Experimental Study of Bond Behavior of CFRP-to-Brick Joints
Publication: Journal of Composites for Construction
Volume 19, Issue 3
Abstract
Carbon fiber–reinforced polymer (CFRP) composite materials have been widely used to strengthen masonry constructions. The bond between CFRP and substrate strongly conditions the performance of reinforced masonry structures. Characterization of shear bond mechanical behavior of masonry-CFRP interface thus becomes a crucial factor. The paper presents the results of an extensive experimental investigation aimed at evaluating the bond between clay brick and CFRP sheet. Specimens with varying width and length of the bonded CFRP sheet were subjected to shear test by three different testing setups. Results allowed comparison of the effectiveness of the three types of setup and pointed out the influence of the dimensions of the bonded sheet on ultimate load and ultimate slip, load-displacement diagram, and failure modes. Measurement of local strain along the CFRP sheet also allowed an investigation on the transfer mode of the stresses from the reinforcement to the brick and the determination of the local shear stress-slip relationship.
Get full access to this article
View all available purchase options and get full access to this article.
References
Aiello, M. A., and Sciolti, S. M. (2006). “Bond analysis of masonry structures strengthened with CFRP sheets.” J. Constr. Build. Mater., 20(1–2), 90–100.
Aiello, M. A., Sciolti, S. M., and Triantafillou, T. C. (2007). “FRP-strengthened masonry: Bond aspect.” 8th Int. Symp. on Fiber Reinforced Polymer Reinforcement for Concrete Structures, FRPRCS-8, Univ. of Patras, Patras, Greece.
Al-Safy, R., Al-Mahaidi, R., Simon, G. P., and Habsuda, J. (2012). “Experimental investigation on the thermal and mechanical properties of nanoclay-modified adhesives used for bonding CFRP to concrete substrates.” J. Constr. Build. Mater., 28, 769–778.
American Concrete Institute (ACI). (2004). “Guide test methods for fiber-reinforced polymers (FRPs) for reinforcing or strengthening concrete structures.”, Farmington Hills, MI.
ASTM. (2003). “Standard test method for tensile properties of plastics.” D638-03, West Conshohocken, PA.
Basilio, I., Fedele, R., and Lourenço, P. B. (2014). “Assessment of curved FRP-reinforced masonry prisms: Experiments and modeling.” Constr. Build. Mater., 51, 492–505.
Borri, A., Castori, G., and Corradi, M. (2011). “Intrados strengthening of brick masonry arches with composite materials.” Comp. B, 42(5), 1164–1172.
Briccoli Bati, S., Fagone, M., and Rotunno, T. (2013). “Lower bound limit analysis of masonry arches with CFRP reinforcements: A numerical method.” J. Compos. Constr., 543–553.
Briccoli Bati, S., and Rovero, L. (2008). “Towards a methodology for estimating strength and collapse mechanism in masonry arches strengthened with fibre reinforced polymer applied on external surfaces.” Mater. Struct., 41(7), 1291–1306.
Briccoli Bati, S., Rovero, L., and Tonietti, U. (2007). “Strengthening masonry arches with composite materials.” J. Compos. Constr., 11(1), 33–41.
Capozucca, R. (2010). “Experimental FRP/SRP-historic masonry delamination.” Comp. Struct., 92(4), 891–903.
Carloni, C., and Subramaniam, K. V. (2012). “FRP-masonry debonding: Numerical and experimental, study of the role of mortar joints.” J. Compos. Constr., 581–589.
Consiglio Nazionale Delle Ricerche (CNR). (2012). “Istruzioni per la Progettazione, l’Esecuzione ed il Controllo di Interventi di Consolidamento Statico mediante l’utilizzo di Compositi Fibrorinforzati. Materiali, strutture di c.a. e di c.a.p., strutture murarie.”, Rome, Italy (in Italian).
Ente Nazionale Italiano di Unificazione (UNI). (1976). “Prove sui calcestruzzi. Determinazione del modulo elastico secante a compression.”, Milan, Italy (in Italian).
Ente Nazionale Italiano di Unificazione (UNI). (2004). “Prodotti da costruzione di laterizio—Tavelloni, tavelle e tavelline—Terminologia, requisiti e metodi di prova.”, Milan, Italy (in Italian).
European Committee for Normalization. (2011). “Methods of test for masonry units—Part 1: Determination of compressive strength.”, Brussels, Belgium.
Faella, C., Camorani, G., Martinelli, E., and Paciello, S. O., and Perri, F. (2012). “Bond beahavior of FRP strips glued on masonry: Experimental investigation and empirical formulation.” J. Constr. Build. Mater., 31, 353–363.
Fedele, R., and Milani, G. (2010). “A numerical insight into the response of masonry reinforced by FRP strips. The case of perfect adhesion.” Comp. Struct., 92(10), 2345–2357.
Fedele, R., and Milani, G. (2011). “Three-dimensional effects induced by FRP-from-masonry delamination.” Comp. Struct., 93(7), 1819–1831.
Focacci, F. (2008). Rinforzo delle murature con materiali compositi, Dario Flaccovio, Palermo, Italy (in Italian).
Ghiassi, B., Marcari, G., Oliveira, D. V., and Lourenço, P. B. (2012). “Numerical analysis of bond behavior between masonry bricks and composites materials.” Eng. Struct., 43, 210–220.
Grande, E., Imbimbo, M., and Sacco, E. (2011). “Simple model bond behavior of masonry elements strengthened with FRP.” J. Compos. Constr., 354–363.
Oliveira, D. V., Basilio, I., and Lourenço, P. B. (2011). “Experimental bond behavior of FRP sheets glued on brick masonry.” J. Compos. Constr, 32–41.
Rovero, L., Focacci, F., and Stipo, G. (2013). “Structural behavior of arch models strengthened using FRP strips of different lengths.” J. Compos. Constr., 249–258.
Triantafillou, T. C. (1998). “Strengthening of masonry structures using epoxy-bonded FRP laminates.” J. Compos. Constr., 96–104.
Valluzzi, M. R., et al. (2012). “Round robin test for composite-to-brick shear bond characterization.” Mater. Struct., 45(12), 1761–1791.
Valluzzi, M. R., Valdemarca, M., and Modena, C. (2001). “Behavior of brick masonry vaults strengthened by FRP laminates.” J. Compos. Constr., 163–169.
Yao, J., Teng, J. G., and Chen, J. F. (2005). “Experimental study on FRP-to-concrete bonded joints.” Compos. Part B, 36(2), 99–113.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Mar 24, 2014
Accepted: Aug 11, 2014
Published online: Sep 15, 2014
Discussion open until: Feb 15, 2015
Published in print: Jun 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.