Gurney-Flap Drag Penalty Reduction with a DBD Plasma Actuator
Publication: Journal of Aerospace Engineering
Volume 30, Issue 5
Abstract
The present research proposed a method to reduce the Gurney-flap drag penalty with a dielectric barrier discharge (DBD) plasma actuator, which was mounted in front of the Gurney flap to generate a countercurrent wall jet. The research was based on numerical simulation, which was performed on a NACA 0012 airfoil with Gurney-flap heights (h) of 1, 2, and 3%c at . According to the simulation results, the wall jet was able to decrease the additional drag on the Gurney flap by lowering the upstream pressure of the Gurney flap without disturbing the flow field downstream of the Gurney flap. The drag reduction effect was more obvious at low angles of attack and small Gurney-flap height, and a drag reduction of 15% was achieved at with 1%c flap height. This method also lowered total lift, but it was not strong enough to impair the high-lift property of the Gurney flap. For all tested Gurney-flap heights, the lift-drag ratios under low to moderate were enhanced by this approach. Comparing with the clean airfoil, a 12% increment of lift-drag ratio was obtained at cruise with plasma control at flap height.
Get full access to this article
View all available purchase options and get full access to this article.
References
Cole, J. A., Vieira, B. A. O., Coder, J. G., Premi, A., and Maughmer, M. D. (2013). “Experimental investigation into the effect of gurney flaps on various airfoils.” J. Aircr., 50(4), 1287–1294.
Corke, T., and Matlis, E. (2000). “Phased plasma arrays for unsteady flow control.” Fluids 2000 Conf. and Exhibit, Fluid Dynamics and Co-located Conf., American Institute of Aeronautics and Astronautics, Reston, VA.
Feng, L. H., Choi, K. S., and Wang, J. J. (2015). “Flow control over an airfoil using virtual Gurney flaps.” J. Fluid Mech., 767, 595–626.
Feng, L. H., and Wang, J. J. (2010). “Circular cylinder vortex-synchronization control with a synthetic jet positioned at the rear stagnation point.” J. Fluid Mech., 662, 232–259.
FLUENT [Computer software]. Ansys, Inc., Canonsburg, PA.
Gaitonde, D. V, Visbal, M. R., and Roy, S. (2005). “Control of flow past a wing section with plasma-based body forces.” 36th AIAA Plasmadynamics and Lasers Conf., American Institute of Aeronautics and Astronautics, Reston, VA.
Grundmann, S., Klumpp, S., and Tropea, C. (2007). “Experimental and numerical investigations of boundary-layer influence using plasma-actuators.” Active flow control, Springer, Berlin, 56–68.
He, X., Wang, J. J., Yang, M. Q., Ma, D. L., Yan, C., and Liu, P. Q. (2016). “Numerical simulation of Gurney flap on SFYT15 thick airfoil.” Theor. Appl. Mech. Lett., 6(6), 286–292.
ICEM [Computer software]. Ansys, Inc., Canonsburg, PA.
Jayaraman, B., Cho, Y.-C., and Shyy, W. (2007). “Modeling of dielectric barrier discharge plasma actuator.” 38th Plasmadynamics and Lasers Conf., Fluid Dynamics and Co-Located Conf., American Institute of Aeronautics and Astronautics, Reston, VA.
Jayaraman, B., and Shyy, W. (2008). “Modeling of dielectric barrier discharge-induced fluid dynamics and heat transfer.” Prog. Aerosp. Sci., 44(3), 139–191.
Jeffrey, D., Zhang, X., and Hurst, D. W. (2000). “Aerodynamics of Gurney flaps on a single-element high-lift wing.” J. Aircr., 37(2), 295–301.
Jukes, T. N., Choi, K.-S., Johnson, G. A., and Scott, S. J. (2006). “Characterization of surface plasma-induced wall flows through velocity and temperature measurements.” AIAA J., 44(4), 764–771.
Jukes, T. N., Choi, K. S., Segawa, T., and Yoshida, H. (2008). “Jet flow induced by a surface plasma actuator.” Proc., Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering, SAGE, Thousand Oaks, CA, 347–356.
Li, Y., Wang, J., and Zhang, P. (2002). “Effects of gurney flaps on a NACA0012 airfoil.” Flow, Turbulence and Combustion, 68(1), 27–39.
Liebeck, R. H. (1978). “Design of subsonic airfoils for high lift.” J. Aircr., 15(9), 547–561.
Maughmer, M. D., and Bramesfeld, G. (2008). “Experimental investigation of gurney flaps.” J. Aircr., 45(6), 2062–2067.
Rizzetta, D., and Visbal, M. (2007). “Numerical investigation of plasma-based flow control for a transitional highly-loaded low-pressure turbine.” 45th AIAA Aerospace Sciences Meeting and Exhibit, American Institute of Aeronautics and Astronautics, Reston, VA.
Rizzetta, D. P., and Visbal, M. R. (2011). “Numerical investigation of plasma-based control for low-Reynolds-number airfoil flows.” AIAA J., 49(2), 411–425.
Roth, J. R., Sherman, D. M., and Wilkinson, S. P. (1998). “Boundary layer flow control with a one atmosphere uniform glow discharge surface plasma.” 36th AIAA Aerospace Sciences Meeting and Exhibit, American Institute of Aeronautics and Astronautics, Reston, VA.
Roth, J. R., Sherman, D. M., and Wilkinson, S. P. (2000). “Electrohydrodynamic flow control with a glow-discharge surface plasma.” AIAA J., 38(7), 1166–1172.
Schatz, M., Günther, B., and Thiele, F. (2004). “Computational modeling of the unsteady wake behind gurney-flaps.” 2nd AIAA Flow Control Conf., Fluid Dynamics and Co-Located Conf., American Institute of Aeronautics and Astronautics, Reston, VA.
Shyy, W., Jayaraman, B., and Andersson, A. (2002). “Modeling of glow discharge-induced fluid dynamics.” J. Appl. Phys., 92(11), 6434–6443.
Strelets, M. (2001). “Detached eddy simulation of massively separated flows.” 39th AIAA Aerospace Sciences Meeting and Exhibit, American Institute of Aeronautics and Astronautics, Reston, VA.
Traub, L. W., and Agarwal, G. (2008). “Aerodynamic characteristics of a Gurney/jet flap at low Reynolds numbers.” J. Aircr., 45(2), 424–429.
Traub, L. W., Miller, A., and Rediniotis, O. (2006). “Preliminary parametric study of gurney flap dependencies.” J. Aircr., 43(4), 1242–1244.
Troolin, D. R., Longmire, E. K., and Lai, W. T. (2006). “Time resolved PIV analysis of flow over a NACA 0015 airfoil with Gurney flap.” Experiments Fluids, 41(2), 241–254.
Van Dyken, R., McLaughlin, T. E., and Enloe, C. L. (2004). “Parametric investigations of a single dielectric barrier plasma actuator.” 42nd AIAA Aerospace Sciences Meeting and Exhibit, American Institute of Aeronautics and Astronautics, Reston, VA.
Visbal, M., Gaitonde, D., and Roy, S. (2006). “Control of transitional and turbulent flows using plasma-based actuators.” 36th AIAA Fluid Dynamics Conf. and Exhibit, Fluid Dynamics and Co-Located Conf., American Institute of Aeronautics and Astronautics, Reston, VA.
Wang, J. J., Choi, K. S., Feng, L. H., Jukes, T. N., and Whalley, R. D. (2013). “Recent developments in DBD plasma flow control.” Prog. Aerosp. Sci., 62, 52–78.
Wang, J. J., Li, Y. C., and Choi, K. S. (2008). “Gurney flap-lift enhancement, mechanisms and applications.” Prog. Aerosp. Sci., 44(1), 22–47.
Zhang, P., Yan, B., Liu, A., and Wang, J. (2010a). “Numerical simulation on plasma circulation control airfoil.” AIAA J., 48(10), 2213–2226.
Zhang, P. F., Liu, A. B., and Wang, J. (2010b). “Flow structures in flat plate boundary layer induced by pulsed plasma actuator.” Sci. China Technol. Sci., 53(10), 2772–2782.
Zhang, P. F., Liu, A. B., and Wang, J. J. (2009). “Aerodynamic modification of a NACA 0012 airfoil by trailing-edge plasma Gurney flap.” AIAA J., 47(10), 2467–2474.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Oct 19, 2016
Accepted: Mar 27, 2017
Published online: Jul 7, 2017
Published in print: Sep 1, 2017
Discussion open until: Dec 7, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.