Progressive Collapse Analysis of Three-Dimensional Steel–Concrete Composite Building due to Extreme Blast Load
Publication: Journal of Performance of Constructed Facilities
Volume 34, Issue 3
Abstract
This paper investigated the behavior of three-dimensional (3D) steel-concrete building under external explosion considering the slab and connection rigidity. Most of the work carried out so far in the progressive collapse area followed the threat-independent alternate load path (ALP) methodology as a design guide. This study presents a simplified two-stage nonlinear dynamic analysis using Abaqus FE. The number of columns likely to be removed in progressive collapse due to blast is determined using a three-step restart analysis in the first stage. Collapse analysis of the entire building is carried out in the second stage, and the results were compared with nonlinear dynamic analysis of the ALP. The numerical model was validated with the data obtained from experimental works and the results showed good agreement. It was concluded that the ALP usually is not conservative; more columns may be eliminated under heavy explosion, and collapse analysis is required to capture the real behavior. The well-known failure criteria for yielding, fracture, and stability are not efficient enough, and the damage index criterion which basically depends on the global column behavior and its remaining axial capacity should be used.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
References
Alashker, Y., S. El-Tawil, and F. Sadek. 2010. “Progressive collapse resistance of steel-concrete composite floors.” J. Struct. Eng. 136 (10): 1187–1196. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000230.
Alashker, Y., H. Li, and S. El-Tawil. 2011. “Approximations in progressive collapse modeling.” J. Struct. Eng. 137 (9): 914–924. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000452.
ANSI/AISC. 2005. Specifications for structural steel buildings. Chicago, IL: AISC.
Baker, W. E. 1973. Explosions in air. Austin, TX: University of Texas Press.
Bandyopadhyay, M., A. K. Banik, and K. D. Tushar. 2015. “Progressive collapse of three-dimensional semi-rigid jointed steel frames.” J. Perform. Constr. Facil. 30 (3): 04015051. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000796.
Elsanadedy, H. M., T. H. Almusallam, Y. R. Alharbi, Y. A. Al-Salloum, and H. Abbas. 2014. “Progressive collapse potential of a typical steel building due to blast attacks.” J. Constr. Steel Res. 101 (Oct): 143–157. https://doi.org/10.1016/j.jcsr.2014.05.005.
Frye, M. J., and G. A. Morris. 1975. “Analysis of flexibly connected steel frames.” Can. J. Civ. Eng. 2 (3): 280–291. https://doi.org/10.1139/l75-026.
Fu, F. 2009. “Progressive collapse analysis of high-rise building with 3-D finite element modeling method.” J. Constr. Steel Res. 65 (6): 1269–1278. https://doi.org/10.1016/j.jcsr.2009.02.001.
Fu, F. 2010. “3-D nonlinear dynamic progressive collapse analysis of multi-storey steel composite frame buildings-parametric study.” Eng. Struct. 32 (12): 3974–3980. https://doi.org/10.1016/j.engstruct.2010.09.008.
Fu, F. 2013. “Dynamic response and robustness of tall buildings under blast loading.” J. Constr. Steel Res. 80 (Jan): 299–307. https://doi.org/10.1016/j.jcsr.2012.10.001.
Galal, M. A., M. Bandyopadhyay, and A. K. Banik. 2018. “Vulnerability of three-dimensional semi-rigid composite frame subjected to progressive collapse.” J. Perform. Constr. Facil. 33 (3): 04019030. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001297.
Galal, M. A., M. Bandyopadhyay, and A. K. Banik. 2019, “Dual effect of axial tension force developed in catenary action during progressive collapse of 3D composite semi-rigid jointed frames.” In Structures, 507–519. Amsterdam, Netherlands: Elsevier.
Gerasimidis, S. 2014. “Analytical assessment of steel frames progressive collapse vulnerability to corner column loss.” J. Constr. Steel Res. 95 (Apr): 1–9. https://doi.org/10.1016/j.jcsr.2013.11.012.
Gerasimidis, S., and J. Sideri. 2016. “A new partial-distributed damage method for progressive collapse analysis of steel frames.” J. Constr. Steel Res. 119 (Mar): 233–245. https://doi.org/10.1016/j.jcsr.2015.12.012.
Gombeda, M. J., C. J. Naito, S. E. Quiel, and C. T. Fallon. 2014. “Blast-induced damage mapping framework for use in threat-dependent progressive collapse assessment of building frames.” J. Perform. Constr. Facil. 31 (2): 04016089. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000949.
GSA (General Services Administration). 2003. GSA guidelines for progressive collapse analysis. Washington, DC: Office of the Chief Architect.
Jama, H. H., M. R. Bambach, G. N. Nurick, R. H. Grzebieta, and X. Zhao. 2009. “Numerical modelling of square tubular steel beams subjected to transverse blast loads” Thin-Walled Struct. 47 (12): 1523–1534. https://doi.org/10.1016/j.tws.2009.06.004.
Jeyarajan, S., and J. Y. Richard. 2016. “Robustness analysis of 3D composite buildings with semi-rigid joints and floor slab.” Structures 6 (May): 20–29. https://doi.org/10.1016/j.istruc.2016.01.005.
Jeyarajan, S., J. Y. Richard, and C. G. Koh. 2015. “Analysis of steel-concrete composite buildings for blast induced progressive collapse.” Int. J. Protective Struct. 6 (3): 457–485. https://doi.org/10.1260/2041-4196.6.3.457.
Khandelwala, K., S. El-Tawila, and F. Sadek. 2006. “Progressive collapse analysis of seismically designed steel braced frames.” J. Constr. Steel Res. 65 (3): 699–708.
Kwasniewski, L. 2010. “Nonlinear dynamic simulations of progressive collapse for a multistory building.” Eng. Struct. 32 (5): 1223–1235. https://doi.org/10.1016/j.engstruct.2009.12.048.
Marjanishvili, S., and E. Agnew. 2006. “Comparison of various procedures for progressive collapse analysis” J. Perform. Constr. Facil. 20 (4): 365–374. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(365).
Mays, G. C., and P. D. Smith. 2001. Blast effects on buildings: Design of buildings to optimize resistance to blast loading. London: Tomas Telford.
McConnell, J. R., and H. Brown. 2011. “Evaluation of progressive collapse alternate load path analyses in designing for blast resistance of steel columns.” Eng. Struct. 33 (10): 2899–2909. https://doi.org/10.1016/j.engstruct.2011.06.014.
Ngo, T., P. Mendis, A. Gupta, and J. Ramsay. 2007. “Blast loading and blast effects on structures.” Int. Spec. Issue-Loading Struct. 7 (1): 76–91.
Pantidis, P., and S. Gerasimidis. 2017. “New Euler-type progressive collapse curves for steel moment-resisting frames: Analytical method.” J. Struct. Eng. 143 (9): 04017113. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001834.
Sadek, F., S. El-Tawil, and H. S. Lew. 2008. “Robustness of composite floor systems with shear connections: Modeling, simulation, and evaluation” J. Struct. Eng. 134 (11): 1717–1725. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:11(1717).
Serdar, A., T. Krauthammer, D. Morency, and P. T. Tran. 2013. “Behavior of reinforced concrete columns under combined effects of axial and blast-induced transverse loads.” Eng. Struct. 55 (Oct): 26–34.
Shi, Y., H. Hao, and Z. Li. 2008. “Numerical derivation of pressure–impulse diagrams for prediction of RC column damage to blast loads.” Int. J. Impact Eng. 35 (11): 1213–1227. https://doi.org/10.1016/j.ijimpeng.2007.09.001.
Shi, Y., Z. X. Li, and H. Hao. 2010. “A new method for progressive collapse analysis of RC frames under blast loading.” Eng. Struct. 32 (6): 1691–1703. https://doi.org/10.1016/j.engstruct.2010.02.017.
UFC (Unified Facilities Criteria). 2008. Structures to resist the effects of accidental explosions. UFC 3-340-02. Arlington, VA: US Dept. of Defense.
UFC (Unified Facilities Criteria). 2009. Design of buildings to resist progressive collapse. Washington, DC: US Dept. of Defense.
United States Department of the Army. 1986. Fundamentals of protective design for conventional weapons. TM 5-855-1. Washington, DC: United States Department of the Army.
Wang, J. F., and G. Q. Li. 2007. “Testing of semi-rigid steel–concrete composite frames subjected to vertical loads.” Eng. Struct. 29 (8): 1903–1916. https://doi.org/10.1016/j.engstruct.2006.10.014.
Zhang, D., S. J. Yao, F. Lu, X. G. Chen, G. Lin, W. Wang, and Y. Lin. 2013. “Experimental study on scaling of RC beams under close-in blast loading.” Eng. Fail. Anal. 33 (Oct): 497–504. https://doi.org/10.1016/j.engfailanal.2013.06.020.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: May 26, 2019
Accepted: Oct 11, 2019
Published online: Feb 27, 2020
Published in print: Jun 1, 2020
Discussion open until: Jul 27, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.