Blast-Resistant Window Anchors. I: Experimental Investigation
Publication: Journal of Performance of Constructed Facilities
Volume 37, Issue 2
Abstract
A comprehensive experimental investigation was conducted on blast-resistant window anchors involving 46 tests of double-pane insulated glass units (IGUs) anchored to structural steel, reinforced concrete, concrete block masonry, and stone masonry substrates. The tests were conducted using a shock tube. The windows were glazed with security films of different thickness. Different number and spacing of steel anchors were used to secure the window frames to substrates. Each window was subjected to two levels of blast loads, consisting of 28 kPa, 207 kPa-ms, and 69 kPa, 621 kPa-ms reflected pressure–impulse combinations. The windows were instrumented to measure anchor forces. The anchors developed out-of-plane shear forces and in-plane axial tension associated with postbreak membrane action. The results indicate that anchor shear forces show variations with window stiffness, substrate type, and anchor arrangements, often developing lower forces than those computed based on the static application of blast loads, indicating significant inertia resistance. Rigid substrates produce higher anchor forces. In addition to the experimental results, the paper presents single-degree-of-freedom analysis results for anchor force computation, indicating good correlations with experimental data.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data that support the findings of this study are available from the corresponding author upon reasonable request. The data available include pressure-time distributions for each test reported, displacement time histories recorded on selected window anchors, and analytical predictions using SDOF dynamic analysis.
Acknowledgments
The research program that forms the basis for this paper was funded by the Canadian Safety and Security Program of Defence Research and Development Canada (DRDC) under Grant No. EJ116-151018-001/sv. The shock tube used in the experimental research program was purchased through a grant from the Canada Foundation for Innovation (CFI) under Grant No. 15232.
References
Abrishami, H. H., and D. Mitchell. 1996. “Analysis of bond stress distributions in pullout specimens.” J. Struct. Eng. 122 (3): 255–261. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:3(255).
ACI (American Concrete Institute). 2019. Building code requirements available for public review. ACI 318-19. Farmington Hills, MI: ACI.
Alameer, A. 2020. “Window retention anchors in blast-resistant windows.” Ph.D. dissertation. Dept. of Civil Engineering, Univ. of Ottawa.
ARA (Applied Research Associates Inc.). 2005. Window glazing analysis response & design—WINGARD—Technical manual. ARA-TR-05-16462-2. Washington, DC: US General Services Administration.
ASCE. 2011. Blast protection of buildings. ASCE/SEI 59-11. Reston, VA: ASCE.
Bangash, M. Y. H., and T. Bangash. 2006. Explosion resistant buildings. New York: Springer.
Biggs, J. M. 1964. Introduction to structural dynamics. New York: McGraw-Hill.
CSA (Canadian Standards Association). 2012. Design and assessment of buildings subjected to blast loads. CSA S850-12. Mississauga, ON, Canada: CSA.
CSA (Canadian Standards Association). 2018. Blast-resistant window anchor systems. CSA S852-18. Mississauga, ON, Canada: CSA.
CSA (Canadian Standards Association). 2019. Design of concrete structures. CSA A23.3-19. Mississauga, ON, Canada: CSA.
Dussenberry, D. 2010. Handbook for blast-resistant design of buildings. New York: Wiley.
Eligehausen, R., and W. Fuchs. 1988. “Load-bearing behavior of anchor fastenings under shear, combined tension and shear or flexural loading.” Betonwerk Fertigteil Tech. 54 (Feb): 48–56.
GSA (General Services Administration). 2003. Standard test method for glazing and window systems subject to dynamic overpressure loadings. Washington, DC: US General Services Administration.
Hao, H., and X. Zhang. 2015. “Analysis and design of glass windows against blast and impact loads.” In Proc., 11th Int. Conf. on Shock and Impact Loads on Structures, 1–15. Orchard Plaza, Singapore: CI-Premier PTE.
Klingner, R. E., and J. A. Mendonca. 1982. “Shear capacity of short anchor bolts and welded studs—A literature review.” ACI J. 79 (5): 339–349.
Krauthammer, T. 2008. Modern protective structures. Boca Raton, FL: CRC Press.
Lloyd, A. 2010. “Performance of reinforced concrete columns under shock tube induced shock wave loading.” Master’s thesis, Dept. of Civil Engineering, Univ. of Ottawa.
Lotze, D., R. E. Klingner, and H. L. Graves. 2001. “Static behavior of anchors under combinations of tension and shear loading.” ACI Struct. J. 98 (4): 525–536.
Mays, G. C., and P. D. Smith. 2003. Blast effects on buildings—Design of buildings to optimize resistance to blast loading. London: Thomas Telford.
Morison, C. 2007. “The resistance of laminated glass to blast pressure loading and the coefficients for single degree of freedom analysis of laminated glass.” Ph.D. thesis, Defence College of Management and Technology, Defense Academy of the United Kingdom.
Saatcioglu, M., and E. Contastabile. 2015. Review of literature on blast resistant window anchor systems. Ottawa: Public Works and Government Services Canada.
Smith, J. L. 2003. Anti-terrorism: Criteria, tools and technology. Vicksburg, MS: Applied Research Associates.
Smith, J. L., and N. A. Renfroe. 2010. Glazing hazard mitigation. Washington, DC: National Institute of Building Science.
Timoshenko, S. P. 1940. Theory of plates and shells. New York: McGraw-Hill.
Uddin, N. 2010. Blast protection of civil infrastructures and vehicles using composite. Boca Raton, FL: CRC Press.
Vallabhan, C. V. G. 1983. “Iterative analysis of nonlinear glass plates.” J. Struct. Eng. 109 (2): 489–502. https://doi.org/10.1061/(ASCE)0733-9445(1983)109:2(489).
Ward, S. P., and B. Jordan. 2006. “Anchoring blast resistant windows.” Accessed January 14, 2020. https://aees.org.au/wp-content/uploads/2013/11/20-Jordan.pdf.
Weissman, S., N. Dobbs, W. Stea, and P. Price. 1978. Blast capacity evaluation of glass windows and aluminum window frames. Fort Belvoir, VA: Defense Technical Information Center.
Information & Authors
Information
Published In
Journal of Performance of Constructed Facilities
Volume 37 • Issue 2 • April 2023
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Jul 30, 2021
Accepted: Jun 13, 2022
Published online: Jan 10, 2023
Published in print: Apr 1, 2023
Discussion open until: Jun 10, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.