Numerical Study for Active Flow Control Using Dielectric Barrier Discharge Actuators
Publication: Journal of Aerospace Engineering
Volume 30, Issue 5
Abstract
This paper presents a numerical investigation of active aerodynamic flow control on an airfoil by dielectric barrier discharge plasma actuators. Simplified Maxwell equations for an electric field coupled with Navier-Stokes equations and turbulence models for fluid are implemented to simulate the wall jet flow induced by the body force attributable to the dielectric barrier discharge plasma actuators. The numerical model is validated with the laboratory results in the quiescent flow. The simulated maximum velocity in the quiescent environment is proportional to the applied voltage. The dielectric barrier discharge plasma actuators are also demonstrated to significantly influence the velocity profiles. The numerical model is applied to an airfoil with Reynolds number equal to , and the peak-to-peak voltage varies from 5 to 18 kV. The flow separation is delayed or removed to some extent by dielectric barrier discharge plasma at high angles of attack. The dielectric barrier discharge increases the lift coefficient, reduces the drag coefficient, and finally improves the performance of the airfoil.
Get full access to this article
View all available purchase options and get full access to this article.
References
ANSYS Fluent version 14.0 [Computer software]. ANSYS, Canonsburg, PA.
Baughn, J. W., et al. (2006). “Momentum transfer for an aerodynamic plasma actuator with an imposed boundary layer.” 44th AIAA Aerospace Sciences Meeting and Exhibit, AIAA, Reston, VA, 168.
Benard, N., Braud, P., and Jolibois, J. (2008). “Airflow reattachment along a NACA 0015 airfoil by surface SDBD actuator-time resolved PIV investigation.” 4th Flow Control Conf., Curran Associates Group, Miami, 4202.
Bouchmal, A. (2011). “Modeling of dielectric-barrier discharge actuator-implementation, validation and generalization of an electrostatic model.” M.Sc. thesis, Delft Univ. of Technology, Delft, Netherlands.
Corke, T. C., He, C., and Patel, M. (2004). “Plasma flaps and slats: An application of weakly-ionized plasma actuators.” J. Aircraft, 46(3), 864–873.
Do, H., Kim, W., Mungal, M. O., and Cappelli, M. A. (2007). “Bluff body flow separation control using surface dielectric barrier discharges.” 45th AIAA Aerospace Sciences Meeting and Exhibit, AIAA, Reston, VA, 939.
Enloe, C. L., McLaughlin, T. E., VanDyken, R. D., Kachner, K. D., Jumper, E. J., and Corke, T. C. (2004). “Mechanisms and responses of a single dielectric barrier discharge plasma actuator: Plasma morphology.” AIAA J., 42(3), 589–594.
Font, G. I. (2006). “Boundary layer control with atmospheric plasma discharges.” AIAA J., 44(7), 1572–1578.
Gregory, J., Porter, C., Sherman, D., and McLaughlin, T. (2008). “Circular cylinder wake control using spatially distributed plasma forcing.” 4th Flow Control Conf., Curran Associates Group, Miami, 4198.
Huang, J., Corke, T. C., and Thomas, F. O. (2006). “Unsteady plasma actuators for separation control of low-pressure turbine blades.” AIAA J., 44(7), 1477–1487.
Jayaraman, B., Thakur, S., and Shyy, W. (2007). “Modeling of fluid dynamics and heat transfer induced by dielectric barrier plasma actuator.” J. Heat Transfer, 129(4), 517–525.
Kernighan, B. W., and Ritchie, D. M. (2008). “The C programming language, 1st Ed., Prentice Hall, Englewood Cliffs, NJ.
LeBeau, R. P., Reasor, D. A., Suzen, Y. B., Jacob, J. D., and Huang, P. G. (2007). “Abstract: Unstructured grid simulations of flow separation control using plasma actuators.” 18th AIAA Computational Fluid Dynamics Conf., Reston, VA.
Massines, F., Rabehi, A., Decomps, P., Ben Gadri, R., Segur, P., and Mayoux, C. (1998). “Experimental and theoretical study of a glow discharge at atmospheric pressure controlled by dielectric barrier.” J. Appl. Phys., 83(6), 2950–2957.
Orlov, D. M., Corke, T. C., and Patel, M. P. (2006). “Electric circuit model for aerodynamic plasma actuator,” 44th AIAA Aerospace Sciences Meeting and Exhibit, AIAA, Reston, VA, 1206.
Post, M. L., and Corke, T. C. (2004). “Separation control on a high angle of attack airfoil using plasma actuators.” AIAA J., 42(11), 2177–2184.
Post, M. L., and Corke, T. C. (2006). “Separation control using plasma actuators-dynamic stall vortex control on an oscillating airfoil.” AIAA J., 44(12), 3125–3135.
Reasor, D. A. (2007). “Numerical simulation of two flow control approaches for low Reynolds number applications.” Master’s thesis, Univ. of Kentucky, Lexington, KY, 171.
Rizzetta, D., and Visbal, M. (2009). “Large-eddy simulation of plasma-based control strategies for bluff body flow.” AIAA J., 47(3), 717–729.
Roth, J. R., Sherman, D. M., and Wilkinson, S. P. (1998). “Boundary layer flow control with a one atmosphere uniform glow discharge surface plasma.” Proc., 36th AIAA Aerospace Sciences Meeting and Exhibit, AIAA, Reston, VA, 328.
Schatzman, D., and Thomas, F. O. (2008). “Turbulent boundary layer separation control using plasma actuators.” 4th AIAA Flow Control Conf., Curran Associates, New York, 4199.
Shyy, W., Jayaraman, B., and Andersson, A. (2002). “Modeling of glow discharge-induced fluid dynamics.” J. Appl. Phys., 92(11), 6434–6443.
Suzen, Y. B., Huang, P. G., Jacob, J. D., and Ashipis, D. E. (2005). “Numerical simulation of plasma based flow control applications.” 35th AIAA Fluid Dynamics Conf. and Exhibit, 4633.
Thomas, F. O., Kozlov, A., and Corke, T. C. (2008). “Plasma actuators for cylinder flow control and noise reduction.” AIAA J., 46(8), 1921–1931.
Yoon, J. S., and Han, J. H. (2015). “Semi-empirical thrust model of dielectric barrier plasma actuator for flow control.” J. Aerosp. Eng., 04014041.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Feb 6, 2015
Accepted: Mar 13, 2017
Published online: Jun 1, 2017
Published in print: Sep 1, 2017
Discussion open until: Nov 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.