Experimental Investigation of Circular High-Strength Concrete Columns Reinforced with Glass Fiber-Reinforced Polymer Bars and Helices under Different Loading Conditions
Publication: Journal of Composites for Construction
Volume 21, Issue 4
Abstract
Existing design codes and guidelines do not adequately address the design of concrete columns reinforced with fiber-reinforced polymer (FRP) bars. Accordingly, a number of research studies investigated the behavior of FRP bar-reinforced concrete columns. However, the previous studies were limited to FRP bar-reinforced normal-strength concrete (NSC) columns. In this study, the behavior of glass fiber-reinforced polymer (GFRP) bar-reinforced high-strength concrete (HSC) specimens under different loading conditions was investigated in terms of axial load-carrying capacity, confinement efficiency of the GFRP helices, as well as the ductility and post-peak axial load-axial deformation response. The effects of the key parameters such as the type of the reinforcement (steel and GFRP), the pitch of the transverse helices, and the loading condition (concentric, eccentric, and four-point loading) on the performance of the specimens were investigated. It was observed that the GFRP bar-reinforced HSC specimen sustained similar axial load under concentric axial compression compared to its steel counterpart, but the efficiency of GFRP bar-reinforced HSC specimens in sustaining axial loads decreased with an increase in the axial load eccentricity. Direct replacement of steel reinforcement by the same amount of GFRP reinforcement in HSC specimens resulted in about 30% less ductility under concentric axial load. However, it was found that the ductility and post-peak axial load-axial deformation behavior of the GFRP bar-reinforced HSC specimens can be significantly improved by providing closely spaced helices.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors express special thanks to the technical officers at the High Bay Laboratories of the University of Wollongong, especially Messrs. Ritchie McLean, Richard Gasser, and Fernando Escribano, for their help in conducting the experimental program of this study. Also, the second author would like to acknowledge the Iraqi Government and the University of Wollongong for the support of his full Ph.D. scholarship. The second author also thanks his parents for their loving support.
References
ACI (American Concrete Institute). (2006). “Guide for the design and construction of structural concrete reinforced with FRP bars.”, Farmington Hills, MI.
ACI (American Concrete Institute). (2010). “Report on high strength concrete.”, Farmington Hills, MI.
ACI (American Concrete Institute). (2011). “Building code requirements for structural concrete.”, Farmington Hills, MI.
ACI (American Concrete Institute). (2014). “Building code requirements for structural concrete.”, Farmington Hills, MI.
ACI (American Concrete Institute). (2015). “Guide for the design and construction of structural concrete reinforced with FRP bars.”, Farmington Hills, MI.
Afifi, M., Mohamed, H., and Benmokrane, B. (2013). “Axial capacity of circular concrete columns reinforced with GFRP bars and spirals.” J. Compos. Constr., .
Ali, A. H., Mohamed, H. M., and Benmokrane, B. (2016). “Shear behavior of circular concrete members reinforced with GFRP bars and spirals at shear span-to-depth ratios between 1.5 and 3.0.” J. Compos. Constr., .
Alsayed, S. H., Al-Salloum, Y. A., Almusallam, T. H., and Amjad, M. A. (1999). “Concrete columns reinforced by GFRP rods.” 4th Int. Symp. on Fiber-Reinforced Polymer Reinforcement for Reinforced Concrete Structures SP-188, C. W. Dolan, S. H. Rizkalla, and A. Nanni, eds., American Concrete Institute, Farmington Hills, MI, 103–112.
AS (Australian Standard). (2007). “Metallic materials-tensile testing at ambient temperature.”, Sydney, NSW, Australia.
ASTM. (2011). “Standard test method for tensile properties of fiber reinforced polymer matrix composite bars.”, West Conshohocken, PA.
Bing, L., Park, R., and Tanaka, H. (2001). “Stress-strain behavior of high-strength concrete confined by ultra-high- and normal-strength transverse reinforcements.” ACI Struct. J., 98(3), 395–406.
Choo, C. C., Harik, I. E., and Hans, G. (2006). “Strength of rectangular concrete columns reinforced with fiber-reinforced polymer bars.” ACI Struct. J., 103(3), 452–459.
Collins, M. P., and Mitchell, D. (1991). Prestressed concrete structure, Prentice Hall, Englewood Cliffs, NJ, 766.
CSA (Canadian Standards Association). (2006). “Canadian highway bridge design code.”, Rexdale, ON, Canada.
CSA (Canadian Standards Association). (2012). “Design and construction of building components with fiber reinforced polymers.”, Rexdale, ON, Canada.
Cusson, D., and Paultre, P. (1994). “High-strength concrete columns confined by rectangular ties.” J. Struct. Eng., 783–804.
De Luca, A., Matta, F., and Nanni, A. (2010). “Behavior of full-scale glass fiber-reinforced polymer reinforced concrete columns under axial load.” ACI Struct. J., 107(5), 589–596.
El-Nemr, A., Ahmed, E. A., and Benmokrane, B. (2013). “Flexural behavior and serviceability of normal-and high-strength concrete beams reinforced with glass fiber-reinforced polymer bars.” ACI Struct. J., 110(6), 1077–1087.
Foster, S. J., and Attard, M. M. (1997). “Experimental tests on eccentrically loaded high strength concrete columns.” ACI Struct. J., 94(3), 295–303.
Foster, S. J., Liu, J., and Sheikh, S. (1998). “Cover spalling in HSC columns loaded in concentric compression.” J. Struct. Eng., 1431–1437.
Goldston, M., Remennikov, A., and Sheikh, M. N. (2016). “Experimental investigation of the behaviour of concrete beams reinforced with GFRP bars under static and impact loading.” Eng. Struct., 113, 220–232.
Hadi, M., Karim, H., and Sheikh, M. (2016). “Experimental investigations on circular concrete columns reinforced with GFRP bars and helices under different loading conditions.” J. Compos. Constr., .
Hadi, M., and Youssef, J. (2016). “Experimental investigation of GFRP-reinforced and GFRP-encased square concrete specimens under axial and eccentric load, and four-point bending test.” J. Compos. Constr., .
ISO. (2015). “Fibre-reinforced polymer (FRP) reinforcement of concrete: Test methods. Part 1: FRP bars and grids.”, Switzerland.
Karim, H., Sheikh, M. N., and Hadi, M. N. S. (2016). “Axial load-axial deformation behaviour of circular concrete columns reinforced with GFRP bars and helices.” Constr. Build. Mater., 112, 1147–1157.
Lignola, G. P., Jalayer, F., Nardone, F., Prota, A., and Manfredi, G. (2014). “Probabilistic design equations for the shear capacity of RC members with FRP internal shear reinforcement.” Composites Part B, 67, 199–208.
Lignola, G. P., Prota, A., Manfredi, G., and Cosenza, E. (2007). “Deformability of reinforced concrete hollow columns confined with CFRP.” ACI Struct. J., 104(5), 629.
Mohamed, H., Afifi, M., and Benmokrane, B. (2014). “Performance evaluation of concrete columns reinforced longitudinally with FRP bars and confined with FRP hoops and spirals under axial load.” J. Bridge Eng., .
Nanni, A. (1993). “Flexural behavior and design of RC members using FRP reinforcement.” J. Struct. Eng., 3344–3359.
Ozbakkaloglu, T., and Saatcioglu, M. (2004). “Rectangular stress block for high-strength concrete.” ACI Struct. J., 101(4), 475–483.
Paramanantham, N. S. (1993). “Investigation of the behavior of concrete columns reinforced with fiber-reinforced plastic rebars.” Lamar Univ., Beaumont, TX.
Pessiki, S., and Pieroni, A. (1997). “Axial load behavior of large scale spirally reinforced high strength concrete columns.” ACI Struct. J., 94(3), 304–314.
Popovics, S. (1973). “A numerical approach to the complete stress-strain curve of concrete.” Cem. Concr. Res., 3(5), 583–599.
Razvi, S. R., and Saatcioglu, M. (1999). “Circular high-strength concrete columns under concentric compression.” ACI Struct. J., 96(5), 817–826.
Thorenfeldt, E., Tomaszewicz, A., and Jensen, J. J. (1987). “Mechanical properties of high strength concrete and application to design.” Proc., of the Symp.: Utilization of High-Strength Concrete, Tapir, Trondheim, Norway, 149–159.
Tobbi, H., Farghaly, A. S., and Benmokrane, B. (2012). “Concrete columns reinforced longitudinally and transversally with glass fiber-reinforced polymer bars.” ACI Struct. J., 109(4), 551–558.
Toutanji, H., and Saafi, M. (2000). “Flexural behavior of concrete beams reinforced with glass fiber-reinforced polymer (GFRP) bars.” ACI Struct. J., 97(5), 712–719.
V-Rod. (2012). “Composite reinforcing rods technical data sheet.” Large Bay, SA, Australia.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: May 5, 2016
Accepted: Oct 10, 2016
Published online: Jan 30, 2017
Discussion open until: Jun 30, 2017
Published in print: Aug 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.