Experimental Investigation of Moisture Transfer between Concrete Foundation and Sill Plate
Publication: Journal of Architectural Engineering
Volume 22, Issue 3
Abstract
Precipitation is one of the most common moisture sources on which building designers focus. Water comes from both top down and bottom up. Although foundations are sometimes constructed out of pressure-treated lumber, generally they are constructed from poured concrete. In a wet climate zone, the foundation of a house is often under continuous contact with moisture, which is mainly caused by rundown rainwater, wet soil, a high water table, or a combination of all these factors. This causes rot growth and decay of the wood-frame structure as it sits constantly on the damp foundation concrete. In this research, moisture transfer between concrete and wood is investigated under three different scenarios: a case with direct wood and concrete contact and two cases with different moisture barriers between the two materials. The moisture barrier materials considered in this study are the damp-proofing layer and sill plate gasket. The moisture transfer processes in these three cases are investigated in a field experimental setting using a customized experimental setup for 1 year. The experimental data suggest that using damp proofing and a sill gasket helps restrict moisture transfer.
Get full access to this article
View all available purchase options and get full access to this article.
References
Agilent VEE Pro 9.2 [Computer software] Agilent Technologies, Inc., Santa Clara, CA.
Boardman, C. R., Glass, S. V., and Carll, C. G. (2010). “Estimating foundation water vapor release using a simple moisture balance and AIM-2: Case study of a contemporary wood-frame house.” Proc., Thermal Performance of the Exterior Envelopes of Whole Buildings XI Int. Conf., American Society of Heating, Refrigerating and Air-Conditioning Engineers, Atlanta.
Carll, C. G., Boardman, C. R., and Olson, C. L. (2010). “Case study: Performance of a house built on a treated wood foundation system in a cold climate.” Proc., Thermal Performance of Exterior Envelopes of Whole Buildings XI, American Society of Heating, Refrigerating and Air-Conditioning Engineers, Atlanta.
Christian, J. E. (2009). “Moisture sources.” Moisture control in buildings, 2nd Ed., H. R. Trechsel and M. T. Bomberg, eds., ASTM International, West Conshohocken, PA.
Fugler, D. (1996). “Molds in finished basements.” Final Rep., Canadian Mortgage and Housing Corporation, Ottawa, 1–14.
Glass, S. V., and TenWolde, A. (2007). “Review of in-service moisture and temperature conditions in wood-frame buildings.” General Technical Rep. FPL-GTR-174, U.S. Dept. of Agriculture, Forest Service, Washington, DC, 53.
Harderup, L.-E. (1991). “Concrete slab on the ground and moisture control: Verification of some methods to improve the moisture conditions in the foundation.” Doctoral dissertation, Byggnadsfysik LTH, Lunds Tekniska Högskola, Lund, Sweden, 174.
IRC (International Residential Code). (2012). Building planning, R317.1 location required. International Code Council, Washington, DC.
Janssen, H., Carmeliet, J., and Hens, H. (2002). “The influence of soil moisture in the unsaturated zone on the heat loss from buildings via the ground.” J. Build. Phys., 25(4), 275–297.
Janssen, H., Carmeliet, J., and Hens, H. (2004). “The influence of soil moisture transfer on building heat loss via the round.” Build. Environ., 39(7), 825–836.
Kurnitski, J. (2000). “Crawl space air change, heat and moisture behaviour.” Energy Build., 32(1), 19–39.
Kurnitski, J. (2001). “Ground moisture evaporation in crawl spaces.” Build. Environ., 36(3), 359–373.
Kurnitski, J., and Matilainen, M. (2000). “Moisture conditions of outdoor air-ventilated crawl spaces in apartment buildings in a cold climate.” Energy Build., 33(1), 15–29.
Kusuda, T., and Bean, J. W. (1984). “Simplified methods for determining seasonal heat loss from uninsulated slab-on-grade floors.” ASHRAE Trans., 90(1B), 611–643.
Leivo, V., and Rantala, J. (2006). “Seasonal change in water content of subsoil beneath old slab-on-ground structures in Finland.” J. Build. Phys., 29(4), 301–312.
Leivo, V., and Rantala, J. (2008). “Moisture behaviour of slab-on-ground structures in operating conditions: Steady-state analysis.” Constr. Build. Mater., 22(4), 526–531.
Moses, C. S., and Scheffer, T. C. (1962). “Survey of houses for moisture content and decay in wood members.” Report WP–60, U.S. Dept. of Agriculture, Forest Service, Forest Products Laboratory, Federal Housing Administration, Madison, WI.
NBCC (National Building Code of Canada). (2010). Associate Committee on the National Building Code, National Research Council of Canada, Ottawa.
Onysko, D., Rijn, G. V., Gates, D., and Fugler, D. (2005).“Remediating high moisture levels in the wall cavities of preserved wood foundations.” 10th Canadian Conf. on Building Science and Technology, Building Envelope Council Ottawa Region, Ottawa.
Rantala, J., and Leivo, V. (2009). “Heat, air, and moisture control in slab-on-ground structures.” J. Build. Phys., 32(4), 335–353.
Rees, S. W., Zhou, Z., and Thomas, H. R. (2007). “Ground heat transfer: A numerical simulation of a full-scale experiment.” Build. Environ., 42(3), 1478–1488.
Saber, H. H., Maref, W., and Swinton, M. C. (2011). “Numerical investigation of thermal response of basement wall systems with low emissivity material and furred airspace.” 13th Canadian Conf. on Building Science and Technology, Manitoba Building Envelope Council, Winnipeg, MB, Canada, 1–13.
Santos, G. H., and Mendes, N. (2006). “Simultaneous heat and moisture transfer in soils combined with building simulation.” Energy Build., 38, 303–314.
Scheffer, T. C., and Moses, C. S. (1993). “Survey of moisture content in houses for evidence of decay susceptibility.” For. Prod. J., 43(11/12)45–51.
Tariku, F., and Ge, H. (2010). “Moisture response of sheathing board in conventional and rain-screen wall systems with shiplap cladding.” J. Test. Eval., 39(3), 381–388.
Tariku, F., and Simpson, Y. (2015). “Experimental investigation of the wetting and drying potential of wood frame walls subjected to vapor diffusion and wind-driven rain loads.” Build Environ., 92, 368–379.
Toyoumi, A., Horisawa, S., Yoshimura, T., Doi, S., and Imamura, Y. (2010). “The effect of different foundation systems on the fungal flora in the crawl space of a new wooden Japanese house.” Build. Environ., 45(4), 1054–1060.
Tsongas, G. (1994). “Case studies of moisture problems in residences.” Moisture control in buildings, ASTM Manual Series: MNL 18, H. R. Trechsel, ed., Philadelphia, 254–280.
Yost, N., and Lstiburek, J. (2002). “Basement insulation systems.” Research Rep. BA-0202, Building Science Corporation, Westford, MA.
Information & Authors
Information
Published In
Journal of Architectural Engineering
Volume 22 • Issue 3 • September 2016
Copyright
© 2016 American Society of Civil Engineers.
History
Received: May 29, 2015
Accepted: Dec 9, 2015
Published online: Feb 24, 2016
Discussion open until: Jul 24, 2016
Published in print: Sep 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.