Migration of High-Pressure Air during Gas Well Drilling in the Appalachian Basin
Publication: Journal of Environmental Engineering
Volume 140, Issue 5
Abstract
We present the details of a numerical model simulating the migration of pressurized air used for pneumatic drilling of a well in an aquifer. We used an incident that occurred in West Virginia during June 2012 as a basis for making the simulations realistic. We developed a 3D conceptual model using the multipurpose model TOUGH2 to simulate the events during this incident. Input parameters for the model were obtained from field measurements, and a number of reasonable assumptions were made for other parameters. Our results showed that compressed air from a drilling well is capable of creating a high pressure gradient in groundwater at hundreds of meters from the drill hole, even if the air leakage from the drilling well occurs in a confined aquifer, and even if the leakage duration is only 2 h. Therefore, one way to prevent the pressure buildup in the surrounding aquifers is through emplacement of observation wells before drilling, which would alert the drillers to any unusual pressure buildup inside the confined aquifer. However, air leakage in unconfined aquifers seems to have a much smaller spatial extent (less than tens of meters). Sensitivity analysis revealed that air pressure, fracture permeability, and injection time are critical parameters for the propagation of air.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This project was funded in part by the William Penn Foundation and the Claneil Foundation. However, no endorsement of the results by these organizations should be assumed.
References
A+ Environmental Solutions LLC (AES). (2013). “Drilling technology.” 〈http://www.envir-solutions.com/technologies/drilling-technology/〉 (Mar. 2, 2013).
Ahmed, N. (1997). Ground water: Protection alternatives and strategies in the USA, ASCE, Reston, VA.
Brown, S. R. (1987). “Fluid flow through rock joints: the effect of surface roughness.” J. Geophys. Res., 92(B2), 1337–1347.
Brown, S. R., Kranz, R. L., and Bonner, B. P. (1986). “Correlation between the surfaces of natural rock joints.” Geophys. Res. Lett., 13(13), 1430–1433.
Clearwater, J., Burnell, J., and Azwar, L. (2011). “Modeling the Ngatamariki geothermal system.” Proc., New Zealand Geothermal Workshop 2011, Stanford Geothermal Workshop, Stanford Univ., Stanford, CA.
Corey, A. T. (1954). “The interrelation between gas and oil relative permeabilities.” Producers Mon., 19(1), 38–41.
Crawford, S. (2012). “Drilling methods used by the western region research drilling program.” 〈http://ca.water.usgs.gov/projects/central-valley/drillrig_poster.pdf〉 (Mar. 2, 2013).
Cui, X., Bustin, R. M., and Dipple, G. (2004). “Differential transport of and in coalbed aquifers: Implications for coalbed gas distribution and composition.” AAPG Bull., 88(8), 1149–1161.
DOE. (2011). “DOE’s early investment in shale gas technology producing results today.” 〈http://www.netl.doe.gov/publications/press/2011/11008-DOE_Shale_Gas_Research_Producing_R.html〉 (Jun. 10, 2013).
Doyen, P. M. (1988). “Permeability, conductivity, and pore geometry of sandstone.” J. Geophys. Res., 93(B7), 7729–7740.
Findikakis, A. N., and Leckie, J. O. (1979). “Numerical simulation of gas flow in sanitary landfills.” J. Environ. Eng. Div., 105(5), 927–945.
Gala, D. (2011). “Air drilling improves efficiency in challenging well bores.” Hart’s E & P, 〈http://www.weatherford.com/weatherford/groups/web/documents/weatherfordcorp/wft184002.pdf〉.
Gazette, C. (2012). “Gas drillers hit aquifer; geysers erupt.” 〈http://www.wvgazette.com/News/201206060127〉 (Mar. 17, 2013).
Guo, Q., Ji, L., Rajabov, V., Friedheim, J., Portella, C., and Wu, R. (2012). “Shale gas drilling experience and lessons learned from eagle ford.” Proc., SPE Americas Unconventional Resources Conf., Society of Petroleum Engineers, Texas.
Holzman, D. C. (2011). “Methane found in well water near fracking sites.” Environ. Health Perspect., 119(7), a289.
Howarth, R. W., Ingraffea, A., and Engelder, T. (2011). “Natural gas: Should fracking stop?” Nature, 477(7364), 271–275.
Ito, K., and Seol, Y. (2003). “A 3-Dimensional discrete fracture network generator to examine fracture-matrix interaction using TOUGH2.” Proc., TOUGH Symp., Lawrence Berkeley National Laboratory, Berkeley, CA, 12–14.
Kerr, R. A. (2010). “Natural gas from shale bursts onto the scene.” Science, 328(5986), 1624–1626.
Kiryukhin, A., Miroshnik, O., Maguskin, M., and Delemen, I. (2013). “Modeling and observations of the enthalpy, pressure, chloride, and vertical deformation transient change in the mutnovsky geothermal field (Kamchatka, Russia).” Proc., 38th Workshop on Geothermal Reservoir Engineering, Stanford University, Stanford, CA.
Kranzz, R., Frankel, A., Engelder, T., and Scholz, C. (1979). “The permeability of whole and jointed Barre granite.” Int. J. Rock. Mech. Min. Sci. Geomech. Abstr., 16(4), 225–234.
Kumamotoa, Y., Itoia, R., Tanakaa, T., and Hazamab, Y. (2009). “Modeling and numerical analysis of the two-phase geothermal reservoir at Ogiri, Kyushu, Japan.” Proc., 34th Workshop on Geothermal Reservoir Engineering, Stanford University, Stanford, CA.
Li, Y., Cheng, Y., and Meng, Y. (2008). “Monitor and control technology of downhole explosion in air drilling.” Nat. Gas Ind., 5(23), 50–52.
Lipson, D. S., Kueper, B. H., and Gefell, M. J. (2005). “Matrix diffusion-derived plume attenuation in fractured bedrock.” Ground Water, 43(1), 30–39.
Lomize, G. (1961). Filtrarsiia v Treshchinovatykh Porod [Water flow in jointed rock], Gosenergoizdat, Moscow (in Russian).
McCray, J. E., and Falta, R. W. (1997). “Numerical simulation of air sparging for remediation of NAPL contamination.” Ground Water, 35(1), 99–110.
Mongano, G., et al. (1999). Geology of the ECRB cross drift-exploratory studies facility, Yucca Mountain Project, Yucca Mountain, Nevada, Bureau of Reclamation and USGS, Denver, CO.
Mualem, Y. (1976). “A new model for predicting the hydraulic conductivity of unsaturated porous media.” Water Resour. Res., 12(3), 513–522.
North Carolina Division of Water Resources (NCDWR). (2013). “Air rotary.” 〈http://www.ncwater.org/Education_and_Technical_Assistance/Ground_Water/Network/Well_Construction/air.php〉 (Jun. 18, 2013).
Osato, K., Ujo, S., and White, S. (2003). “Prediction of formation equilibrium temperature while drilling based on drilling mud temperature: inverse problem using TOUGH2 and wellbore thermal model.” Proc., TOUGH Symp., Lawrence Berkeley National Laboratory, Berkeley, CA, 12–14.
Osborn, S. G., Vengosh, A., Warner, N. R., and Jackson, R. B. (2011). “Methane contamination of drinking water accompanying gas-well drilling and hydraulic fracturing.” PNAS, 108(20), 8172–8176.
Pruess, K. (1985). “A practical method for modeling fluid and heat flow in fractured porous media.” Old SPE J., 25(1), 14–26.
Pruess, K. (1991). TOUGH2: A general-purpose numerical simulator for multiphase fluid and heat flow, Lawrence Berkeley Laboratory, Berkeley, CA.
Pruess, K. (2010). GMINC-A mesh generator for flow simulations in fractured reservoirs, Lawrence Berkeley National Laboratory, Berkeley, CA.
Pruess, K., and Narasimhan, T. (1982). “On fluid reserves and the production of superheated steam from fractured, vapor-dominated geothermal reservoirs.” J. Geophys. Res. Solid Earth (1978–2012), 87(B11), 9329–9339.
Raven, K., Novakowski, K., and Lapcevic, P. (1988). “Interpretation of field tracer tests of a single fracture using a transient solute storage model.” Water Resour. Res., 24(12), 2019–2032.
Reitsma, S., and Kueper, B. H. (1994). “Laboratory measurement of capillary pressure-saturation relationships in a rock fracture.” Water Resour. Res., 30(4), 865–878.
Rutqvist, J., Wu, Y. S., Tsang, C. F., and Bodvarsson, G. (2002). “A modeling approach for analysis of coupled multiphase fluid flow, heat transfer, and deformation in fractured porous rock.” Int. J. Rock Mech. Min. Sci., 39(4), 429–442.
Schmidt, R., Gudbjerg, J., Sonnenborg, T. O., and Jensen, K. H. (2002). “Removal of NAPLs from the unsaturated zone using steam: prevention of downward migration by injecting mixtures of steam and air.” J. Contam. Hydrol., 55(3), 233–260.
Schrauf, T., and Evans, D. (1986). “Laboratory studies of gas flow through a single natural fracture.” Water Resour. Res., 22(7), 1038–1050.
Soeder, D. J. (2012). “Shale gas development in the United States.” Advances in natural gas technology, H. A. Al-Megren, ed., InTech, Rijeka, Croatia, 1–28.
Stamm, N. (2012). “Geologic names and paleontologic databases (GEOLEX).” National Geologic Map Database, U.S. Geological Survey, Reston, VA.
Tomlinson, D., Thomson, N., Johnson, R., and Redman, J. (2003). “Air distribution in the Borden aquifer during in situ air sparging.” J. Contam. Hydrol., 67(1), 113–132.
Tour, J. M., Kittrell, C., and Colvin, V. L. (2010). “Green carbon as a bridge to renewable energy.” Nature Mater., 9(11), 871–874.
Tsang, Y., and Witherspoon, P. (1981). “Hydromechanical behavior of a deformable rock fracture subject to normal stress.” J. Geophys. Res., 86(B10), 9287–9298.
Tsang, Y. W., and Tsang, C. (1987). “Channel model of flow through fractured media.” Water Resour. Res., 23(3), 467–479.
van Genuchten, M. T. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
Whiteley, M., and England, W. (1986). “Air drilling operations improved by percussion-bit/hammer-tool tandem.” SPE Drill. Eng., 1(5), 377–382.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 140 • Issue 5 • May 2014
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Mar 21, 2013
Accepted: Jul 17, 2013
Published online: Jul 25, 2013
Published in print: May 1, 2014
Discussion open until: Jun 14, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.