Progressive Collapse Analysis of Steel Moment Frames: An Energy-Based Method and Explicit Expressions for Capacity Curves
Publication: Journal of Performance of Constructed Facilities
Volume 33, Issue 2
Abstract
This paper presents a simplified model to evaluate progressive collapse response of steel beam–column substructures in a midspan column removal scenario. The model accounts for the influence of the span:depth ratio of the beam on progressive collapse behavior of substructures. The model was carefully validated against results obtained from rigorous numerical analyses. A single-story analogy was proposed to derive explicit expressions for progressive collapse–resisting capacity curves based on the energy conservation principle. The expressions covering the full range of loading—including interaction between the bending moments and beam axial load—and problem variables likely to be encountered in practice were derived. These explicit expressions can be applied in a step-by-step manner for tracing nonlinear behavior up to failure.
Get full access to this article
View all available purchase options and get full access to this article.
References
Abruzzo, J., A. Matta, and G. Panariello. 2006. “Study of mitigation strategies for progressive collapse of a reinforced concrete commercial building.” J. Perform. Constr. Facil. 20 (4): 384–390. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(384).
Asprone, D., F. Jalayer, A. Prota, and G. Manfredi. 2010. “Proposal of a probabilistic model for multi-hazard risk assessment of structures in seismic zones subjected to blast for the limit state of collapse.” Struct. Saf. 32 (1): 25–34. https://doi.org/10.1016/j.strusafe.2009.04.002.
Bažant, Z. P., and Y. Zhou. 2002. “Why did the world trade center collapse?—Simple analysis.” J. Eng. Mech. 128 (1): 2–6. https://doi.org/10.1061/(ASCE)0733-9399(2002)128:1(2).
Bažant, Z. P., J. L. Le, F. R. Greening, and D. B. Benson. 2008. “What did and did not cause collapse of World Trade Center Twin Towers in New York?” J. Eng. Mech. 134 (10): 892–906. https://doi.org/10.1061/(ASCE)0733-9399(2008)134:10(892).
Bažant, Z. P., and M. Verdure. 2007. “Mechanics of progressive collapse: Learning from World Trade Center and building demolitions.” J. Eng. Mech. 133 (3): 308–319. https://doi.org/10.1061/(ASCE)0733-9399(2007)133:3(308).
Brunesi, E., R. Nascimbene, F. Parisi, and N. Augenti. 2015. “Progressive collapse fragility of reinforced concrete framed structures through incremental dynamic analysis.” Eng. Struct. 104: 65–79. https://doi.org/10.1016/j.engstruct.2015.09.024.
Corley, W. G., P. F. M. Sr, M. A. Sozen, and C. H. Thornton. 1998. “The Oklahoma City bombing: Summary and recommendations for multihazard mitigation.” J. Perform. Constr. Facil. 12 (3): 100–112. https://doi.org/10.1061/(ASCE)0887-3828(1998)12:3(100).
Ding, Y., X. Song, and H. T. Zhu. 2017. “Probabilistic progressive collapse analysis of steel-concrete composite floor systems.” J. Constr. Steel Res. 129: 129–140. https://doi.org/10.1016/j.jcsr.2016.11.009.
DOD (Department of Defense). 2009. Unified facilities criteria (UFC): Design of buildings to resist progressive collapse. Washington, DC: DOD.
Dusenberry, D. O., and R. O. Hamburger. 2006. “Practical means for energy-based analyses of disproportionate collapse potential.” J. Perform. Constr. Facil. 20 (4): 336–348. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(336).
Elsanadedy, H. M., T. H. Almusallam, Y. R. Alharbi, Y. A. Al-Salloum, and H. Abbas. 2014. “Progressive collapse potential of a typical steel building due to blast attacks.” J. Constr. Steel Res. 101: 143–157. https://doi.org/10.1016/j.jcsr.2014.05.005.
FEMA. 2000. Commentary for the seismic rehabilitation of buildings. FEMA-356. Washington, DC: FEMA.
Grierson, D. E., M. Safi, L. Xu, and Y. Liu. 2005. “Simplified methods for progressive-collapse analysis of buildings.” In Proc., ASCE 2005 Structures Congress: Metropolis and Beyond, 20–24. New York: ASCE.
GSA (General Service Administration). 2003. Progressive collapse analysis and design guidelines for new federal office buildings and major modernization projects. Washington, DC: GSA.
Izzuddin, B. A., A. G. Vlassis, A. Y. Elghazouli, and D. A. Nethercot. 2008. “Progressive collapse of multi-storey buildings due to sudden column loss. Part I: Simplified assessment framework.” Eng. Struct. 30 (5): 1308–1318. https://doi.org/10.1016/j.engstruct.2007.07.011.
Lee, C. H., S. Kim, K. H. Han, and K. Lee. 2009. “Simplified nonlinear progressive collapse analysis of welded steel moment frames.” J. Constr. Steel Res. 65 (5): 1130–1137. https://doi.org/10.1016/j.jcsr.2008.10.008.
Lee, C. H., S. Kim, and K. Lee. 2010. “Parallel axial-flexural hinge model for nonlinear dynamic progressive collapse analysis of welded steel moment frames.” J. Struct. Eng. 136 (2): 165–173. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000102.
Leyendecker, E. V., and B. Ellingwood. 1977. Design methods for reducing the risk of progressive collapse in buildings: NBS building science series no. 98. Washington, DC: US Dept. of Commerce, National Bureau of Standards.
Marjanishvili, S., and E. Agnew. 2006. “Comparison of various procedures for progressive collapse analysis.” J. Perform. Constr. Facil. 20 (4): 365–374. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(365).
McGuire, W. 1974. “Prevention of progressive collapse.” In Proc., Regional Conf. on Tall Buildings, 23–24.
Naji, A. 2016. “Modelling the catenary effect in the progressive collapse analysis of concrete structures.” Struct. Concr. 17 (2): 145–151. https://doi.org/10.1002/suco.201500065.
Naji, A. 2017. “Plastic limit analysis of truss structures subjected to progressive collapse.” Eur. J. Eng. Res. Sci. 2 (9): 31–35. https://doi.org/10.24018/ejers.2017.2.9.451.
Naji, A. 2018. “Improving the tie force method for progressive collapse design of RC frames.” Int. J. Struct. Integrity 9 (4): 520–531. https://doi.org/10.1108/IJSI-10-2017-0058.
Naji, A., and F. Irani. 2012. “Progressive collapse analysis of steel frames: Simplified procedure and explicit expression for dynamic increase factor.” Int. J. Steel Struct. 12 (4): 537–549. https://doi.org/10.1007/s13296-012-4008-0.
Nigro, E., A. Bilotta, D. Asprone, F. Jalayer, A. Prota, and G. Manfredi. 2014. “Probabilistic approach for failure assessment of steel structures in fire by means of plastic limit analysis.” Fire Saf. J. 68: 16–29. https://doi.org/10.1016/j.firesaf.2014.05.020.
Parisi, F., and N. Augenti. 2012. “Influence of seismic design criteria on blast resistance of RC framed buildings: A case study.” Eng. Struct. 44: 78–93. https://doi.org/10.1016/j.engstruct.2012.05.046.
Ruth, P., K. A. Marchand, and E. B. Williamson. 2006. “Static equivalency in progressive collapse alternate path analysis: Reducing conservatism while retaining structural integrity.” J. Perform. Constr. Facil. 20 (4): 349–364. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(349).
Seffen, K. A. 2008. “Progressive collapse of the World Trade Center: Simple analysis.” J. Eng. Mech. 134 (2): 125–132. https://doi.org/10.1061/(ASCE)0733-9399(2008)134:2(125).
Tsai, M. H., and B. H. Lin. 2008. “Investigation of progressive collapse resistance and inelastic response for an earthquake-resistant RC building subjected to column failure.” Eng. Struct. 30 (12): 3619–3628. https://doi.org/10.1016/j.engstruct.2008.05.031.
Vlassis, A. G., B. A. Izzuddin, A. Y. Elghazouli, and D. A. Nethercot. 2008. “Progressive collapse of multi-storey buildings due to sudden column loss. Part II: Application.” Eng. Struct. 30 (5): 1424–1438. https://doi.org/10.1016/j.engstruct.2007.08.011.
Vlassis, A. G., B. A. Izzuddin, A. Y. Elghazouli, and D. A. Nethercot. 2009. “Progressive collapse of multi-storey buildings due to failed floor impact.” Eng. Struct. 31 (7): 1522–1534. https://doi.org/10.1016/j.engstruct.2009.02.009.
Xu, G., and B. R. Ellingwood. 2011. “An energy-based partial pushdown analysis procedure for assessment of disproportionate collapse potential.” J. Constr. Steel Res. 67 (3): 547–555. https://doi.org/10.1016/j.jcsr.2010.09.001.
Yi, W. J., Q. F. He, Y. Xiao, and S. K. Kunnath. 2008. “Experimental study on progressive collapse-resistant behavior of reinforced concrete frame structures.” ACI Struct. J. 105 (4): 433–439.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Feb 21, 2018
Accepted: Sep 5, 2018
Published online: Jan 22, 2019
Published in print: Apr 1, 2019
Discussion open until: Jun 22, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.