Effect of Microfabric on Mechanical Behavior of Kaolin Clay Using Cubical True Triaxial Testing
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 133, Issue 4
Abstract
Various aspects of the mechanical behavior of kaolin clay are discussed in light of experimental observations from a series of strain controlled true triaxial undrained tests performed on cubical kaolin clay specimens with flocculated and dispersed microfabric, using a fully automated flexible boundary experimental setup with real-time feedback control system. The laboratory procedures used to prepare flocculated and dispersed microfabric specimens are presented. Mercury intrusion porosimetry is used to evaluate the pore structure of these specimens. The influence of microfabric on the consolidation behavior of kaolin clay is evaluated based on the data obtained from consolidation during constant rate of strain tests and the isotropic consolidation during true triaxial tests. Undrained tests on kaolin clay show that the following vary with microfabric of specimen: The shear stiffness, excess pore pressure generated during shear, and strength and strain to failure. For both microfabrics, the observed strength behavior using cubical triaxial testing shows a similar pattern of variation with applied stress anisotropy; hence, only a marginal influence of fabric-induced anisotropy.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Financial support from the National Science Foundation (NSF) through Grant Nos. NSFCMS-9872618 and NSFCMS-0296111 is gratefully acknowledged. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the writers and do not necessarily reflect the views of NSF.
References
ASTM. (1998). “Standard test method for one-dimensional consolidation properties of soils using controlled-strain loading.” D 4186–89, West Conshohocken, Pa.
Barden, L, and Sides, G. (1971). “Sample disturbance in investigation of clay structure.” Geotechnique, 21(3), 211–222.
Broms, B. B., and Casbarian, A. O. (1965). “Effects of rotation of principal stress axes and of the intermediate principal stress on the shear strength.” Proc., 6th Int. Conf. on Soil Mechanics, and Foundation Engineering, Vol. 1, 179–183.
Burland, J. B. (1990). “On the compressibility and shear strength of natural clays.” Geotechnique, 40(3), 329–378.
Carty, W. M. (1999). “The colloidal nature of kaolinite.” Am. Ceram. Soc. Bull., 77(8), 72–76.
Collins, K., and McGown, A. (1974). “The form and function of microfabric features in a variety of natural soils.” Geotechnique, 24(2), 223–254.
Duncan, J. M., and Seed, H. B. (1966). “Anisotropy and stress reorientation in clay.” J. Soil Mech. and Found. Div., 92(5), 21–52.
Germaine, J. T., and Ladd, C. C. (1988). “Triaxial testing of saturated cohesive soils.” Advanced Triaxial Testing of Soil and Rock, ASTM STP977, West Conshohocken, Pa., 421–459.
Hazen, I., and Penumadu, D. (1999). “Resonant column testing of clay specimens with controlled microfabric.” Rep. No. 99–02, Clarkson Univ., Potsdam, N.Y.
Henkel, D. J. (1960). “The shear strength of saturated remoulded clays.” ASCE Conf. on Shear Strength of Cohesive Soils, 533–554.
Kirkgard, M. M., and Lade, Poul V. (1993). “Anisotropic three-dimensional behavior of a normally consolidated clay.” Can. Geotech. J., 30(4), 848–858.
Krizek, R. J., Edil, T. B., and Ozaydin, I. K. (1975). “Preparation and identification of samples with controlled fabric.” Eng. Geol. (Amsterdam), 9(1), 13–38.
Lambe, T. W. (1958a). “The engineering behavior of compacted clay.” J. Soil Mech. and Found. Div., 84(2), 1–35.
Lambe, T. W. (1958b). “The structure of compacted clays.” J. Soil Mech. and Found. Div., 84(2), 1–34.
Mandeville, D., and Penumadu, D. (2004). “True triaxial testing system for clay with proportional-integral-differential control.” Geotech. Test. J., 27(2), 1–12.
Martin, R. T. (1965). “Quantitative fabric of consolidated Kaolinite.” Research Rep. No. R65–47, Soils Publication No. 179 Massachusetts Institute of Technology, Cambridge, Mass.
Mayne, P. W., and Swanson, P. G. (1981). “The critical state pore pressure parameter for consolidated undrained shear tests.” Lab. Shear Strength of Soil, ASTM STP740, R. N. Yong, and F. C. Townsend, eds., West Conshohocken, Pa., 410–430.
McConnachie, I. (1974). “Fabric changes in consolidated kaolin.” Geotechnique, 24(2), 207–222.
McKyes, E., and Yong, R. N. (1971). “Three techniques for fabric viewing as applied to shear distortion of clay.” Clays Clay Miner., 19, 289–293.
Mesri, G., and Godlewski, P. M. (1977). “Time and stress-compressibility interrelationship.” J. Geotech. Engrg. Div., 103(5), 417–430.
Mitchell, J. K. (1956). “The fabric of natural clays and relation to engineering properties.” Highway Research Board Proceedings, Vol. 35, 693–713.
Mitchell, J. K. (1964). “Shearing resistance of soil as a rate process.” J. Soil Mech. and Found. Div., 90(1), 29–61.
Mitchell, J. K. (1993). Fundamentals of soil behavior, 2nd Ed., Wiley, New York.
Morgenstern, N. R., and Tchalenko, J. S. (1967). “Microstructural observations on shear zones and slips in natural clays.” Proc., Geotechnical Conf., Oslo, Vol. 1, 147–153.
Olson, R. E., and Mesri, G. (1970). “Mechanisms controlling the compressibility of clay.” J. Soil Mech. and Found. Div., 96(6), 1863–1878.
Penumadu, D. (1996). “Evaluating clay microfabric using scanning electron microscopy and digital information processing.” Transportation Research Record. 1526, Transportation Research Board, Washington, D.C., 112–120.
Penumadu, D., and Dean, J. (1999). “Compressibility effect in evaluating the pore-size distribution of kaolin clay using mercury intrusion porosimetry.” Can. Geotech. J., 37, 393–405.
Prashant, A., and Penumadu, D. (2004). “Effect of intermediate principal stress on overconsolidated Kaolin clay.” J. Geotech. Geoenviron. Eng., 130(3), 284–292.
Prashant, A., and Penumadu, D. (2005). “A laboratory study of normally consolidated kaolin clay.” Can. Geotech. J., 42(1), 27–37.
Quigley, R. M., and Thompson, C. D. (1966). “The fabric of anisotropically consolidated sensitive marine clay.” Can. Geotech. J., 3(2), 61–73.
Seed, H. B., and Chan, C. K. (1959). “Structure and strength characteristics of compacted clays.” J. Soil Mech. and Found. Div. 85(5), 87–128.
Seed, H. B., Mitchell, J. K., and Chan, C. K. (1962). “Swell and swell pressure characteristics of compacted clays.” Highway Research Board Bulletin, No. 313, 12–39.
Skempton, A. W. (1954). “The pore pressure coefficients A and B.” Geotechnique, 4, 143–147.
Soga, K. (1994). “Mechanical behavior and constitutive modeling of natural structured soils.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Univ. of California, Berkeley, Calif.
Washburn, E. W. (1921). “Note on a method of determining the distribution of pore sizes in a porous material.” Proc. Natl. Acad. Sci. U.S.A., 7(4), 115–116.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Oct 19, 2004
Accepted: Aug 21, 2006
Published online: Apr 1, 2007
Published in print: Apr 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.