Mechanistic Model for One-Dimensional Consolidation Behavior of Nonsegregating Oil Sands Tailings
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 2
Abstract
Thermal-chemical-hydraulic separation process is used to extract bitumen from surface mined oil sands ores. Huge amounts of oil sands fine tailings are produced from the extraction process. The most fundamentally challenging issue facing the geo-environmental community is containment, long-term storage, and volume reduction of oil sands fine tailings. One of the fine tailings disposal techniques is to homogenize fine tailings with coarse tailings forming nonsegregating tailings (NST). NST exhibits enhanced performance in consolidation and strength, and reduction in water retention as compared to fine tailings. This paper examines one-dimensional consolidation behavior of NST with varying fine and coarse tailings compositions. A mechanistic model based on theory of mixture is developed and proposed to predict consolidation behavior of NST. This model is demonstrated to achieve an optimum design of NST for accelerated consolidation rate and water recovery.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers thank Shell Canada Limited for use of their testing data in this research investigation. Funding provided by Natural Science and Engineering Research Council and the University of Calgary are appreciated.
References
Carman, P. C. (1937). “Fluid flow through a granular bed.” Trans. Inst. Chem. Eng., 15, 150–156.
Caughill, D. L., Morgenstern, N. R., and Scott, J. D. (1993). “Geotechnics of nonsegregating oil sand tailings.” Can. Geotech. J., 30, 801–811.
Dusseault, M. B., and Scott, J. D. (1983). “Tailings pond behaviour and characterization of oil sand tailings sludge.” Part. Sci. Technol., 1, 295–309.
Energy Resources Conservation Board (ERCB). (1990). “Alberta’s reserves of crude oil, oil sands, gas, natural gas liquids and sulphur.” Reserves Rep. Series No. ST 91-18.
Evans, M. D., and Zhou, S. (1995). “Liquefaction behavior of sand gravel composites.” J. Geotech. Engrg., 121(3), 287–298.
Fine Tailings Fundamentals Consortium (FTFC). (1995). “Advances in oil sands tailings research.” Fine tails and process water reclamation, Vol. II, Alberta Dept. of Energy, Oil Sands and Research Division, Edmonton, Alta., Canada.
Gutierrez, M. (2005). “Mixture theory characterization and modeling of soil mixtures.” Geotechnical Special Publication, No. 143, ASCE, Reston, Va., 600–616.
Kenny, T. C. (1977). “Residual strength of mineral mixtures.” Proc. 9th Int. Conf. of Soil Mechanics and Foundation Engineering, ICSMFE, Vol. 1, Tokyo, 155–160.
Kozeny, J. (1927). “Ueber kapillare leitung des wassers im Boden.” Sitzungsber. Akad. Wiss. Wien, Math.-Naturwiss. Kl., Abt. 2A, 136a, 271–306.
Kumar, G. V., and Muir Wood, D. (1996). “Mechanical behaviour of mixtures of kaolin and coarse sand.” IUTAM Symp. on Mechanics of Granular and Porous Materials, N. A. Fleck and A. C. F. Cocks, eds., Kluwer Academic, Dordrecht, 57–68.
Kynch, G. J. (1952). “A theory of sedimentation.” Trans. Faraday Soc., 48, 166–176.
Lade, P. V., and Yamamuro, J. A. (1997). “Effects of nonplastic fines on static liquefaction of sands.” Cognition, 34, 918–928.
Lambe, T. W., and Whitman, R. V. (1969). Soil mechanics, Wiley, New York.
Liu, Y. B., Lord, E. R. F., and Scott, J. D. (1997). “Geotechnical aspects of two innovative disposal technologies for oil sand tailings.” 50th Canadian Geotechnical Conf. of the Canadian Geotechnical Society, Ottawa, 514–521.
Matthews, J. G., Shaw, W. H., MacKinnon, M. D., and Cuddy, R. G. (2002). “Development of composite tailings technology at Syncrude Canada.” International J. Surface Mining and Reclamation Environment, 16, 24–39.
Mills, B. N. (2002). “Modelling the consolidation behaviour of nonsegregating oil sand tailings.” MSc thesis, Dept. of Civil Engineering, Univ. of Calgary, Calgary, Alta., Canada.
Mitchell, J. K. (1993). Fundamentals of soil behavior, 2nd Ed., Wiley, New York.
Muir Wood, D., and Kumar, G. V. (2000). “Experimental observations of behaviour of heterogeneous soil.” Mech. Cohesive-Frict. Mater., 5, 373–398.
Pitman, T. D., Robertson, P. K., and Sego, D. C. (1994). “Influence of fines on the collapse of loose sands.” Cognition, 31, 728–739.
Pollock, G. W. (1988). “Consolidation of oil sand tailings sludge.” MSc thesis, Dept. of Civil Engineering, Univ. of Alberta, Edmonton, Alta., Canada.
Scott, J. D., and Dusseault, M. B. (1982). “Behaviour of oil sands tailings sludge.” Proc., 33rd Annual Technical Meeting of the Canadian Institute of Mining and Metallurgy, Calgary, Alta., Canada, Paper No. 82-33-85.
Suthaker, N. N., and Scott, J. D. (1996). “Measurement of hydraulic conductivity in oil sand tailings slurries.” Cognition, 33, 642–653.
Suthaker, N. N., Scott, J. D., and Miller, W. G. (1997). “The first fifteen years of a large scale consolidation test.” 50th Canadian Geotechnical Conf. of the Canadian Geotechnical Society, Ottawa, 476–483.
Tang, J. (1997). “Fundamental behaviour of composite tailings.” MSc thesis, Dept. of Civil Engineering, Univ. of Alberta, Edmonton, Alta., Canada.
Thevanayagam, S. (1998). “Effect of fines and confining stress on undrained shear strength of silty sands.” J. Geotech. Geoenviron. Eng., 124(6), 479–491.
Thevanayagam, S., Shenthan, T., Mohan, S., and Liang, J. (2002). “Undrained fragility of clean sands, silty sands, and sandy silts.” J. Geotech. Geoenviron. Eng., 128(10), 849–859.
Truesdell, C. A., and Toupin, R. (1960). “The classical field theories.” Encyclopedia of physics, S. Flügge, ed., Vol. III/1, Springer, Berlin, 73–99.
Vallejo, L. E. (2001). “Interpretation of the limits in shear strength in binary granular mixtures.” Cognition, 38, 1097–1104.
Vallejo, L. E., Lobo-Guerrero, S., and Chik, Z. (2005). “A network of fractal force chains and their effect in granular materials under compression.” Fractals in engineering. New trends in theory and applications, J. Levy-Vehel and E. Lutton, eds., Springer, London, 67–80.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 134 • Issue 2 • February 2008
Pages: 195 - 202
Copyright
© 2008 ASCE.
History
Received: Jul 21, 2006
Accepted: Jul 23, 2007
Published online: Feb 1, 2008
Published in print: Feb 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.