Performance of Composite Twin I-Girder Bridges with Fatigue-Induced Cracks
Publication: Journal of Bridge Engineering
Volume 22, Issue 9
Abstract
An experimental program was performed to investigate the postfracture performance of composite twin I-girder bridges in the fatigue crack condition. An intact specimen and a damaged specimen were tested under one-point load to understand the effect of fracture on the bridge response and safety. In addition, nonlinear numerical analyses were performed to study the mechanical behavior of the models. The results showed that the fracture of the entire web and bottom flange at the midspan section can result in a considerable increase in the shear strain on the studs near the middle section. The fracture of the bridge in the midspan section governed by bending failure is found to be most critical in terms of the remaining load-carrying capacity, and the fracture near the support location governed by shear failure is found to be brittle, which can result in a sudden collapse of the bridge system. The effects of the fatigue crack on the safety of the composite twin I-girder bridge can be mitigated by using a continuous span instead of a simply supported span or by using a stronger and thicker concrete slab.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was sponsored by Waseda University Grant for Special Research Project-A (key funding, Project 2015A-503). The financial support is gratefully acknowledged.
References
AASHTO. (2012). AASHTO LRFD bridge design specifications, 6th Ed., Washington, DC.
ASCE Committee on Fatigue and Fracture Reliability. (1982). “Fatigue reliability: Introduction.” J. Struct. Div., 108(1), 3–23.
CEN (European Committee for Standardization). (1992). “Design of concrete structures.” Eurocode 2, Brussels, Belgium.
Connor, R. J., Dexter R., and Mahmoud H. (2005). “Inspection and management of bridges with fracture critical details.” NCHRP Synthesis 354, National Cooperative Highway Research Program, Washington, DC.
Daniels, J. H., Kim, W., and Wilson J. L. (1998). “Recommended guidelines for redundancy design and rating of two-girder steel bridges.” NCHRP Rep. 319, National Cooperative Highway Research Program, Washington, DC.
Deng, L., Wang, W., and Yu, Y. (2016). “State-of-the-art review on the causes and mechanisms of bridge collapse.” J. Perform. Constr. Facil., 04015005.
DIANA 9.4.4. [Computer software] DIANA FEA BV, Delft, Netherlands.
Dörr, K. (1980). “Ein Beitrag zur Berechnung von Stahlbetonscheiben unter besonderer Berücksichtigung des Verbundverhaltens.” Ph.D. thesis, Univ. of Darmstadt, Darmstadt, Germany (in German).
Fujino, Y. (2006). “Steel bridges in Japan—Current circumstances and future tasks.” Steel Construction Today and Tomorrow, 15, 1–19.
Ghosn, M., and Moses, F. (1998). “Redundancy in highway bridge superstructure.” NCHRP Rep. 406, National Cooperative Highway Research Program, Washington, DC.
Ghosn, M., Moses, F., and Frangopol, D. M. (2010). “Redundancy and robustness of highway bridge superstructures and substructures.” Struct. Infrastruct. Eng., 6(1–2), 257–278.
Ghosn, M., and Yang, J. (2014). “Bridge system safety and redundancy.” NCHRP Rep. 776, National Cooperative Highway Research Program, Washington, DC.
Haghani, R., Al-Emrani, M., and Heshmati, M. (2012). “Fatigue-prone details in steel bridges.” Buildings, 2(4), 456–476.
Hendawi, S., and Frangopol, D. M. (1994). “System reliability and redundancy in structural design and evaluation.” Struct. Saf., 16(1–2), 47–71.
Hunley, C., and Harik, I. (2012). “Structural redundancy evaluation of steel tub girder bridges.” J. Bridge Eng., 481–489.
JRA (Japan Road Association). (2012). Specifications for highway bridges. Part I, Common, Tokyo.
JSCE (Japan Society of Civil Engineers). (2002). Standard specification for concrete structures, Tokyo.
JSCE (Japan Society of Civil Engineers). (2007). Standard specifications for steel and composite structures, Tokyo.
Kakiichi, T., Ishikawa, T., Ojio, T., and Yamada, K. (2011). “Stress measurement and fatigue durability evaluation of plate girder web detail at cross beam.” JSCE J. Struct. Eng., 57A, 852–859 (in Japanese).
Lam, H., Lin, W., and Yoda, T. (2014). “Effect of bracing systems on redundancy of three-span composite twin I-girder bridge.” JSCE J. Struct. Eng., 60A, 59–69.
Lin, W., Yoda, T., Kumagai, Y., and Saigyo, T. (2013). “Numerical study on post-fracture redundancy of the two-girder steel-concrete composite highway bridges.” Int. J. Steel Struct., 13(4), 671–681.
Liu, W. D., Ghosn, M., Moses, F., and Neuenhoffer, A. (2001). “Redundancy in highway bridge substructures.” NCHRP Rep. 458, National Cooperative Highway Research Program, Washington, DC.
Nagai, M. (2006). Steel bridges in Japan—Rationalized design methods in Japan, 15, Japan Society of Steel Construction, Tokyo.
Nakasu, M., and Iwatate, J. (1996). “Fatigue experiment on bond between concrete and reinforcement.” Trans. JSCE, 426, 852–853.
Neuman, B. J. (2009). “Evaluating the redundancy of steel bridges: Full-scale destructive testing of a fracture critical twin box-girder steel bridge.” M.S. thesis, Univ. of Texas at Austin, Austin, TX.
Okada, J., Yoda, T., and Lebet, J. P. (2006). “A study of the grouped arrangement of stud connectors on the shear strength.” Struct. Eng. Earthquake Eng., 23(1), 75s–89s.
Ollgaard, J. G., Slutter, R. G., and Fisher, J. W. (1971). “Shear strength of stud connectors in lightweight and normal weight concrete.” Eng. J. AISC, 8(2), 55–64.
Samaras, V., Sutton, J., Williamson, E., and Frank, K. (2012). “Simplified method for evaluating the redundancy of twin steel box-girder bridges.” J. Bridge Eng., 470–480.
Selby, R. G., and Vecchio, F. J. (1993). “Three-dimensional constitutive relations for reinforced concrete.” Tech. Rep. 93-02, Univ. of Toronto, Toronto.
Tamakoshi, T., Yoshida, Y., Sakai, Y., and Fukunaga, S. (2006). “Analysis of damage occurring in steel plate girder bridges on national roads in Japan.” Public Work Research Institute of Japan, Tsukuba, Japan.
Vecchio, F. J., and Collins, M. P. (1986). “The modified compression field theory for reinforced concrete elements subjected to shear.” ACI J., 83(2), 219–231.
Veggeberg, K. (2011). “Data acquisition for a bridge collapse test.” Proc., Structural Dynamics, Vol. 3, Springer, New York, 1313–1324.
Wardhana, K., and Hadipriono, F. (2003). “Analysis of recent bridge failures in the united states.” J. Perform. Constr. Facil., 144–150.
Yamada, Y., Pengphon, S., Miki, C., Ichikawa, A., and Irube, T. (2001). “Shear strength of slab-anchor and adhesion fixing a non-composite girder bridge’s slab.” JSCE J. Struct. Eng., 47A, 1161–1168 (in Japanese).
Information & Authors
Information
Published In
Copyright
© 2017 American Society of Civil Engineers.
History
Received: Nov 30, 2016
Accepted: Apr 10, 2017
Published online: Jul 7, 2017
Published in print: Sep 1, 2017
Discussion open until: Dec 7, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.