Abstract
Collapse of a 15.7-m-deep excavation in very sensitive organic soft clay in Hangzhou, China, is presented in this paper. The collapse of the excavation caused the break and/or inclination of the retaining walls, the wracking of the supporting system, significant sinking of a major road adjacent to the excavation site, and also the break in a water main beneath the road. After the collapse, the ground disturbance due to the collapse was investigated by cone penetration tests (CPTs) and field vane shear tests (VSTs). A simplified method, based on the CPT and VST test results, was used to evaluate the strength reduction ratio (SRR) of the in situ soils. According to the SRR values of the soils at different depths, the lower boundaries of the severely disturbed soils were determined and a possible slip failure surface passing through the bottom of the severely disturbed soils was justified. The factors of safety (FOSs) against basal heave of the excavation calculated from various methods were 1.05, 0.74 and 0.89, respectively. These computed values were much smaller than the corresponding recommended values. The stability number of the excavation was calculated to be 7.4. The overall FOS was studied using the shear strength reduction technique based on a finite-element method (FEM) program. The FEM analysis results indicated that the FOS of the excavation was 0.97, and the computed slip failure surface fit well with that from the soil disturbance investigation. The failure mechanism of the excavation was then justified to be a basal heave. The main reasons leading to the collapse and lessons learned from the collapse are discussed. The investigation of the failure provides experiences and lessons for deep excavation design in very sensitive organic soft clay.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Much of the work presented in this paper was supported by the National Science Foundation for Distinguished Young Scholars of China (Grant No. 51225804), the State Key Program of National Natural Science of China (Grant No. U1234204), the grand science and technology special project of Zhejiang province in China (Grant No. 2011C13043), and the National Natural Science Foundation of China (NSFC Grant No. 51108417).
References
Bishop, A. W. (1955). “The use of the slip circle in the stability of slopes.” Geotechnique, 5(1), 7–17.
Bjerrum, L. (1972). “Embankments on soft ground, state-of-the-report.” Proc., ASCE Specialty Conf. on Performance of Earth and Earth-Supported Structures, Vol. 2, ASCE, Reston, VA, 1–54.
Bjerrum, L., and Eide, O. (1956). “Stability of strutted excavations in clay.” Geotechnique, 6(1), 32–47.
Brinkgreve, R., et al. (2002). Plaxis 2D version 8 manual, A.A. Balkema, Rotterdam, Netherlands.
Do, T. N., Ou, C. Y., and Lim, A. (2013). “Evaluation of factors of safety against basal heave for deep excavations in soft clay using the finite element method.” J. Geotech. Geoenviron. Eng., 2125–2135.
Duncan, J. M. (1996). “State of the art: Limit equilibrium and finite-element analysis of slopes.” J. Geotech. Eng., 577–596.
Henkel, D. J. (1971). “The calculation of earth pressures in open cuts in soft clays.” Arup J., 6(4), 14–15.
Hong, Z. S., and Onitsuka, K. (1998). “A method of correcting yield stress and compression index of clays for sample disturbance.” Soils Found., 38(2), 211–222.
Hsieh, P. G., and Ou, C. Y. (1998). “Shape of ground surface settlement profiles caused by excavation.” Can. Geotech. J., 35(6), 1004–1017.
Lim, A., Ou, C. Y., and Hsieh, P. G. (2010). “Evaluation of clay constitutive models for analysis of deep excavation under undrained conditions.” J. Geoeng., 5(1), 9–20.
Lunne, T., and Kleven, A. (1981). “Role of CPT in North Sea foundation engineering.” Symp. on Cone Penetration Testing and Experience, ASCE, Reston, VA, 49–75.
Magnus, R., Teh, C. I., and Lau, J. M. (2004). Rep. of the Committee of Inquiry into the Incident at the MRT Circle Line worksite that Led to the Collapse of Nicoll Highway on 20 April 2004 Volume 1, Subordinate Courts, Singapore.
Mana, A. I., and Clough, G. W. (1981). “Prediction of movements for braced cut in clay.” J. Geotech. Eng. Div., 107(6), 759–777.
Matsui, T., and San, K. C. (1992). “Finite element slope stability analysis by shear strength reduction technique.” Soils Found., 32(1), 59–70.
Nagaraj, T. S., Srinivasa Murthy, B. R., Vatsala, A., and Joshi, R. C. (1990). “Analysis of compressibility of sensitive clays.” J. Geotech. Eng., 105–118.
Naval Facilities Engineering Command (NAVFAC). (1982). Foundation and earth structure, design manual 7.2, U.S. Dept. of the Navy, Washington, DC.
Ou, C. Y. (2006). Deep excavation: Theory and practice, Taylor and Francis, London.
Rosenqvist, I. T. (1953). “Considerations on the sensitivity of Norwegian quick clays.” Geotechnique, 3(5), 195–200.
Tan, Y., and Wei, B. (2012). “Performance of an overexcavated metro station and facilities nearby.” J. Perform. Constr. Facil., 241–254.
Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.
Ugai, K., and Leshchinsky, D. (1995). “Three-dimensional limit equilibrium and finite element analyses: A comparison of results.” Soils Found., 35(4), 1–7.
Zienkiewicz, O. C., Humpheson, C., and Lewis, R. W. (1975). “Associated and non-associated visco-plasticity and plasticity in soil mechanics.” Geotechnique, 25(4), 671–689.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: May 12, 2013
Accepted: Dec 10, 2013
Published online: Dec 12, 2013
Discussion open until: Jan 13, 2015
Published in print: Jun 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.