Role of Mixing Energy in the Flocculation of Mature Fine Tailings
Publication: Journal of Environmental Engineering
Volume 138, Issue 1
Abstract
High-molecular-weight polymer flocculants are used for accelerated dewatering of mature fine tailings (MFTs) to reclaim the land occupied by containment ponds. Two anionic polymers were used to flocculate an MFT sample containing 98% by weight of fines smaller than 44 μm in diameter, with 85% of this fraction being clay minerals. The polymer solutions and polymer-treated MFT followed the Herschel-Bulkley and Bingham equations of state, respectively. The coupling of shear thinning and structural breakdown of the flocculated MFT gave rise to cavern formation during mixing. The mixing energy input for a series of MFT flocculation tests, in which other conditions were held constant, was proportional to the mixing time. The mixing tools used for the flocculation process were a Rushton turbine (RT), a pitched-blade turbine (PBT), a vane, and hydrofoil impellers. The flocculation outcome was evaluated on the basis of the amount of water released and the capillary suction test time (CST). The CST of the treated MFT was inversely proportional to its water release volume in settling columns. There was a clear peak in the rate of water release and a minimum in the CST as a function of mixing time, clearly showing that there is an optimal mixing energy that corresponds to the most rapid dewatering of flocculated MFT.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Funding for this work was provided by the Canadian Program for Energy Research and Development (PERD).
References
ASCE and American Water Works Association (AWWA)., (2005). Water treatment plant design, 4th Ed., McGraw-Hill, New York.
ASTM. (1984). “Standard test method for methylene blue index of clay.” ASTM C837, West Conshohocken, PA.
ASTM. (2004). “Standard test method for particle-size analysis of soils.” ASTM D422, West Conshohocken, PA.
Bailey, S. W. (1980). “Summary of recommendations of AIPEA Nomenclature Committee on clay minerals.” Am. Mineral., 15(1), 85–93.
Bouyer, D., Coufort, C., Line, A., and Do-Quang, Z. (2005). “Experimental analysis of floc size distributions in a 1-L jar under different hydrodynamics and physicochemical conditions.” J. Colloid Interface Sci., 292(2), 413–428.
Chapple, D., Kresta, S. M., Wall, A., and Afacan, A. (2002). “The effect of impeller and tank geometry on power number for pitched blade turbine.” Chem. Eng. Res. Des., 80(4), 364–372.
Dean, E. W., and Stark, D. D. (1920). “A convenient method for the determination of water in petroleum and other organic emulsions.” J. Ind. Eng. Chem. (Washington, D.C.), 12(5), 486–490.
Demoz, A., Munoz, V., and Mikula, R. J. (2011). “Thin lift dewatering of oil sands tailings: Optimizing fluid fine tailings dewatering by controlling polymer mixing.” Proc., World Heavy Oil Congress.
Dobias, B., ed. (1993). Coagulation and flocculation: Theory and applications, Dekker, New York.
Espinosa-Solares, T., Brito-de la Feuente, E., Tacante, A., and Tanguy, P. A. (2002). “Mixing time in rheologically evolving model fluids by hybrid dual mixing systems.” Chem. Eng. Res. Des., 80(8), 817–823.
Farinato, R. S., and Dubin, P. L. (1999). Colloid-polymer interactions, from fundamentals to practice, Wiley, Chichester, UK.
Galindo, E., and Nienow, A. W. (1992). “Mixing of highly viscous simulated Xanthan fermentation broths with the Lightnin A315 impeller.” Biotechnol. Prog., 8(3), 233–239.
Gray, M., Xu, Z., and Masliya, J. (2009). “Physics in the oil sands of Alberta.” Phys. Today, 62(3), 31–35.
Gregory, J. (1989). “Fundamentals of flocculation.” Crit. Rev. Environ. Control, 19(3), 185–230.
Heath, A. R., Bahri, P. A., Fawell, P. D., and Farrow, J. B. (2006). “Polymer flocculation of calcite: Experimental results from turbulent pipe flow.” AIChE J., 52(4), 1284–1293.
Hogg, R. (2000). “Flocculation and dewatering.” Int. J. Miner. Process., 58(1–4), 223–226.
Jillavenkatesa, A., Dapkunas, S. J., and Lum, H. L. (2001). “Particle size characterization: Recommended practice guide.” NIST Special Publication 960-1, NIST, Gaithersburg, MD.
Judd, S. J., and Fawcett, N. (1999). “Flocculation modeling: A review.” Water Res., 33(7), 1579–1592.
Kamiwano, M., Saito, F., and Kaminoyama, M. (1990). “Velocity distribution and apparent viscosity of a pseudo-plastic liquid in a stirred vessel.” Int. Chem. Eng., 30(4), 274–280.
Langer, S. J., and Klute, R. (1993). “Rapid mixing in sludge conditioning with polymers.” Water Sci. Technol., 28(1), 233–242.
Larson, R. G. (1999). The structure and rheology of complex fluids, Chapter 3, Oxford University Press, New York.
Luckham, P. F., and Ross, S. (1999). “The colloidal and rheological properties of bentonite suspensions.” Adv. Colloid Interface Sci., 82(1–3), 43–92.
Macosko, C. W. (1994). Rheology: Principles, measurements and applications, Wiley, Poughkeepsie, NY.
Masliyah, J. H., Zhou, Z. J., Xu, Z., Czarnecki, J., and Hamza, H. A. (2008). “Understanding water-based bitumen extraction from Athabasca oil sands.” Can. J. Chem. Eng., 82, 625–864.
McFarlane, A., Bremmell, K., and Addai-Mensah, J. (2006). “Improved dewatering behavior of clay minerals dispersions via interfacial chemistry and particle interactions optimization.” J. Colloid Interf. Sci., 293(1), 116–127.
Meeten, G. H., and Smeulders, J. B. A. F. (1995). “Interpretation of filterability measured by the capillary suction time method.” Chem. Eng. Sci., 50(8), 1273–1279.
Mikula, R. J., Kasperski, K. L., Burns, R. D., and Mackinnon, M. D. (1996). “Nature and fate of oil sands fine tailings.” Adv. Chem. Ser., 251, 677.
Moudgil, B. M., and Somasundaran, P., eds. (1988). Flocculation, sedimentation and consolidation, American Institute of Chemical Engineers (AIChE), New York.
Moudgil, B. M., and Somasundaran, P., eds. (1994). Dispersion and aggregation: Fundamentals and applications, American Institute of Chemical Engineers (AIChE), New York.
Nienow, A. W. (1998). “Hydrodynamics of stirred bioreactors.” Appl. Mech. Rev., 51(1), 3–32.
Owen, A. T., Fawell, P. D., Swift, J. D., Labbett, D. M., Benn, F. A., and Farrow, J. B. (2008). “Using turbulent pipe flow to study the factors affecting polymer-bridging flocculation of mineral systems.” Int. J. Miner. Process., 87(3–4), 90–99.
Paul, E. L., Atiemo-Obeng, V. A., and Kresta, S. M., eds. (2004). Handbook of industrial mixing, Wiley Interscience, Hoboken, NJ.
Pelssers, E. G. M., Stuart, M. A. C., and Fleer, G. J. (1989). “Kinetic aspects of polymer bridging: Equilibrium flocculation and nonequilibrium flocculation.” Colloids Surf., 38(1), 15–25.
Perry, H. R., and Green, D. W. (1997). Perry’s chemical engineering handbook, 7th Ed., McGraw-Hill, New York.
Phelps, G. W., Maguire, S. G., Kelly, W. J., and Wood, R. K. (1983). Rheology and rhoemtery of clay-water systems, Cyprus Industrial Minerals, Sanderville, GA.
Rattanakawan, C., and Hogg, R. (2000). “Aggregate size distribution in flocculation.” Colloids Surf., A, 177(2–3), 87–98.
Reynolds, T. D., and Richards, P. A. (1996). Unit operation and processes in environmental engineering, PWS, Boston.
Scholz, M. (2006). “Revised capillary suction time (CST) test to reduce consumable costs and improve dewaterability interpretation.” J. Chem. Technol. Biotechnol., 81(3), 336–344.
Sworska, A., Laskwski, J. S., and Cymerman, G. (2000). “Flocculation of the Syncrude fine tailings: Part II. Effect of hydrodynamic conditions.” Int. J. Miner. Process., 60(2), 153–161.
Van Olphen, H. (1977). An introduction to clay colloid chemistry, 2nd Ed., Krieger, Malabar, FL.
Wang, J. J., Feng, L. F., Gu, X. P., Wang, K., and Hu, C. H. (2000). “Power consumption of inner-outer helical ribbon impellers in viscous Newtonian and non-Newtonian fluids.” Chem. Eng. Sci., 55(12), 2339–2354.
Wichterle, K., and Wein, O. (1981). “Threshold of mixing of non-Newtonian fluids.” Int. Chem. Eng., 21, 116–120.
Xu, Y., Dabros, T., and Kan, J. (2008). “Filterability of oil sand tailings.” Process Saf. Environ. Prot., 86(4), 268–276.
Yeung, A., Gibbs, A., and Pelton, R. (1997). “The effect of shear on polymer-induced flocs.” J. Colloid Interface Sci., 196(1), 113–115.
Zbik, M., and Horn, R. G. (2003). “Hydrophobic attraction may contribute to aqueous flocculation of clays.” Colloids Surf., A, 222(1–3), 323–328.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 138 • Issue 1 • January 2012
Pages: 129 - 136
Copyright
© 2012 American Society of Civil Engineers.
History
Received: May 28, 2010
Accepted: Jun 29, 2011
Published online: Jul 1, 2011
Published in print: Jan 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.