In Situ Lateral Load Testing of a Two-Story Solid Clay Brick Masonry Building
Publication: Journal of Performance of Constructed Facilities
Volume 32, Issue 5
Abstract
The seismic behavior of unreinforced masonry (URM) structures has usually been investigated by conducting laboratory tests. Such efforts, although useful in order to understand the response of single walls or subassemblages, cannot fully mimic the in situ seismic response of masonry buildings. In this study, in situ lateral load testing of a two-story full-scale URM building was conducted. First, forced vibration tests were performed to determine the vibration frequencies of the building. Afterwards, the building was tested by reacting against a braced steel frame built behind the test building and imposing one-way cyclic displacements. The building was pushed until 20% loss of lateral load capacity, which corresponds to a drift ratio of approximately 0.8%. The diagonal tension cracking of the walls was followed by sliding of the second-story concrete slab over the walls. A three-dimensional nonlinear finite-element analysis of the test building was conducted to simulate the behavior of the test building. The results showed that upon careful selection of the contact cohesion at the slab–wall interfaces, the numerical model provided reasonable estimations of the global structural behavior in terms of load-deformation response.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge the financial support provided by the Ministry of Environment and Urbanization, Directorate of Infrastructure and Urban Renewal, for conducting this study. The contributions of Baran Cobanoğlu, Salim Azak, and METU Structural Mechanics Laboratory workers Osman Keskin, Murat Demirel, and Barış Esen during the site and laboratory work are also gratefully acknowledged.
References
Abrams, D., T. Smith, J. Lynch, and S. Franklin. 2007. “Effectiveness of rehabilitation on seismic behaviour of masonry piers.” J. Struct. Eng. 133 (1): 32–43. https://doi.org/10.1061/(ASCE)0733-9445(2007)133:1(32).
Aldemir, A., B. Binici, E. Canbay, and A. Yakut. 2017. “Lateral load testing of an existing two story masonry building up to near collapse.” Bull. Earthquake Eng. 15 (8): 3365–3383. https://doi.org/10.1007/s10518-015-9821-3.
Aldemir, A., M. A. Erberik, I. O. Demirel, and H. Sucuoglu. 2013. “Seismic performance assessment of unreinforced masonry buildings with a hybrid modeling approach.” Earthquake Spectra 29 (1): 33–57. https://doi.org/10.1193/1.4000102.
Ali, Q., A. N. Khan, N. Ahmad, and B. Alam. 2012. “In-situ dynamic testing of masonry structure by means of underground explosions simulating earthquake motions: A unique case study.” Int. J. Earth Sci. Eng. 5 (5): 1196–1207.
ASCE. 2000. Prestandard and commentary for the seismic rehabilitation of buildings. Washington, DC: ASCE.
ASCE. 2010. Minimum design loads for buildings and other structures. Reston, VA: ASCE.
ASCE. 2013. Seismic rehabilitation of existing buildings. Reston, VA: ASCE.
Beyer, K. 2012. “Peak and residual strengths of brick masonry spandrels.” Eng. Struct. 41 (1): 533–547. https://doi.org/10.1016/j.engstruct.2012.03.015.
Beyer, K., and A. Dazio. 2012. “Quasi-static cyclic tests on masonry spandrels.” Earthquake Spectra 28 (3): 907–929. https://doi.org/10.1193/1.4000063.
CEN (European Committee for Standardization). 2005. Design of masonry structures—Part 1-1: General rules for reinforced and unreinforced masonry structures. Eurocode 6. Brussels, Belgium: CEN.
Chourasia, A., S. K. Bhattacharyya, P. Bhargava, and N. M. Bhandari. 2016. “Seismic performance of different masonry buildings: A full-scale experimental study.” J. Perform. Constr. Facil. 3 (5): 04016006. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000850.
Cobanoglu, B., A. Aldemir, I. O. Demirel, B. Binici, E. Canbay, and A. Yakut. 2017. “Seismic performance assessment of masonry buildings using in situ material properties.” J. Perform. Constr. Facil. 31 (4): 04017033. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001030.
Dizhur, D., R. Lumantarna, H. Derakhshan, M. Griffith, and J. Ingham. 2010. “In-situ testing of a residential unreinforced masonry building located in New Zealand.” In Proc., 8th Int. Masonry Conf. Whyteleafe, UK: International Masonry Society.
Erberik, M. A., A. Aldemir, and B. O. Ay. 2008. “A critique on the Turkish earthquake code regulations regarding masonry construction.” In Proc., 8th Int. Seminar on Structural Masonry. Istanbul, Turkey: Istanbul Technical Univ.
Franklin, S., J. Lynch, and D. Abrams. 2001. Performance of rehabilitated URM shear walls: Flexural behavior of piers. Champaign, IL: Univ. of Illinois at Urbana–Champaign.
Giongo, I., D. Dizhur, R. Tomasi, and J. M. Ingham. 2014. “Field testing of flexible timber diaphragms in an existing vintage URM building.” J. Struct. Eng. 141 (1): D4014009. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001045.
Guojue, W., L. Yingmin, Z. Nina, and J. M. Ingham. 2017. “Testing and modelling the in-plane seismic response of clay brick masonry walls with boundary columns made of precast concrete interlocking blocks.” Eng. Struct. 131 (1): 513–529. https://doi.org/10.1016/j.engstruct.2016.10.035.
Hsiao, F. P., T. C. Chiou, S. J. Hwang, and Y. J. Chiou. 2008. Field test of RC school buildings applying seismic retrofit and evaluation, 9–12. Taipei, Taiwan: National Center for Research on Earthquake Engineering.
Hsiao, F. P., and S. J. Hwang. 2007. In-situ tests of buildings in Rei-Pu elementary school, 5–8. Taipei, Taiwan: National Center for Research on Earthquake Engineering.
Lourenco, P. B. 1996. “Computational strategies for masonry structures.” Ph.D. dissertation, Dept. of Civil Engineering, Delft Univ. of Technology.
Lourenco, P. B., and J. G. Rots. 1997. “A multi-surface interface model for the analysis of masonry structures.” J. Eng. Mech. 123 (7): 660–668. https://doi.org/10.1061/(ASCE)0733-9399(1997)123:7(660).
Magenes, G., and G. M. Calvi. 1997. “In-plane seismic response of brick masonry walls.” Earthquake Eng. Struct. Dyn. 26 (11): 1091–1112. https://doi.org/10.1002/(SICI)1096-9845(199711)26:11%3C1091::AID-EQE693%3E3.0.CO;2-6.
Magenes, G., G. R. Kingsley, and G. M. Calvi. 1995. Seismic testing of a full-scale, two-story masonry building: Test procedure and measured experimental response. Pavia, Italy: Univ. of Pavia.
Ministry of Environment and Urbanization. 2013. Guidelines for the assessment of buildings under high risk. [In Turkish.] Ankara, Turkey: Government of Republic of Turkey.
MSJC (Masonry Standards Joint Committee). 2013. Building code requirements for masonry structures and specification for masonry structures and commentaries. Boulder: Masonry Society.
Paquette, J., and M. Bruneau. 2003. “Pseudo-dynamic testing of unreinforced masonry building with flexible diaphragm.” J. Struct. Eng. 129 (6): 708–716. https://doi.org/10.1061/(ASCE)0733-9445(2003)129:6(708).
Roca, P., M. Cervera, L. Pela, R. Clemente, and M. Chiumenti. 2013. “Continuum FE models for the analysis of Mallorca cathedral.” Eng. Struct. 46 (1): 653–670. https://doi.org/10.1016/j.engstruct.2012.08.005.
Russell, A. P., K. J. Elwood, and J. M. Ingham. 2014. “Lateral force-displacement response of unreinforced masonry wall with flanges.” J. Struct. Eng. 140 (4): 04013087. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000863.
Shahzada, K., A. N. Khan, A. S. Elnashai, M. Ashraf, M. Javed, A. Naseer, and B. Alam. 2012. “Experimental seismic performance evaluation of unreinforced brick masonry buildings.” Earthquake Spectra 28 (3): 1269–1290. https://doi.org/10.1193/1.4000073.
Shih, C. T., S. Y. Chu, Y. W. Liou, F. P. Hsiao, C. C. Huang, T. C. Chiou, and Y. C. Chiou. 2015. “In situ test of school buildings retrofitted with external steel-framing systems.” J. Struct. Eng. 141 (1): D4014002. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001063.
Smith, J. O. 2011. “Spectral audio signal processing.” W3K Publishing. Accessed February 13, 2018. http://ccrma.stanford.edu/~jos/sasp/.
Sucuoglu, H., and M. A. Erberik. 1997. “Performance evaluation of a three story unreinforced masonry building during the 1992 Erzincan earthquake.” Earthquake Eng. Struct. Dyn. 26 (3): 319–336.
TEC (Turkish Earthquake Code). 2017. Specification for the buildings to be constructed in disaster areas. Ankara, Turkey: Ministry of Public Works and Settlement.
Tomazevic, M., and P. Weiss. 1994. “Seismic behaviour of plain and reinforced masonry buildings.” J. Struct. Eng. 120 (2): 323–338. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:2(323).
Uranjek, M., V. Bosiljkov, R. Zarnic, and V. B. Bosiljkov. 2012. “In situ tests and seismic assessment of a stone-masonry building.” Mater. Struct. 45 (6): 861–879. https://doi.org/10.1617/s11527-011-9804-z.
Willam, K. J., and E. D. Warnke. 1975. “Constitutive model for the triaxial behavior of concrete.” In Vol. 19 of Proc., Int. Association for Bridge and Structural Engineering, 1–30. Zurich, Switzerland: International Association for Bridge and Structural Engineering.
Yi, T. 2004. “Experimental investigation and numerical simulation of an unreinforced masonry structure with flexible diaphragms.” Ph.D. dissertation, Dept. of Civil and Environmental Engineering, Georgia Institute of Technology.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Aug 7, 2017
Accepted: Apr 3, 2018
Published online: Jun 22, 2018
Published in print: Oct 1, 2018
Discussion open until: Nov 22, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.