Systems Analysis of Pump-and-Treat Groundwater Remediation
Publication: Practice Periodical of Hazardous, Toxic, and Radioactive Waste Management
Volume 7, Issue 3
Abstract
The design and operation of complex remediation projects can often benefit from an analysis from a systems perspective, that is one in which the various components of the system are viewed holistically, and a specific objective and associated constraints are articulated. This paper reports on such an analysis of a multiyear pump-and-treat scheme for removing light nonaqueous phase liquid from groundwater with subsequent treatment of the water for removal or destruction of the sum of benzene, toulene, ethylbenzene, and xylene concentrations, polynuclear aromatic hydrocarbon, carbon oxygen demand, particulate iron, and suspended solids prior to discharge. The treatment train consists of eight unit processes linked in series. The objective is to minimize total net present value of operating costs over the projected life of the treatment facility given constraints on permitted discharge limits, and the performance characteristics and requirements of the contaminant removal processes. Results indicate that the system is especially sensitive to flow rate, fixed costs of operation, and the projected quantity of oil to be recovered prior to disengagement, with the greatest cost penalty existing for underutilization of the treatment facility. Matching pumping rate with treatment capacity is seen to be the most important design factor in minimizing overall costs, however various options available to management to improve upon non-optimal conditions are discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
Alt, C. (1989). “Centrifuges for sludge treatment.” Water, wastewater and sludge filtration, S. Vigneswaran and R. Ben Aim eds., CRC Press, Boca Raton, Fla.
American Petroleum Institute (API). (1969). Manual on disposal of refinery wastes, 1st Ed., American Petroleum Institute, Washington D.C.
Crittenden, J. C., Speth, T. F., Hand, D. W., Luft, P. J., and Lykins, B.(1987). “Design considerations for GAC treatment of organic chemicals.” J. Environ. Eng. Div. (Am. Soc. Civ. Eng.), 113, 74–82.
Department of the Environment. (1995). State Discharge Number 92-DP-0192, National Pollutant Discharge Elimination System Permit Number 00001538.
EA Engineering, Science and Technology, Inc. (1993). “Oil recovery pilot report.” Project number 12060.01, EA Engineering, Science and Technology, Sparks, Mass.
Edzwald, J. K., Malley, J. P., and Yu, C.(1991). “A conceptual model for dissolved air flotation in water treatment.” Water Supply,9, 141–150.
Greenkorn, R. A. (1983). Flow phenomena in porous media, Marcel Dekker, New York.
Hand, D. W., Crittenden, J. C., and Thacker, W. E.(1984). “Simplified models for design of fixed-bed adsorption systems.” J. Environ. Eng., 110(2), 440–456.
Hickey, R. F., Wagner, D., and Mazewski, G. (1990). “Combined biological fluid bed carbon adsorption system for BTEX contaminated groundwater remediation.” Proc. of the Fourth National Outdoor Action Conference on Aquifer Restoration, National Water Well Association, Las Vegas, 813–828.
Lin, S. H.(1991). “A mathematical model for a biological fluidized bed reactor.” J. Chem. Technol. Biotechnol., 51, 473–482.
Mapstone, G. E., and Thorn, B. R.(1978). “The hypochlorite oxidation of cyanide and cyanate.” J. Appl. Chem. Biotechnol.,28, 135–143.
Munson, B. R., Young, D. F., and Okiishi, T. H. (1990). Fundamentals of fluid mechanics, Wiley, New York.
O’Carroll, D. (1997). “The development of a groundwater treatment cost analysis model.” MS thesis, Rep. No. 97-5, Dept. of Civil and Environmental Engineering, Clarkson Univ., Potsdam, N.Y.
Palmer, S. A. K., Breton, M. A., Nunno, T. J., Sullivan, D. M., and Surprenant, N. F. (1988). Metal-cyanide containing waste treatment technologies, Noyes Data Corporation, Park Ridge, N.J.
Revelle, C. S., Whitlach, E. E., and Wright, J. R. (1997). Civil and environmental systems engineering, Prentice-Hall, Upper Saddle River, N.J.
Sherrard, J. H., and Schroeder, E. D.(1976). “Stoichiometry of industrial biological wastewater treatment.” J. Water Pollut. Control. Fed., 48(4), 742–747.
Shieh, W. K., Sutton, P. M., and Kos, P.(1981). “Predicting reactor biomass concentration in a fluidized-bed system.” J. Water Pollut. Control. Fed., 53(11), 1574–1584.
Vesilind, P. A. (1974). Treatment and disposal of wastewater sludges, Ann Arbor Science, Ann Arbor, Mich.
Wen, C. Y., and Yu, Y. H.(1966). “Mechanisms of Fluidization.” Chem. Eng. Prog., Symp. Ser., 62, 100–110.
Yao, K. M., Habibian, M. T., and O’Melia, C. R.(1971). “Water and Waste Filtration: Concepts and Applications.” Environ. Sci. Technol., 5(11), 1105–1112.
Information & Authors
Information
Published In
Practice Periodical of Hazardous, Toxic, and Radioactive Waste Management
Volume 7 • Issue 3 • July 2003
Pages: 177 - 181
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Jun 5, 2001
Accepted: Mar 21, 2003
Published online: Jun 13, 2003
Published in print: Jul 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.