Multihazard Assessment and Retrofit of Deteriorated Timber Pile Bridges
Publication: Journal of Performance of Constructed Facilities
Volume 32, Issue 3
Abstract
Compared to research studies on the behavior and performance of reinforced concrete and steel structures, there is almost no information available in the literature relating to heavy timber structures such as timber pile bridges. With growing interest to expand the scope of structural designs to extreme loads from multiple hazards, the knowledge gap is expanding. In this study, the performance of a model bridge with timber pile substructures and a precast concrete superstructure was examined in a multihazard scenario involving three hazards: timber deterioration, earthquake, and tsunami loading. As a countermeasure to timber deterioration, a retrofitting strategy using fiber-reinforced polymer (FRP) composites was investigated. Material models for as-is timber piles and FRP-confined timber piles were derived based on experiments conducted on field-extracted specimens. The earthquake and tsunami events were simulated sequentially. The particle finite element method is used to conduct the tsunami simulation. Results show that even a modest level of timber deterioration can considerably affect the capacity of timber pile bridges under earthquake-tsunami loading. However, the FRP retrofitting technique considered in this study shows significant improvements can be achieved in terms of earthquake and tsunami capacity by strengthening a few selected timber piles.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was partially supported by the Illinois Center for Transportation and the Illinois Department of Transportation (ICT/IDOT) under project No. R27-134. The authors would also like to thank Dr. C. Armando Duarte at the University of Illinois at Urbana-Champaign for his guidance on the computational aspects of PFEM as well as Dr. Michael Scott and Dr. Minjie Zhu at Oregon State University for their assistance with PFEM in OpenSees.
References
AFPA (American Forest and Paper Association). (2005). National design specification (NDS) for wood construction, Washington, DC.
Allicock, D. R. (1999). “Experimental study of timber piles subjected to reverse cyclic loading.” M.S. thesis, State Univ. of New York at Buffalo, Buffalo, NY.
Arnason, H., Petroff, C., and Yeh, H. (2009). “Tsunami bore impingement onto a vertical column.” J. Disaster Res., 4(6), 391–403.
ASCE/SEI (Structural Engineering Institute). (2017). “Minimum design loads and associated criteria for buildings and other structures.” ASCE/SEI 7-16, Reston, VA.
ASTM. (2014). “Standard test methods for small clear specimens of timber.” ASTM D143-14, Reston VA.
Borello, D. J., Andrawes, B., Hajjar, J. F., Olson, S. M., and Hansen, J. (2010). “Experimental and analytical investigation of bridge timber piles under eccentric loads.” Eng. Struct., 32(8), 2237–2246.
Brashaw, B. K., Vatalaro, R. J., Wacker, J. P., and Ross, R. J. (2005a). “Condition assessment of timber bridges. 1: Evaluation of a micro-drilling resistance tool.”, Forest Products Laboratory, Madison, WI.
Brashaw, B. K., Vatalaro, R. J., Wacker, J. P., and Ross, R. J. (2005b). “Condition assessment of timber bridges. 2: Evaluation several stress-wave tools.”, Forest Products Laboratory, Madison, WI.
Caiza, P., Shin, M., and Andrawes, B. (2012). “Flexure-compression testing of bridge timber piles retrofitted with fiber reinforced polymers.” Open J. Civ. Eng., 2(03), 115–124.
Carey, T., Mason, H. B., Barbosa, A. R., and Scott, M. H. (2014). “Modeling framework for soil-bridge system response during sequential earthquake and tsunami loading.” Proc., 10th US National Conf. on Earthquake Engineering, Earthquake Engineering Research Institute, Oakland, CA.
Chanson, H. (2006). “Tsunami surges on dry coastal plains: Application of dam break wave equations.” Coastal Eng. J., 48(4), 355–370.
Chock, G., Robertson, I., Kriebel, D., Francis, M., and Nistor, I. (2013). Tohoku, Japan, earthquake and tsunami of 2011: Performance of structures under tsunami loads, ASCE, Reston, VA.
FEMA. (2012). “Guidelines for design of structures for vertical evacuation from tsunamis.” FEMA P-646, Washington, DC.
FHWA-NBI (Federal Highway Administration-National Bridge Inventory). (2016). “2016 data.” ⟨https://www.fhwa.dot.gov/bridge/nbi.cfm⟩ (Mar. 28, 2017).
Fritz, H. M., et al. (2012). “The 2011 Japan tsunami current velocity measurements from survivor videos at Kesennuma Bay using LiDAR.” Geophys. Res. Lett., 39(7), L00G23.
Geist, E. L. (1998). “Local tsunamis and earthquake source parameters.” Adv. Geophys., 39, 117–209.
Geist, E. L., Titov, V. V., and Synolakis, C. E. (2006). “Tsunami: Wave of change.” Sci. Am., 294(1), 56–63.
Idelsohn, S. R., Onate, E., Del Pin, F., and Calvo, N. (2006). “Fluid-structure interaction using the particle finite element method.” Comput. Methods Appl. Mech. Eng., 195(17), 2100–2123.
Kornkasem, W., Foutch, D. A., and Long, J. H. (2001). “Seismic behavior of pile-supported bridges.”, Univ. of Illinois at Urbana-Champaign, Urbana, IL.
Koshimura, S., and Mofjeld, H. O. (2001). “Inundation modeling of local tsunamis in Puget Sound, Washington, due to potential earthquakes.” Proc., Int. Tsunami Symp., International Union of Geodesy and Geophysics Joint Tsunami Commission, Potsdam, Germany, 861–873.
Mander, J., Allicock, D., and Friedland, I. (2000). “Seismic performance of timber bridges.” Transp. Res. Rec., 1740, 75–84.
Mazzoni, S., McKenna, F., Scott, M. H., and Fenves, G. L. (2000). Open system for earthquake engineering simulation, Univ. of California, Berkeley, CA.
Najm, H., Secaras, J., and Balaguru, P. (2007). “Compression tests of circular timber column confined with carbon fibers using inorganic matrix.” J. Mater. Civ. Eng., 198–204.
Nistor, I., Palermo, D., Cornett, A., and Al-Faesly, T. (2011). “Experimental and numerical modeling of tsunami loading on structures.” Coastal Eng. Proc., 1(32), in press.
Oñate, E., Idelsohn, S. R., Del Pin, F., and Aubry, R. (2004). “The particle finite element method—An overview.” Int. J. Comput. Methods, 1(02), 267–307.
Plevris, N., and Triantafillou, T. C. (1992). “FRP-reinforced wood as structural material.” J. Mater. Civ. Eng., 300–317.
Satake, K., and Tanioka, Y. (1999). “Sources of tsunami and tsunamigenic earthquakes in subduction zones.” Pure Appl. Geophys., 154(3–4), 467–483.
Shama, A. A., and Mander, J. B. (2004). “Behavior of timber pile-to-cap connections under cyclic lateral loading.” J. Struct. Eng., 1252–1262.
Shama, A. A., Mander, J. B., Friedland, I. M., and Allicock, D. R. (2007). “Seismic vulnerability of timber bridges and timber substructures.”, State Univ. of New York at Buffalo, Buffalo, NY.
Yeh, H. (2006). “Maximum fluid forces in the tsunami runup zone.” J. Waterway Port Coastal Ocean Eng., 496–500.
Yeh, H. H. (1991). “Tsunami bore runup.” Tsunami hazard, Springer, Dordrecht, Netherlands, 209–220.
Zhang, W., Song, X., Gu, X., and Tang, H. (2012). “Compressive behavior of longitudinally cracked timber columns retrofitted using FRP sheets.” J. Struct. Eng., 90–98.
Zhu, M., and Scott, M. H. (2014). “Modeling fluid-structure interaction by the particle finite element method in OpenSees.” Comput. Struct., 132, 12–21.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Jun 28, 2017
Accepted: Nov 8, 2017
Published online: Mar 30, 2018
Published in print: Jun 1, 2018
Discussion open until: Aug 30, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.