Pile Drag Load and Downdrag in a Liquefaction Event
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 9
Abstract
Sandy soils may undergo compression during liquefaction. A review of published design manuals, including the 2004 AASHTO LRFD Bridge Design Specifications, indicates that some recommendations for pile design may not represent the pile response in a manner consistent with the actual axial response of the pile during liquefaction. The actual response is discussed in light of the unified pile design method and separated between liquefaction occurring above and below the static nonliquefied neutral plane location before the liquefaction event. In the former case, the effect on the pile is minor regardless of the magnitude of liquefaction-induced settlement of the surrounding soil. In the latter case, the axial compressive load in the pile increases and additional pile settlement (downdrag) will occur when the force equilibrium is reestablished through the necessary mobilization of additional toe resistance. This means that the magnitude of the downdrag is governed by the pile toe load-movement response to the downward shift of the neutral plane. While there is a reduction in shaft resistance due to the reduction in strength within the liquefied layers, this reduction will only influence the pile design length where the liquefying layer is very thick.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (2004). LRFD bridge design specifications, 3rd Ed., Washington, D.C.
Australian Piling Standard. (1995). Piling design and installation, Standard AS2159-1995, Australian Council of Standards, Committee CE/18, Adelalide, Australia.
Boulanger, R. W., and Idriss, I. M. (2006). “Liquefaction susceptibility criteria for silts and clays.” J. Geotech. Geoenviron. Eng., 132(11), 1413–1426.
Bray, J. D., and Sancio, R. B. (2006). “Assessment of the liquefaction susceptibility of fine-grained soils.” J. Geotech. Geoenviron. Eng., 132(9), 1165–1177.
California Division of Mines. (1951). Geologic guidebook of San Francisco Bay counties, Bulletin 154, San Francisco.
Canadian Geotechnical Society (CGS). (1992). Canadian foundation engineering manual, CFEM, 3rd Ed., BiTech Publishers, Vancouver, Canada.
Eslami, A., and Fellenius, B. H. (1997). “Pile capacity by direct CPT and CPTu methods applied to 102 case histories.” Can. Geotech. J., 34(6), 886–904.
Fellenius, B. H. (1984). “Negative skin friction and settlement of piles.” Proc., 2nd Int. Seminar, Pile Foundations, Nanyang Technological Institute, Singapore.
Fellenius, B. H. (2004). “Unified design of piled foundations with emphasis on settlement analysis.” Honoring George G. Goble—Current Practice and Future Trends in Deep Foundations, Proc., Geo-Institute Geo TRANS Conf., J. A. DiMaggio and M. H. Hussein, eds., ASCE GSP 125, ASCE, Reston, 253–275.
Fellenius, B. H. (2006). “Results from long-term measurement in piles of drag load and downdrag.” Can. Geotech. J., 43(4), 409–430.
Hannigan, P. J., Goble, G. G., Likins, G. E., and Rausche, F. (2006). Design and construction of driven pile foundations, FHWA-HI-97-013, National Highway Institute Federal Highway Administration, U.S. Department of Transportation, Washington, D.C.
Hong Kong Geotechnical Engineering Office. (2006). Foundation design and construction, Geo Publication No. 1/2006, The Government of Hong Kong, Hong Kong.
Ishihara, K., and Yoshimine, M. (1992). “Evaluation of settlements in sand deposits following liquefaction during earthquakes.” Soil Mech. Found. Eng. (English Transl.), 118(32), 173–188.
Knutson, L., and Siegel, T. C. (2006). “Consideration of drilled displacement piles for liquefaction mitigation.” Proc., DFI Augered Cast-In-Place Pile Committee Specialty Seminar, Deep Foundations Institute, Los Angeles, 129–132.
Li, D. K., Juang, C. H., Andrus, R. D., and Camp, W. M., III. (2007). “Index properties-based criteria for liquefaction susceptibility of clayey soils: a critical assessment.” J. Geotech. Geoenviron. Eng., 133(1), 110–115.
Missouri Department of Transportation (MoDOT). (2005). LRFD bridge design specifications, Mo.
O’Neill, M. W., and Reese, L. C. (1999). Drilled shafts: Construction procedures and design methods, FHWA-IF-99-025, Federal Highway Association, Washington, D.C.
Robertson, P. K., and Wride, C. E. (1998). “Evaluating cyclic liquefaction potential using the cone penetration test.” Can. Geotech. J., 35(3), 442–459.
Tokimatsu, K., and Seed, H. B. (1987). “Evaluation of settlements in sands due to earthquake shaking.” J. Geotech. Engrg., 113(8), 861–879.
Washington State Department of Transportation (WSDOT). (2006). Geotechnical design manual M 46-03, http://www.wsdot.wa.gov/fasc/EngineeringPublications/Manuals/GDM/GDM.htm .
Youd, T. L., et al. (2001). “Liquefaction resistance of soils: Summary report from the 1996 NCEER and 1998 NCEER/NSF workshop on evaluation of liquefaction resistance of soils.” J. Geotech. Geoenviron. Eng., 127(10), 817–833.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Feb 16, 2007
Accepted: Nov 9, 2007
Published online: Sep 1, 2008
Published in print: Sep 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.