Spatial Distribution of Excess Pore-Water Pressure due to Piezocone Penetration in Overconsolidated Clay
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 133, Issue 6
Abstract
This paper presents the results of an analysis of the spatial distribution of the excess pore-water pressure induced by piezocone penetration into overconsolidated clays. From the experimental results obtained for moderately and heavily overconsolidated clays, it was observed that the excess pore-water pressure increases monotonically from the piezocone surface to the outer boundary of the shear zone and then decreases logarithmically, approaching zero at the outer boundary of the plastic zone. It was also found that the size of the shear zone decreases from approximately 2.2 to 1.5 times the cone radius with increasing overconsolidation ratio (OCR), whereas the plastic radius is about 11 times the piezocone radius, regardless of the OCR. The expressions developed in this study based on the modified Cam clay model and the cylindrical cavity expansion theory, which take into consideration the effects of the strain rate and stress anisotropy, provide a good prediction of the initial pore-water pressure at the piezocone location. The method of predicting the spatial distribution of excess pore-water pressure proposed in this study is based on a linearly increasing in the shear zone and a logarithmically decreasing , and was verified by comparing the pore-water pressure measured in overconsolidated specimens in the calibration chamber.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the Korea Science and Engineering Foundation through Grant No. KOSEFR01-2000-000-00374-0 and this financial support is gratefully acknowledged.
References
Abu-Farsakh, M. Y., Voyiadjis, G. Z., and Tumay, M. T. (1998). “Numerical analysis of the miniature piezocone penetration tests in cohesive soils.” Int. J. Numer. Analyt. Meth. Geomech., 22, 791–818.
Baligh, M. M., and Levadoux, J. N. (1986). “Consolidation after undrained piezocone penetration. II: Interpretation.” J. Geotech. Engrg., 112(7), 727–745.
Battaglio, M., Bruzzi, D., Jamiolkowski, M., and Lancellotta, R. (1986). “Interpretation of CPT’s and CPTU’s: Undrained penetration of saturated clays.” 4th Int. Geotechnical Seminar, Field Instrumentation and In-Situ Measurements, Singapore, 129–143.
Burns, S. E., and Mayne, P. W. (1998). “Monotonic and dilatory pore-pressure decay during piezocone tests in clays.” Can. Geotech. J., 35(6), 1063–1073.
Cao, L. F., Teh, C. I., and Chang, M. F. (2001). “Undrained cavity expansion in modified Cam clay I: Theoretical analysis.” Geotechnique, 51(4), 323–334.
Chang, M. F., Teh, C. I., and Cao, L. F. (1999). “Critical state strength parameters of saturated clays from the modified Cam clay model.” Can. Geotech. J., 36(5), 876–890.
Chang, M. F., Teh, C. I., and Cao, L. F. (2001). “Undrained cavity expansion in modified Cam clay II: Application to the interpretation of the piezocone test.” Geotechnique, 51(4), 335–350.
Chen, B. S., and Mayne, P. W. (1994). “Profiling the overconsolidation ratio of clays by piezocone tests.” Rep. No. GIT-CEEGEO-94-1, Georgia Institute of Technology, Atlanta.
De Lima, D. C. (1990). “Development, fabrication and verification of the LSU in-situ testing calibration chamber.” Ph.D. dissertation, Louisiana State Univ., Baton Rouge, La.
Gupta, R. C. (1983). “Determination of the in-situ coefficient of consolidation and permeability of submerged soils using electrical piezoprobe soundings.” Ph.D. dissertation, Univ. of Florida, Gainsville, Fla.
Gupta, R. C., and Davidson, J. L. (1986). “Piezoprobe determined coefficient of consolidation.” Soils Found., 26(3), 12–22.
Huang, A. B., Bunting, R. D., and Carney, T. C. (1991). “Piezoblade tests in a clay calibration chamber.” Proc., ISOCCT1, Potsdam, N.Y., 161–173.
Jamiolkowski, M., Ladd, C. C., Germaine, J. T., and Lancellotta, R. (1985). “New developments in field and laboratory testing of soils.” 11th Int. Conf. on Soil Mechanics and Foundation Engineering, San Francisco, 57–153.
Kim, T. J. (2005). “Dissipation of pore-water pressure due to piezocone penetration in OC clay.” Ph.D. dissertation, Korea Univ., Seoul, Korea.
Kiousis, P. D., Voyiadjis, G. Z., and Tumay, M. T. (1988). “A large strain theory and its application in the analysis of the cone penetration mechanism.” Int. J. Numer. Analyt. Meth. Geomech., 12(1), 45–60.
Kulhawy, F. H., and Mayne, P. W. (1990). “Manual on estimating soil properties for foundation design.” Rep. No. EPRI EL-6800, Electric Power Research Institute, Palo Alto, Calif.
Kurup, P. U., and Tumay, M. T. (1995). “Piezocone dissipation curves with initial excess pore pressure variation.” Proc., Int. Symp. on Cone Penetration Testing, Linkoping, Sweden, 195–200.
Ladanyi, B. (2002). “Discussion: Undrained cavity expansion in modified cam clay II: Application to the interpretation of the piezocone test.” Geotechnique, 52(4), 307–311.
Ladd, C. C., and Foott, R. (1974). “New design procedure for stability of soft clays.” J. Geotech. Engrg. Div. 100(7), 763–786.
Lunne, T., Eidsmoen, T. E., Powell, J. J. M., and Quatermann, R. S. T. (1986). “Piezocone testing in overconsolidated clays.” 39th Canadian Geotechnical Conf., Ottawa, 209–218.
Sully, J. P., Campanella, R. G., and Robertson, P. K. (1988). “Overconsolidation ratio of clays from penetration pore pressures.” J. Geotech. Engrg. 114(2), 209–216.
Vesic, A. S. (1972). “Expansion of cavities in infinite soil mass.” J. Soil Mech. and Found. Div., 98(3), 265–290.
Wood, D. M. (1990). Soil behavior and critical state soil mechanics, Cambridge University Press, Cambridge, U.K.
Wroth, C. P. (1984). “The interpretation of in-situ soil tests.” Geotechnique, 34(4), 449–489.
Wroth, C. P., Carter, J. P., and Randolph, M. F. (1979). “Stress change around a pile driven into cohesive soil.” Conf. in Recent Developments in the Design and Construction of Piles, I.C.E., London, 255–264.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Mar 6, 2006
Accepted: Dec 14, 2006
Published online: Jun 1, 2007
Published in print: Jun 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.