Effect of Progressive Failure on Measured Shear Strength of Geomembrane/GCL Interface
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 4
Abstract
This paper presents experimental data and numerical modeling results that illustrate the effects of progressive failure on the measured shear strength of a textured geomembrane/geosynthetic clay liner (GMX/GCL) interface. Large direct shear tests were conducted using different specimen gripping/clamping systems to isolate the effects of progressive failure. These tests indicate that progressive failure causes a reduction in measured peak shear strength, an increase in the displacement at peak, an increase in large displacement shear strength, and significant distortion of the shear stress–displacement relationship. A numerical model was developed to simulate progressive failure of a GMX/GCL interface. Measured and simulated shear stress–displacement relationships are in good-to-excellent agreement at four normal stress levels. The model was then used to investigate mechanisms of progressive interface failure and factors that control its significance. The results indicate that accurate measurements of shear stress–displacement behavior and strength are obtained when gripping surfaces prevent slippage of the test specimen and the intended failure surface has the lowest shear resistance of all possible sliding surfaces. The use of proper gripping surfaces is expected to reduce difficulties in test data interpretation and to increase the accuracy and reproducibility of test results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Financial support and GCL material for this investigation were provided by CETCO of Arlington Heights, Ill. Geomembrane material was provided by Gundle/SLT Environmental Lining Technology, Inc. (GSE) of Houston, Tex. This support is gratefully acknowledged. The direct shear tests were conducted in the Bechtel Geotechnical Laboratory at Purdue University. The writers thank Jim Olsta of CETCO and Richard Erickson, formerly of GSE, for their assistance with the project.
References
Allen, J. M., and Fox, P. J. (2007). “Pyramid-tooth gripping surface for GCL shear testing.” Proc., Geosynthetics ’07 (CD-ROM).
ASTM. (2006). “Standard test method for determining the internal and interface shear resistance of geosynthetic clay liner by the direct shear method.” ASTM D 6243, ASTM International, West Conshohocken, Pa.
Bathurst, R. J., and Cai, Z. (1994). “In-isolation cyclic load-extension behavior of two geogrids.” Geosynthet. Int., 1(1), 1–19.
Bressi, G., Zinesi, M., Montanelli, F., and Rimoldi, P. (1995). “The slope stability of GCL layers in geosynthetic lining system.” Proc., 5th Int. Symp. on Landfills, Cagliari, Italy, Vol. 1, 595–610.
Byrne, R. J. (1994). “Design issues with strain-softening interfaces in landfill liners.” Proc., Waste Tech ’94, National Solid Waste Management Association, Charleston, S.C., 1–26.
Chiu, P., and Fox, P. J. (2004). “Internal and interface shear strengths of unreinforced and needle-punched geosynthetic clay liners.” Geosynthet. Int., 11(3), 176–199.
Filz, G. M., Esterhuizen, J. J. B., and Duncan, J. M. (2001). “Progressive failure of lined waste impoundments.” J. Geotech. Geoenviron. Eng., 127(10), 841–848.
Fox, P. J., Rowland, M. G., and Scheithe, J. R. (1998). “Internal shear strength of three geosynthetic clay liners.” J. Geotech. Geoenviron. Eng., 124(10), 933–944.
Fox, P. J., Rowland, M. G., Scheithe, J. R., Davis, K. L., Supple, M. R., and Crow, C. C. (1997). “Design and evaluation of a large direct shear machine for geosynthetic clay liners.” Geotech. Test. J., 20(3), 279–288.
Fox, P. J., and Stark, T. D. (2004). “State-of-the-art report: GCL shear strength and its measurement.” Geosynthet. Int., 11(3), 141–175.
Fox, P. J., Stark, T. D., and Swan, R. H., Jr. (2004). “Laboratory measurement of GCL shear strength.” Proc., 2nd Symp. on Advances in Geosynthetic Clay Liner Technology, STP 1456, R. E. Mackey and K. von Maubeuge, eds., ASTM International, West Conshohocken, Pa., 92–109.
Frobel, R. K. (1996). “Geosynthetic clay liners, part four: Interface and internal shear strength determination.” Geotech. Fabr. Rep., 14(8), 20–23.
Gilbert, R. B., Fernandez, F., and Horsfield, D. W. (1996). “Shear strength of reinforced geosynthetic clay liner.” J. Geotech. Engrg., 122(4), 259–266.
Giroud, J. P. (2005). “Quanitification of geosynthetic behavior.” Geosynthet. Int., 12(1), 2–27.
Li, M.-H., and Gilbert, R. B. (2006). “Mechanisms of postpeak strength reduction for textured geomembrane-nonwoven geotextile interfaces.” Geosynthet. Int., 13(5), 206–209.
Ling, H. I., Mohri, Y., and Kawabata, T. (1998). “Tensile properties of geogrids under cyclic loadings.” J. Geotech. Geoenviron. Eng., 124(8), 782–787.
Nye, C. J., and Fox, P. J. (2007). “Dynamic shear behavior of a needle-punched geosynthetic clay liner.” J. Geotech. Geoenviron. Eng., 133(8), 973–983.
Raju, D. M., and Fannin, R. J. (1998). “Load-strain–displacement response of geosynthetics in monotonic and cyclic pullout.” Can. Geotech. J., 35(1), 183–193.
Trauger, R. J., Swan, R. H., Jr., and Yuan, Z. (1997). “Long-term shear strength behavior of a needle punched geosynthetic clay liner.” Proc., Testing and Acceptance Criteria for Geosynthetic Clay Liners, STP 1308, L. W. Well, ed., ASTM International, West Conshohocken, Pa., 103–120.
Triplett, E. J., and Fox, P. J. (2001). “Shear strength of HDPE geomembrane/geosynthetic clay liner interfaces.” J. Geotech. Geoenviron. Eng., 127(6), 543–552.
Wesseloo, J., Visser, A. T., and Rust, E. (2004). “A mathematical model for the strain-rate dependent stress-strain response of HDPE geomembranes.” Geotext. Geomembr., 22(4), 273–295.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jan 24, 2007
Accepted: Aug 16, 2007
Published online: Apr 1, 2008
Published in print: Apr 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.