Analysis of Integrated Radiant Slab Heating and Cooling Systems for Residential Buildings
Publication: Journal of Architectural Engineering
Volume 22, Issue 1
ABSTRACT
This paper presents a simulation environment developed to assess the energy use specific to integrated radiant heating and cooling systems. The developed simulation environment combines a transient finite difference solution for the two-dimensional model of an integrated radiant slab heating and cooling system with a resistance capacitance (RC) thermal network model for a multifloor building. The developed model of the integrated radiant system is able to account for thermal bridge effects on the energy performance of multifloor buildings. The predictions of the developed simulation environment are verified against those obtained from a detailed whole-building energy simulation tool under specific conditions. The developed simulation environment is then used to investigate the impact of thermal bridge effects on the performance of an integrated radiant heating and cooling system. Thermal bridging can affect significantly the energy performance of the integrated radiant systems by up to 8%. Several insulation configurations have been evaluated to assess the performance of the integrated radiant systems during both heating and cooling seasons for three U.S. locations: Chicago, IL; Golden, CO; and San Francisco, CA. A combination of horizontal and edge insulations is the most effective regardless of the building location. The most effective insulation configuration achieves up to 30% in heating energy savings and 35% in cooling energy savings compared with the building with no insulation.
Get full access to this article
View all available purchase options and get full access to this article.
References
DOE-2.1E-053 [Computer software]. Lawrence Berkeley Laboratory, Berkeley, CA.
Arasteh, D., Hokler, C., and Griffith, B. (2010). “Modeling windows in energy plus with simple performance indices.” Technical Rep. LBNL-2804E, Lawrence Berkeley National Laboratory, Berkeley, CA.
ASHRAE (American Society of Heating, Refrigerating and Air-Conditioning Engineers). (2005). Handbook of fundamentals, Atlanta.
ASHRAE (American Society of Heating, Refrigerating and Air-Conditioning Engineers). (2008). Handbook of systems and equipment, Atlanta.
Bergman, T. L., Lavine, A. S., Incorpera, F.P., and DeWitt, D. P. (2006). Fundamentals of heat and mass transfer, 6th Ed., John Wiley, New York.
Braun, J. E., and Chaturvedi, N. (2002). “An inverse gray-box model for transient building load prediction.” HVAC&R Res., 8(1), 73–99.
Çengel, Y. A., Turner, R. H., and Cimbala, J. M. (2001). Fundamentals of thermal-fluid sciences, McGraw-Hill, New York.
Conroy, C. L., and Mumma, S. A. (2001). “Ceiling radiant cooling panels as a viable distributed parallel sensible cooling technology integrated with dedicated outdoor air systems/discussion.” ASHRAE Trans., 107(1), 578.
DOE (2010). EnergyPlus Engineering Reference: The reference to EnergyPlus calculations, Washington, DC.
Fux, S. F., Ashouri, A., Benz, M. J., and Guzzella, L. (2014). “EKF based self-adaptive thermal model for a passive house.” Energy Build., 68, 811–817.
Ghatti, V. (2003). “Experimental validation of the EnergyPlus low-temperature radiant simulation.” ASHRAE Trans., 109(2), 614–623.
Ho, S. Y., Hayes, R. E., and Wood, R. K. (1995). “Simulation of the dynamic behaviour of a hydronic floor heating system.” Heat Recovery Sys. CHP, 15(6), 505–519.
Holman, J. P. (1997). Heat transfer, McGraw-Hill, New York.
Hottel, H. C., and Sarofim, A. F. (1967). Radiative transfer, McGraw-Hill, New York.
Kreith F., and Bohn M. S. (2001). Principle of heat transfer, 6th Ed., Cengage Learning, Independence, KY.
Laouadi, A. (2004). “Development of a radiant heating and cooling model for building energy simulation software.” Build. Environ., 39(4), 421–431.
Mumma, S. A. (2001). “Ceiling panel cooling systems.” ASHRAE J., 43(11), 28–32.
Mumma, S. A. (2002). “Chilled ceilings in parallel with dedicated outdoor air systems: addressing the concerns of condensation, capacity, and cost.” ASHRAE Trans., 108(2), 220–231.
Olesen, B. (2008). “Radiant floor cooling systems.” ASHRAE J., 50(9), 16–22.
Patankar, S. (1980). Numerical heat transfer and fluid flow, CRC Press, Boca Raton, FL.
Seem, J. E. (1987). “Modeling of heat transfer in buildings.” Doctoral dissertation, Wisconsin Univ., Madison, WI.
Stetiu, C. (1998). “Radiant cooling in US office buildings: Towards eliminating the perception of climate-imposed barriers.” Rep. No. LBNL-41275, Lawrence Berkeley National Laboratory, Berkeley, CA.
Strand, R. K., and Pedersen, C. O. (1997). “Implementation of a radiant heating and cooling model into an integrated building energy analysis program.” ASHRAE Trans., 103(Pt. 1), 949–958.
Uiuc, L. (2005). EnergyPlus engineering reference: The reference to EnergyPlus calculations, U.S. Department of Energy, Washington, DC.
Walton, G. N. (1983). Thermal analysis research program reference manual, National Bureau of Standards, U.S. Department of Commerce, Washington, DC.
Wang, S., and Xu, X. (2006). “Parameter estimation of internal thermal mass of building dynamic models using genetic algorithm.” Energy Convers. Manage., 47(13), 1927–1941.
Watson, R. D., and Chapman, K. S. (2002). Radiant heating and cooling handbook, McGraw-Hill, New York.
Weitzman, P., Kragh, J., Roots, P., and Svendesn, S. (2005). “Modeling floor heating systems using a validated two-dimensional ground-coupled numerical model.” Build. Environ., 40, 153–163.
Yazdanian, M., and Klems, J. H. (1994). “Measurement of the exterior convective film coefficient for windows in low-rise buildings.” ASHRAE Trans., 100(1), 1087.
Zhang, Z. L. (2001). “Temperature control strategies for radiant floor heating systems.” Doctoral dissertation, Concordia Univ., Quebec.
Information & Authors
Information
Published In
Journal of Architectural Engineering
Volume 22 • Issue 1 • March 2016
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Feb 4, 2015
Accepted: Jul 27, 2015
Published online: Dec 3, 2015
Published in print: Mar 1, 2016
Discussion open until: May 3, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.