Building Rectification by Underexcavation and Practical Design Method
Publication: Journal of Performance of Constructed Facilities
Volume 36, Issue 6
Abstract
An 11-story high-rise building with a shear-wall structure utilized a raft foundation based on a deep alluvial deposit. After structure completion, the building tilted beyond acceptable limits. This paper presents the investigation, settlement analysis, building rectification, and foundation remediation. The purpose of this study is to provide a common method of addressing similar problems and propose two formulas to guide design. First, through site investigation and settlement reanalysis, it was determined that the large settlement and building eccentricity accounted for the building tilt. Second, underexcavation was used for the side with less subsidence to address the building differential settlement, and precast micropiles were driven into the foundation to improve foundation safety. Finally, two formulas for underexcavation were proposed to apply to general rectification projects. A simplified analysis method was adopted for formula derivation. In accordance with the force balance in the foundation soil before and after underexcavation, the preferable hole spacing could be expressed as a multiple of the hole diameter, i.e., , which mainly depends on the safety factor of the bearing capacity of the foundation soil. Assuming that the extraction volume of soil equals the forced settlement volume for inclination correction, the diameter of the hole is obtained, i.e., , which mainly depends on the proposed forced settlement. The key parameters were verified by the case history. The case history and practical design method provide a framework for projects experiencing differential settlement.
Practical Applications
Buildings sometimes incline. Reasons for the inclination are various, such as severe foundation settlement, surrounding underground construction, neighboring foundation pit excavation, and underground water drainage. Underexcavation is a cost-effective and “soft” method of rectifying buildings. It is suitable for buildings with shallow foundations. This paper presents a case history, and theoretical formulas for underexcavation design are proposed. In the case study, the methods of investigating and analyzing building inclination and the technology of inclination correction can provide valuable references for similar projects. The theoretical formulas can provide the key parameters of limit hole spacing and hole diameter for a correction design and enable a designer to quickly give a correction scheme for general conditions. For specific projects, appropriate adjustments should be made according to geotechnical conditions, the surrounding environment, and the suitability of construction. Notably, even with the formulas to guide design and construction, in view of the complexity of geological issues, close monitoring is still essential.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The authors acknowledge the financial support provided by the National Natural Science Foundation of China for Major Projects (No. 52038006) and Shandong Jianzhu University Engineering Appraisal and Reinforcement Design Co., Ltd. for School-Company Cooperation Project (No. H19233z).
References
Akbas, S. O., and F. H. Kulhawy. 2009. “Drained soil modulus from load tests for shallow foundation design.” In Contemporary topics in ground modification, problem soils, and geo-support, 449–456. Reston, VA: ASCE. https://doi.org/10.1061/41023(337)57.
Anderson, J. B., F. C. Townsend, and L. Rahelison. 2007. “Load testing and settlement prediction of shallow foundation.” J. Geotech. Geoenviron. Eng. 133 (12): 1494–1502. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:12(1494).
Bedenis, T. H., M. J. Thelen, and S. Maranowski. 2004. “High capacity micro piles for utility retrofit: A case history at DE Karn power plant in Bay City, Michigan.” In Proc., GeoSupport 2004: Drilled Shafts, Micropiling, Deep Mixing, Remedial Methods, and Specialty Foundation Systems, 662–673. Reston, VA: ASCE.
Budhu, M. 2010. Soil mechanics and foundations. 3rd ed. New York: Wiley.
Burland, J. B., M. B. Jamiolkowski, and C. Viggiani. 2015. “Underexcavating the Tower of Pisa: Back to future.” Geotech. Eng. J. SEAGA AGSSEA 46 (4): 126–135.
Chen, W., and X. Zhao. 2009. “Influence of superstructure stiffness on performance of box foundation.” [In Chinese.] Build. Struct. 39 (8): 99–102.
Foye, K. C., R. Salgado, and B. Scott. 2006. “Resistance factors for use in shallow foundation LRFD.” J. Geotech. Geoenviron. Eng. 132 (9): 1208–1218. https://doi.org/10.1061/(ASCE)1090-0241(2006)132:9(1208).
Gong, J. F., G. Y. Hou, S. B. Zhou, and W. H. Zheng. 2014. “Settlement characteristics and calculation of bending moment for large-area thick raft foundation under tall buildings.” Chin. J. Geotech. Eng. 36 (9): 1631–1639. https://doi.org/10.11779/CJGE201409009.
Gong, J. F., J. L. Shi, H. B. Zhu, and S. B. Zhou. 2012. “In-situ tests on settlement of large-area thick raft foundation under tall buildings.” [In Chinese.] Chin. J. Geotech. Eng. 34 (6): 1088–1093.
Hansen, B. J. 1970. A revised and extended formula for bearing capacity. Copenhagen, Denmark: Danish Geotechnical Institute.
Hooper, J. A. 1973. “Observations on the behaviour of a pile-raft foundation on London clay.” Proc. Inst. Civ. Eng. 55 (4): 855–877. https://doi.org/10.1680/iicep.1973.4144.
Johnston, G., and J. Burland. 2001. “An early example of the use of under excavation to stabilize the Tower of St Chad, Wybunbury in 1832.” Accessed September 3, 2021. https://www.researchgate.net/publication/237678149.
Liang, Y. G., Y. X. Zhang, and Z. Y. Tian. 2017. “A case for reinforcement and inclination rectification of high-rise shear wall residential building.” Archit. Technol. 48 (12): 1306–1308. https://doi.org/10.3969/j.issn.1000-4726.2017.12.022.
Meyerhof, G. G. 1963. “Some recent research on the bearing capacity of foundations.” Can. Geotech. J. 1 (1): 16–26. https://doi.org/10.1139/t63-003.
Ministry of Housing and Urban-Rural Development of the People’s Republic of China & General Administration of Quality Supervision, Inspection and Quarantine of the People’s Republic of China. 2011. Code for design of building foundation. GB 50007-2011. Beijing: China Architecture & Building Press.
Moghaddam, R. B., and P. W. Jayawickrama. 2015. “Use of sub-excavation method for foundation remediation: A case study.” In Proc., Int. Conf. Geotechnical Engineering (ICGE-2015). Colombo, Sri Lanka: ICGE.
Ovando-Shelley, E., and E. Santoyo. 2001. “Underexcavation for leveling buildings in Mexico City: Case of the Metropolitan Cathedral and the Sagrario Church.” J. Archit. Eng. 7 (3): 61–70. https://doi.org/10.1061/(ASCE)1076-0431(2001)7:3(61).
Rojas, E., and M. P. Romo. 1994. Comportamiento de una probeta cilíndrica con perforación central y su aplicación al procedimento de subexcavación (Behavior of a cylindrical specimen with a central borehole and its application to the underexcavation procedure). México City: Universidad Nacional Autónoma de México.
Srinivasan, S., A. J. Muck, and A. P. Bodocsi. 2011. “Use of settlement reducing auger cast-in-place pile below a mat foundation.” In Proc., Geo-Frontiers 2011 Advances in Geotechnical Engineering, 192–201. Reston, VA: ASCE. https://doi.org/10.1061/41165(397)21.
Sun, J. P., J. H. Xiao, and Q. P. Wang. 2017. “Settlement of composite foundation—A case history with reinforcement of steel pipe micro-pile.” Eng. Technol. Innovation 1 (1): 109–112. https://doi.org/10.26480/iceti.01.2017.109.112.
Terracina, F. 1962. “Foundations of the tower of pisa.” Géotechnique 12 (4): 336–339. https://doi.org/10.1680/geot.1962.12.4.336.
Terzaghi, K., and R. B. Peck. 1948. Soil mechanics in engineering practice. New York: Wiley.
Tu, J. S., Z. Li, and H. Y. Ge. 2015. “The FEM analysis with considering interaction on raft foundation of high-rise building.” [In Chinese.] J. Longdong Univ. 26 (1): 60–63. https://doi.org/10.3969/j.issn.1674-1730.2015.01.017.
Vesic, A. S. 1973. “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. Found. Div. 99 (SM1): 45–73. https://doi.org/10.1016/0148-9062(74)90598-1.
Wei, H., J. Sun, Q. Chen, and Z. Jiang. 2005. “Causes and dewatering correction of a 120 meter-high inclined chimney and its effect.” Archit. Technol. 36 (6): 425–427. https://doi.org/10.3969/j.issn.1000-4726.2005.06.007.
Wen, L., G. Kong, H. Abuel-Naga, Q. Li, and Z. Zhang. 2020. “Rectification of tilted transmission tower using micropile underpinning method.” J. Perform. Constr. Facil. 34 (1): 04019110. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001398.
Wong, I. H., I. K. Ooi, and B. B. Broms. 1996. “Performance of raft foundations for high-rise buildings on the Bouldery Clay in Singapore.” Can. Geotech. J. 33 (2): 219–236. https://doi.org/10.1139/t96-002.
Xiao, J. H., J. P. Sun, X. Zhang, and Q. X. Yue. 2022. “Mechanism of underexcavation and practical design method for building rectification.” SN Appl. Sci. 4 (4): 103. https://doi.org/10.1007/s42452-022-04993-2.
Zhang, L., and A. M. Y. Ng. 2007. “Limiting tolerable settlement and angular distortion for building foundations.” In Probabilistic applications in geotechnical engineering, 1–11. Reston, VA: ASCE. https://doi.org/10.1061/40914(233)18.
Zhou, M., X. Su, J. Lei, and S. Fang. 2020. “Foundation reinforcement and deviation rectification of the leaning pagoda of Dinglin Temple, China.” Proc. Inst. Civ. Eng. Geotech. Eng. 173 (6): 473–484. https://doi.org/10.1680/jgeen.19.00028.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Feb 3, 2022
Accepted: Jul 21, 2022
Published online: Sep 26, 2022
Published in print: Dec 1, 2022
Discussion open until: Feb 26, 2023
ASCE Technical Topics:
- Building design
- Buildings
- Case studies
- Design (by type)
- Differential settlement
- Engineering fundamentals
- Foundation design
- Foundation settlement
- Foundations
- Geomechanics
- Geotechnical engineering
- Methodology (by type)
- Research methods (by type)
- Soil dynamics
- Soil mechanics
- Soil settlement
- Structural engineering
- Structural settlement
- Structures (by type)
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.