Investigation of Cracks Observed in Underwater Bridge Seal Structures and Crack Control by Means of Material Design
Publication: Journal of Performance of Constructed Facilities
Volume 34, Issue 6
Abstract
A large number of cracks were observed in a bridge seal structure during an underwater inspection. The seal is long, wide, and deep and thus is considered mass concrete. The concrete mixture contains a 45% cement replacement with Class F fly ash. The seal is evaluated to identify the causes of cracking. The heat of hydration (HoH) and temperature rise are experimentally evaluated. Subsequently, a finite-element analysis model is developed using input from the experimental study. The modeling approach is validated with results from sizeable specimens. A coupled thermal-structural analysis is performed to evaluate the temperature-time history and extent of cracking. The results indicate internal temperature in the seal slightly exceeds the allowable temperature of 70°C, which is known for exposing concrete to the risk of delayed ettringite formation. The gradient temperature exceeds the allowable limit of 19.4°C, leading to increased tensile strain. A sensitivity analysis indicates that two mixtures that contain a 70% cement replacement with slag, metakaolin, and/or fly ash are recommended for reducing the internal temperature below 70°C. However, it is concluded that the differential temperature requirement (19.4°C) cannot be met by altering material designs alone. Therefore, active cooling is necessary to control temperature when placing underwater seal structures with a volume-to-surface-area ratio greater than 4.0.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All photos, construction drawings, FEA models, and analysis output data that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The study presented in this paper was conducted by the University of Georgia under the auspices of the Georgia DOT (RP 16-30). The authors extend our sincere appreciation to Georgia DOT research staff and materials engineers. The opinions, findings, and conclusions may not reflect the views of the funding agency or other individuals.
References
ACI (American Concrete Institute). 1997. Mass concrete. ACI 207.1R-96. Farmington Hills, MI: ACI.
ACI (American Concrete Institute). 2007a. Causes, evaluation, and repair of cracks in concrete structures. ACI 224R-07. Farmington Hills, MI: ACI.
ACI (American Concrete Institute). 2007b. Report on thermal and volume change effects on cracking of mass concrete. ACI 207.2R-07. Farmington Hills, MI: ACI.
ACI (American Concrete Institute). 2016. Specifications for structural concrete. ACI 301-16. Farmington Hills, MI: ACI.
Bažant, Z. P., M. F. Kaplan, and Z. P. Bazant. 1996. Concrete at high temperatures: Material properties and mathematical models. London: Addison-Wesley.
Chorzepa, M. G., S. A. Durham, and H. Hamid. 2019. Phase-II evaluation of metakaolin for GDOT concrete specifications (ASTM C618 N pozzolan) and mass concrete provision. Atlanta: Georgia DOT.
Diamond, S. 1996. “Delayed ettringite formation—Processes and problems.” Cem. Concr. Compos. 18 (3): 205–215. https://doi.org/10.1016/0958-9465(96)00017-0.
DIANA FEABV (DIsplacement ANAlyzer Finite Element Analysis). 2017. DIANA finite element analysis user’s manual, release, 10.6. Delft, Netherlands: DIANA FEABV.
fib (International Federation for Structural Concrete). 2013. fib model code for concrete structures 2010. Lausanne, Switzerland: fib.
Gadja, J., and E. Alsamsam. 2006. Engineering mass concrete structures. New York: Portland Cement Association.
Gajda, J., M. Weber, and I. Diaz-Loya. 2014. “A low temperature rise mixture for mass concrete.” Concr. Int. 36 (8): 48–53.
Georgia DOT (Georgia Department of Transportation). 2013. Special provision. Atlanta: Georgia DOT.
Hamid, H. 2019. “Coupling of thermal and structural analysis towards autonomous designing of massive concrete structures and recognizing sustainable alternative materials including metakaolin.” Ph.D. dissertation, Dept. of Civil Engineering, Univ. of Georgia.
Hamid, H., and M. Chorzepa. 2020. “Quantifying maximum temperature in 17 mass concrete cube specimens made with mixtures including metakaolin and/or slag.” Constr. Build. Mater. 252 (Aug): 118950. https://doi.org/10.1016/j.conbuildmat.2020.118950.
Hamid, H., M. G. Chorzepa, M. Sullivan, S. Durham, and S. S. Kim. 2018. “Novelties in material development for massive concrete structures: Reduction in heat of hydration observed in ternary replacement mixtures.” Infrastructures 3 (2): 8. https://doi.org/10.3390/infrastructures3020008.
Jung, S. H., Y. C. Choi, and S. Choi. 2017. “Use of ternary blended concrete to mitigate thermal cracking in massive concrete structures: A field feasibility and monitoring case study.” Constr. Build. Mater. 137 (Apr): 208–215. https://doi.org/10.1016/j.conbuildmat.2017.01.108.
Larosche, C. J. 2009. Types and causes of cracking in concrete structures. In failure, distress and repair of concrete structures, 57–83. Northbrook, IL: Woodhead Publishing.
Taylor, H., C. Famy, and K. Scrivener. 2001. “Delayed ettringite formation.” Cem. Concr. Res. 31 (5): 683–693. https://doi.org/10.1016/S0008-8846(01)00466-5.
Texas DOT (Texas Department of Transportation). 2019. “Engineering software: ConcreteWorks.” Accessed February 22, 2020. https://www.txdot.gov/inside-txdot/division/information-technology/engineering-software.external.html.
USGS. 2013. 2012–2013 minerals yearbook. Washington, DC: USGS.
USGS. 2019. “National water information system: Web interface.” Accessed November 2, 2019. https://nwis.waterdata.usgs.gov/nwis/.
Weather Underground. 2019. “Savannah, GA weather history.” Accessed November 2, 2019. https://www.wunderground.com/.
Zhao, D., X. Qian, X. Gu, S. A. Jajja, and R. Yang. 2016. “Measurement techniques for thermal conductivity and interfacial thermal conductance of bulk and thin film materials.” J. Electron. Packag. 138 (4): 040802. https://doi.org/10.1115/1.4034605.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Feb 28, 2020
Accepted: Jun 18, 2020
Published online: Sep 25, 2020
Published in print: Dec 1, 2020
Discussion open until: Feb 25, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.