), with typical environmental BBL turbulence intensities seen at low pump speeds (). Dissipation shows a log-linear relationship to pump speed. A field experiment in Onondaga Lake was used to characterize typical lacustrine BBL turbulence, allowing the turbulence chamber design objective of reproducing the observed range of conditions to be met. The presented chamber design is adaptable and readily optimizable by users to the specific system under study. This flexible, self-contained design was motivated by the need to handle mercury-contaminated sediments from Onondaga Lake, the initial system it was used to study. Compared to similar facilities, the presented chamber provides well-characterized turbulence which is calibrated against environmental conditions with a direct correspondence between chamber and field turbulence levels in the form of turbulence intensity and turbulent dissipation values.
Get full access to this article
View all available purchase options and get full access to this article.
References
Arega, F., and Lee, J. H. W. (2005). “Diffusional mass transfer at sediment-water interface of cylindrical sediment oxygen demand chamber.” J. Environ. Eng., 755–766.
Auer, M. T., et al. (2010). “Induced oxygen demand and electron acceptor amendment in Onondaga Lake, New York.”, New York State Dept. of Environmental Conservation, Albany, NY.
Beutel, M., Nannoun, I., Pasek, J., and Kavanagh, K. B. (2007). “Evaluation of hypolimnetic oxygen demand in a large eutrophic raw water reservoir, San Vicente reservoir, CA.” J. Environ. Eng., 130–138.
Cowen, E. A., and Monismith, S. G. (1997). “A hybrid digital particle tracking velocimetry technique.” Exp. Fluids, 22(3), 199–211.
Doron, P., Bertuccioli, L., Katz, J., and Osborn, T. (2001). “Turbulence characteristics and dissipation estimates in the coastal ocean bottom boundary layer from PIV data.” J. Phys. Oceanogr., 31(8), 2108–2134.
Edberg, N., and Hofsten, B. V. (1973). “Oxygen uptake of bottom sediments studied in situ and in the laboratory.” Water Res., 7(9), 1285–1294.
Effler, S., and Hennigan, R. (1996). “Onondaga Lake, New York: Legacy of pollution.” Lake Reservoir Manage., 12(1), 1–12.
Effler, S. W. (1996). Limnological and engineering analysis of a polluted urban lake: Prelude to environmental management of Onandaga Lake, New York, Springer, New York.
Effler, S. W., et al. (2004). “An upwelling event at Onondaga lake, NY: Characterization, impact and recurrence.” Hydrobiologia, 511(1–3), 185–199.
Efron, B., and Tibshirani, R. (1993). An introduction to the bootstrap, Chapman and Hall, London, U.K.
Etebari, A., and Vlachos, P. P. (2005). “Improvements on the accuracy of derivative estimation from DPIV velocity measurements.” Exp. Fluids, 39(6), 1040–1050.
Gordon, L., Lohrmann, A., and Jonas, T. (1999). “Internal wave generation in lakes with very slow flow.” IEEE 6th Working Conf. on Current Measurement, IEEE, New York.
Hondzo, M. (1998). “Dissolved oxygen transfer at the sediment-water interface in a turbulent flow.” Water Resour. Res., 34(12), 3525–3533.
Hurther, D., and Lemmin, U. (2001). “A correction method for turbulence measurements with a 3D acoustic Doppler velocity profiler.” J. Atmos. Oceanic Technol., 18(3), 446–458.
Lee, J. H. W., Kuang, C. P., and Yung, K. S. (2000). “Analysis of three dimensional flow in a cylindrical sediment oxygen demand chamber.” Appl. Math. Model., 24(4), 263–278.
Liao, Q., and Cowen, E. A. (2005). “An efficient anti-aliasing spectral continuous window shifting technique for PIV.” Exp. Fluids, 38(2), 197–208.
Ligrani, P. (1988). “Structure of turbulent boundary layers.” Aerodynamics and compressible flows, encyclopedia of fluid mechanics, N. Cheremisinoff, ed., Gulf Publishing, Houston, 111–189.
Lohrmann, A., Cabrera, R., Gelfenbaum, G., and Haines, J. (1995). “Direct measurements of Reynolds stress with an acoustic Doppler velocimeter.” Proc., IEEE 5th Working Conf. on Current Measurement, IEEE, New York, 205–210.
Lorke, A., Müller, B., Maerki, M., and Wüest, A. (2003). “Breathing sediments: The control of diffusive transport across the sediment-water interface by periodic boundary-layer turbulence.” Limnol. Oceanogr., 48(6), 2077–2085.
Mackenthun, A. A., and Stefan, H. G. (1998). “Effect of flow velocity on sediment oxygen demand: Experiments.” J. Environ. Eng., 222–230.
MATLAB [Computer software]. Natick, MA, MathWorks.
Oldham, C. E., Ivey, G. N., and Pullin, C. (2004). “Estimation of a characteristic friction velocity in stirred benthic chambers.” Mar. Ecol. Prog. Ser., 279, 291–295.
Raupach, M. R., Antonia, R. A., and Rajagopalan, S. (1991). “Rough-wall turbulent boundary layers.” Appl. Mech. Rev., 44(1), 1–25.
Rusello, P. J. (2012). “Turbulence in low energy lacustrine environments at the sediment-water interface.” Ph.D. thesis, Cornell Univ., Ithaca, NY.
Saddoughi, S. G., and Veeravalli, S. V. (1994). “Local isotropy in turbulent boundary-layers at high reynolds-number.” J. Fluid Mech., 268(-1), 333–372.
Spalart, P. R. (1988). “Direct simulation of a turbulent boundary layer up to .” J. Fluid Mech., 187(1), 61–98.
Tennekes, H., and Lumley, J. L. (1972). A first course in turbulence, MIT Press, Cambridge, MA.
Truax, D. D., Shindala, A., and Sartain, H. (1995). “Comparison of two sediment oxygen demand measurement techniques.” J. Environ. Eng., 619–624.
Variano, E. A., and Cowen, E. A. (2008). “A random-jet-stirred turbulence tank.” J. Fluid Mech., 604, 1–32.
Webster, D. R., Brathwaite, A., and Yen, J. (2004). “A novel laboratory apparatus for simulating isotropic oceanic turbulence at low Reynolds number.” Limnol. Oceanogr. Methods, 2, 1–12.
Wuest, A., and Lorke, A. (2003). “Small-scale hydrodynamics in lakes.” Ann. Rev. Fluid Mech., 35(1), 373–412.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jul 31, 2012
Accepted: Jul 10, 2014
Published online: Sep 17, 2014
Discussion open until: Feb 17, 2015
Published in print: Mar 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.