Experimental Investigation of Grouted Helical Piers for Use in Foundation Rehabilitation
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 9
Abstract
Building rehabilitation is critical for numerous older urban areas, many of which have inadequate foundations to support new demands. Consequently, development of practical methods to strengthen existing foundations is crucial. In engineering practice, both subsurface grouting and helical piers have been widely used to address these issues by strengthening the foundation. If the solid shaft of a typical helical pier is replaced by a hollow shaft, then helical piers provide the ability to deliver grout. It is hypothesized that these grouted helical pier systems could address foundation strengthening needs. This paper presents findings from an exploratory research program where grouting and pier placement tools were developed and tested on the large geotechnical centrifuge at the University of California, Davis. Experimental methods and procedures developed are presented, and observations regarding the formation of grout bulbs under different conditions are analyzed. Physical observation of the test specimens indicates that average grout bulb diameters of 0.6–1.9 times the helix diameter are attainable. For similar grout mixes, 20–50% larger grout bulbs can be attained by adding just a modest amount of injection pressure. Future research may use these results to develop load performance data.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the Civil and Mechanical Systems Division of the U.S. National Science Foundation (NSF) (CMS-0513972), where Dr. Richard Fragaszy is the program director. NEES Operations and Maintenance funding supports the operation of the centrifuge at UC Davis (NSF Award CMS-0402490). Grouted materials were donated by Surecrete, Inc. and DeNeef Construction Chemicals. Assistance was provided by UC Davis centrifuge staff, in particular Chad Justice and Lars Pederson. Helpful suggestions and technical input were provided by Dean White of Concrete Technologies and Russell Lindsey of Precision Pier USA, Inc. Opinions, findings, and conclusions in this paper are those of the writers, and do not necessarily reflect those of the sponsoring organization.
References
A. B. Chance Company (AB Chance). (1991). “Foundation and underpinning system.” BuyLine 1386, A. B. Chance, Centralia, Mo., ⟨http://www.abchance.com/⟩ (Oct. 2007 ).
Arulnathan, R., Boulanger, R. W., Kutter, B. L., and Sluis, B. (2000). “New tool for shear wave velocity measurements in model tests.” Geotech. Test. J., 23(4), 444–453.
ASCE. (2005). “ASCE report card for America’s infrastructure.” Rep., ASCE, Reston, Va., ⟨http://www.asce.org/reportcard/2005/⟩ (Oct. 2007 ).
Bian, Y. (2006). “Development and testing of centrifuge tools for use in grouted helical pier-based foundation rehabilitation studies.” MS thesis, Univ. of California, Irvine, Calif.
Bian, Y., Hutchinson, T. C., Wilson, D., and Laefer, D. (2006). “Grouted helical piers for use in foundation rehabilitation: Considerations for small-scale centrifuge testing.” Proc., Int. Conf. on Reuse of Foundations for Urban Sites, June 14–15, BRE, Garston, U.K.
Brandenberg, S. J., Choi, S., Kutter, B. L., Wilson, D. W., and Santamarina, J. C. (2006). “A bender element system for measuring shear wave velocities in centrifuge models.” Proc., 6th Int. Conf. on Physical Modeling in Geotechnics, Hong Kong Univ. of Science and Technology, Hong Kong, 165–170.
Culligan, P. J., Barry, D. A., and Parlange, J. Y. (1997). “Scaling unstable infiltration in the vadose zone.” Can. Geotech. J., 34(3), 466–470.
Ghaly, A. M., and Clemence, S. P. (1998). “Pullout performance of inclined helical screw anchors in sand.” J. Geotech. Geoenviron. Eng., 124(7), 617–627.
Geiger, S. L., and Durnford, D. S. (2000). “Infiltration in homogeneous sands and a mechanistic model of unstable flow.” Soil Sci. Soc. Am. J., 64(2), 460–469.
Hertlein, B. H., and Walton, W. H. (2000). “Assessment and reuse of old foundations.” Transportation Research Record. 1736, Transportation Research Board, Washington, D.C., 49–54.
Kulhawy, F. H., and Mayne, P. W. (1990). “Manual on estimating soil properties for foundation design.” Rep. EL-6800, Electric Power Research Institute, Palo Alto, Calif.
Kutter, B. L. (1992). “Dynamic centrifuge modeling of geotechnical structures.” Transportation Research Record. 1336, Transportation Research Board, Washington, D.C., 24–30.
Laefer, D. F., and Manke, J. P. (2006). “Small-scaled testing of rehabilitated pile groups.” Proc., Int. Conf. on Reuse of Foundations for Urban Sites, October 17–18, Watford, U.K., 161–172.
Laefer, D., Manke, J., Tucker, J., and Batten, Y. (2007). “Challenges to model-scale testing for composite deep foundations and existing foundation enhancement.” Geo-Denver 2007: New Peaks in Geotechnics, ASCE Special Geotechnical Publication 158, Contemporary issues in deep foundations, H. W. Olsen, ed., ASCE, Reston, Va., 213–222.
Manke, J. P. (2004). “Assessment of superposition as a design framework for the combined effects of soil improvement and foundation remediation.” MS thesis, North Carolina State Univ.
Meyerhof, G. G. (1956). “Penetration tests and bearing capacity of cohesionless soils.” J. Soil Mech. and Found. Div., 82(1), 1–19.
Nichols, S. C., and Goodings, D. J. (2000). “Physical model testing of compaction grouting in cohesionless soil.” J. Geotech. Geoenviron. Eng., 126(9), 848–852.
Parlange, J. Y., and Hill, D. E. (1976). “Theoretical analysis of wetting front instability in soils.” Soil Sci., 122(4), 236–239.
Prasad, Y. N., and Rao, J. S. N. (1996). “Lateral capacity of helical piles in clays.” J. Geotech. Geoenviron. Eng., 122(11), 938–941.
Robertson, P. K., and Campanella, R. G. (1983). “Interpretation of cone penetration tests. Part I: Sand.” Can. Geotech. J., 20(4), 718–733.
Rupiper, S. (2003). “Helice pier coupling system used for soil stabilization.” ⟨http://www.patentstorm.us/patents/6615554-description.html⟩ (Oct. 2007 ).
Santamarina, J. C. and Fratta, D. (2005). Discrete signals and inverse problems: An introduction for engineers and scientists, John Wiley and Sons, Chichester, U.K., 350.
Selker, J., Leclerq, P., Parlange, J. Y., and Steenhuis, T. S. (1992). “Fingering flow into two dimensions. 1: Measurement of metric potential.” Water Resour. Res., 28(9), 2513–2512.
Vickars, R. A., and Clemence, S. P. (2000). “Performance of helical piles with grouted shafts.” New technological and design development in deep foundations, Geotechnical Special Publication No. 100, N. D. Dennis, Jr., R. Castelli, and M. W. O’Neill, eds., ASCE, Reston, Va., 327–341.
Wang, Z., Jury, W. A., Tuli, A., and Kim, D. J. (2004). “Unstable flow during redistribution: Controlling factors and practical implications.” Soil Sci. Soc. Am. J., 3(2), 549–559.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jun 27, 2007
Accepted: Jan 28, 2008
Published online: Sep 1, 2008
Published in print: Sep 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.