Size Effect on FRP External Reinforcement and Retrofit of Concrete Structures
Publication: Journal of Composites for Construction
Volume 24, Issue 5
Abstract
The size effect on the strength of reinforced concrete (RC) beams flexurally strengthened by surface bonded sheets of fiber-reinforced polymer (FRP) is studied. As the failure is neither ductile nor brittle, but quasibrittle, occurring after stable growth of large cracks with large damage zones, the transitional size effect governed by the energetic size effect law (SEL) must be expected, which the present analysis confirms. Owing to scarcity of size effect experimental data, finite element (FE) analysis is used. A powerful microplane damage constitutive model M7 for concrete, coupled with the crack band model to suppress spurious mesh sensitivity, is calibrated by fitting the existing test data to FRP-strengthened RC specimens of diverse types, and consequently is trusted to simulate the size effect. The analysis captures the debonding near the concrete–FRP interface starting at midspan or at the end of the FRP sheet. It also captures the debonding between adjacent concrete shear cracks, and the delamination of concrete cover. The causes of these different delamination modes are explained. Simple beam-type formulas, in which the size characteristic is not the beam depth but the length of the shear span, are proposed and validated by FE results. The use of single-lap shear tests to determine the bond strength is critically discussed. Finally, a good fit of a few existing limited test data on the size effect of FRP-strengthened specimens is demonstrated.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The first author thanks ITU BAP for supporting the Project No. 40860 and The Scientific and Technological Research Council of Turkey for financially supporting the first 12 months of his post-doctoral appointment at Northwestern University. Partial funding under NSF Grant No. CMMI-2029641 to Northwestern University is gratefully acknowledged.
References
ACI (American Concrete Institute). 2017. Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures. Rep. No. 440.2R-17. West Lafayette, IN: ACI.
Arduini, M., and A. Nanni. 1997. “Behavior of precracked RC beams strengthened with carbon FRP sheets.” J. Compos. Constr. 1 (2): 63–70.
Attari, N., S. Amziane, and M. Chemrouk. 2012. “Flexural strengthening of concrete beams using CFRP, GFRP and hybrid FRP sheets.” Constr. Build. Mater. 37: 746–757.
Bažant, Z. P. 1984. “Size effect in blunt fracture: Concrete, rock, metal.” J. Eng. Mech. 110 (4): 518–535.
Bažant, Z. P. 2002. Scaling of structural strength. London: Hermes Penton Science.
Bažant, Z. P., and B. H. Oh. 1983. “Crack band theory for fracture of concrete.” Matér. Constr. 16 (3): 155–177.
Bažant, Z. P., and J. Ožbolt. 1990. “Nonlocal microplane model for fracture, damage, and size effect in structures.” J. Eng. Mech. 116 (11): 2485–2505.
Bažant, Z. P., and J. Planas. 1998. Fracture and size effect in concrete and other quasibrittle materials. Boca Raton, FL: CRC Press.
Brena, S. F., R. M. Bramblett, S. L. Wood, and M. E. Kreger. 2003. “Increasing flexural capacity of reinforced concrete beams using carbon fiber-reinforced polymer composites.” Struct. J. 100 (1): 36–46.
Caner, F. C., and Z. P. Bažant. 2013a. “Microplane model m7 for plain concrete. I: Formulation.” J. Eng. Mech. 139 (12): 1714–1723.
Caner, F. C., and Z. P. Bažant. 2013b. “Microplane model m7 for plain concrete. II: Calibration and verification.” J. Eng. Mech. 139 (12): 1724–1735.
Carloni, C., M. Santandrea, and I. A. O. Imohamed. 2017. “Determination of the interfacial properties of SRP strips bonded to concrete and comparison between single-lap and notched beam tests.” Eng. Fract. Mech. 186: 80–104.
Carrara, P., D. Ferretti, F. Freddi, and G. Rosati. 2011. “Shear tests of carbon fiber plates bonded to concrete with control of snap-back.” Eng. Fract. Mech. 78 (15): 2663–2678.
Chen, J. F., and J. G. Teng. 2001. “Anchorage strength models for FRP and steel plates bonded to concrete.” J. Struct. Eng. 127 (7): 784–791.
Chiew, S.-P., Q. Sun, and Y. Yu. 2007. “Flexural strength of RC beams with GFRP laminates.” J. Compos. Constr. 11 (5): 497–506.
Dönmez, A., and Z. P. Bažant. 2017. “Size effect on punching strength of reinforced concrete slabs with and without shear reinforcement.” ACI Struct. J. 114 (4): 875–886.
Dönmez, A., and Z. P. Bažant. 2019. “Critique of critical shear crack theory for FIB model code articles on shear strength and size effect of reinforced concrete beams.” Struct. Concr. 20 (4): 1451–1463.
Maalej, M., and Y. Bian. 2001. “Interfacial shear stress concentration in FRP-strengthened beams.” Compos. Struct. 54 (4): 417–426.
Maalej, M., and K. S. Leong. 2005. “Effect of beam size and FRP thickness on interfacial shear stress concentration and failure mode of FRP-strengthened beams.” Compos. Sci. Technol. 65 (7–8): 1148–1158.
Raoof, S. M., and D. A. Bournas. 2017. “TRM versus FRP in flexural strengthening of RC beams: Behaviour at high temperatures.” Constr. Build. Mater. 154: 424–437.
Rasoolinejad, M., and Z. P. Bažant. 2019. “Size effect of squat shear walls extrapolated by microplane model M7.” ACI Struct. J. 116 (3): 75–84.
Saadatmanesh, H., and M. R. Ehsani. 1991. “RC beams strengthened with GFRP plates. I: Experimental study.” J. Struct. Eng. 117 (11): 3417–3433.
Teng, J. G., S. T. Smith, J. Yao, and J. F. Chen. 2003. “Intermediate crack-induced debonding in RC beams and slabs.” Constr. Build. Mater. 17 (6–7): 447–462.
Information & Authors
Information
Published In
Journal of Composites for Construction
Volume 24 • Issue 5 • October 2020
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Jan 28, 2020
Accepted: Jun 2, 2020
Published online: Aug 6, 2020
Published in print: Oct 1, 2020
Discussion open until: Jan 6, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.