Structural Performance of CFRP-Strengthened RC Slabs in a Corrosive Environment
Publication: Journal of Composites for Construction
Volume 14, Issue 6
Abstract
This study was undertaken to address the effect of the main steel corrosion on the structural performance of RC slabs strengthened with carbon-fiber-reinforced polymer (CFRP) strips and exposed to a corrosive environment. A total of eight specimens were constructed and tested under monotonic static loading. Three specimens were CFRP-strengthened and corroded, three specimens were CFRP-strengthened and kept at room temperature, one specimen was unstrengthened and corroded, and one specimen was neither strengthened nor corroded. Three different strengthening schemes were applied: (1) externally bonded CFRP strips; (2) externally bonded CFRP strips provided with CFRP anchors; and (3) near surface mounted (NSM) CFRP strips. During the corrosion process, the specimens were placed in a small tank filled with sodium chloride (NaCl) solution concentration (3%) which covered only the slabs’ bottom third, and corrosion was induced by means of an impressed current. The corrosion process lasted for 20 days, and the average mass loss of the main steel reinforcement due to corrosion was 9%. Following corrosion, the specimens were tested under four-point bending. The experimental results showed that the increase in flexural capacity achieved using the three strengthening schemes were significantly reduced due to corrosion of the main steel. The recorded reductions in flexural strength gains for the CFRP-strengthened corroded slabs relative to the gains for the strengthened uncorroded slabs were about 55, 38, and 41% for the externally bonded CFRP system without anchors, externally bonded CFRP with anchors, and NSM-CFRP system, respectively.
Get full access to this article
View all available purchase options and get full access to this article.
References
Almusallam, A. A., Al-Gahtani, A. S., Aziz, A. R., Dakhil, H. F., and Rasheeduzzafar (1996). “Effect of reinforcement corrosion on flexural behavior of concrete slabs.” J. Mater. Eng., 8(3), 123–127.
Al-Sulaimani, G. J., Kaleemullah, M., Basunbul, I. A., and Rasheeduzzafar (1990). “Influence of corrosion and cracking on bond behaviour of reinforced concrete members.” ACI Struct. J., 87(2), 220–231.
American Concrete Institute (ACI). (2002). “Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures.” ACI 440.2 R-02, Farmington Hills, Mich.
Andrade, C., Alonso, C., and Molina, F. A. (1993). “Cover cracking as a function of rebar corrosion. Part I: Experimental test.” J. Mater. Struct., 26, 453–464.
Badawi, M., and Soudki, K. (2005). “Control of corrosion-induced damage in reinforced concrete beams using carbon fiber-reinforced polymer laminates.” J. Compos. Constr., 9(2), 195–201.
Bentur, A., Diamond, S., and Berke, N. S. (1997). Steel corrosion in concrete, E & FN Spon, London.
Broomfield, J. P. (1997). Corrosion of steel in concrete: Understanding, investigation and repair, E & FN Spon, London.
Cabrera, J. G. (1996). “Deterioration of concrete structures due to reinforcement steel corrosion.” Cem. Concr. Compos., 18, 47–59.
Garcez, M., Meneghetti, L., and Filho, L. (2008). “Structural performance of RC beams poststrengthened with carbon, aramid, and glass FRP systems.” J. Compos. Constr., 12(5), 522–530.
Hassan, T., and Rizkalla, S. (2003). “Investigation of bond in concrete structures strengthened with near surface mounted carbon fiber reinforced polymer strips.” J. Compos. Constr., 7(3), 248–257.
Kunieda, M., Okude, N., Shiotani, T., and Nakamura, H. (2008). “Flexural failure of RC beams with rebar corrosion and damage evaluation by acoustic emission.” Proc., 19th Int. Conf. on Progress in Acoustic Emission, Kyoto Univ., Kyoto, 325–332.
Masoud, S., Soudki, K., and Topper, T. (2001). “CFRP-strengthened and corroded RC beams under monotonic and fatigue loads.” J. Compos. Constr., 5(4), 228–236.
Mufti, A. A., Newhook, J. P., and Tadros, G. (1996). “Deformability versus ductility in concrete in beams with FRP reinforcement.” Proc., 2nd Int. Conf. on Advanced Composite Materials in Bridges and Structures, Canadian Society for Civil Engineering, Montreal, 189–199.
Orton, S. L., Jirsa, J. O., and Bayrak, O. (2008). “Design considerations of carbon fiber anchors.” J. Compos. Constr., 12(6), 608–616.
Soudki, K. S., El-Salakawy, E., and Craig, B. (2007). “Behavior of CFRP strengthened reinforced concrete beams in corrosive environment.” J. Compos. Constr., 11(3), 291–298.
Val, D. V. (2007). “Deterioration of strength of RC beams due to corrosion and its influence on beam reliability.” J. Struct. Eng., 133(9), 1297–1306.
Val, D. V., and Melchers, R. E. (1997). “Reliability of deteriorating RC slab bridges.” J. Struct. Eng., 123(12), 1638–1644.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Apr 10, 2009
Accepted: Apr 11, 2010
Published online: Apr 19, 2010
Published in print: Dec 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.