Full-Scale Field Testing of Colloidal Silica Grouting for Mitigation of Liquefaction Risk
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 133, Issue 2
Abstract
This paper reports results of a full-scale field test to assess the performance of dilute colloidal silica stabilizer in reducing the settlement of liquefiable soil. Slow injection methods were used to treat a -thick layer of liquefiable sand. Eight injection wells were installed around the perimeter of the -diameter test area and 8% by weight colloidal silica grout was slowly injected into the upper of a -thick layer of liquefiable sand. A central extraction well was used during grout injection to direct the flow of the colloidal silica towards the center of the test area. Details of the field injection are described. Subsequently, the injection wells were used to install explosive charges and liquefaction was induced by blasting. After blasting, approximately of settlement occurred versus of settlement in a nearby untreated area. The mechanism of improvement is thought to be bonding between the colloidal silica and the individual sand particles; the colloidal silica gel encapsulates the soil structure and maintains it during dynamic loading.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the U.S. National Science Foundation Grant No. NSFCMS-0219987. This support is gratefully acknowledged. Any opinions, findings, and conclusions, or recommendations expressed in this material are those of the writers and do not necessarily reflect the views of the U.S. National Science Foundation. The writers express their appreciation to the British Columbia Ministry of Transportation for allowing them to use the Vancouver test site. Gordon Gibbons of Mud Bay Drilling provided field expertise and moral support during the planning and execution of the grouting operations. Reuben Karol and Richard M. Berry graciously provided extensive grouting advice. Spencer Strand of BYU provided assistance installing instrumentation and surveying. Danny Winters and Mike Stokes of the University of South Florida donated time and the use of their data system for data collection during blasting. ConeTec, Inc. provided reduced rates to perform CPT soundings. These contributions greatly enhanced the success of the project. The writers would also like to thank the reviewers for their valuable comments.
References
Ashford, S. A., Rollins, K. M., and Lane, J. D. (2004). “Blast-induced liquefaction for full-scale foundation testing.” J. Geotech. Geoenviron. Eng., 130(8), 798–806.
DuPont. (1997). Ludox colloidal silica: Properties, uses, storage, and handling, Product Information, Wilmington, Del.
Gallagher, P. M. (2000). “Passive site remediation for mitigation of liquefaction risk.” Ph.D. dissertation, Virginia Polytechnic Institute and State Univ., Blacksburg, Va.
Gallagher, P. M., and Lin, Y. (2005). “Column testing to determine colloidal silica transport mechanisms.” Innovations in Grouting and Soil Improvement, GSP No., 136, Proc., Sessions of the Geo-Frontiers Congress, Vol. 162, Austin, Tex.
Gallagher, P. M., and Mitchell, J. K. (2002). “Influence of colloidal silica grout on liquefaction potential and cyclic undrained behavior of loose sand.” Soil Dyn. Earthquake Eng., 22(2002), 1017–1026.
Gallagher, P. M., Pamuk, A., and Abdoun, T. (2007). “Stabilization of liquefiable soils using colloidal silica grout.” J. Mater. Civ. Eng., in press.
Iler, R. K. (1979). The chemistry of silica: Solubility, polymerization, colloid and surface properties, and biochemistry, Wiley, New York.
Jurinak, J. J., Summers, L. E., and Bennett, K. E. (1989). “Oilfield application of colloidal silica gel.” Proc., Society of Petroleum Engineers Int. Symp. on Oil Field Chemistry, Houston, 406–412.
Karol, R. H. (2003). Chemical grouting and soil stabilization, 3rd Ed., CRC, Boca Raton, Fla., 584.
Moridis, G. J., Apps, J., Persoff, P., Myer, L., Muller, S., Yen, P., and Pruess, K. (1996). “A field test of a waste containment technology using a new generation of injectable barrier liquids.” Proc., Spectrum ’96, Seattle.
Noll, M. R., Epps, D. E., Bartlett, C. L., and Chen, P. J. (1993). “Pilot field application of a colloidal silica gel technology for in situ hot spot stabilization and horizontal grouting.” Proc., 7th National Outdoor Action Conf., National Ground Water Association, Las Vegas, 207–219.
Pamuk, A., Gallagher, P. M., and Zimmie, T. (2007). “Remediation of pile foundations against lateral spreading by passive site stabilization technique.” Soil Dynamics and Earthquake Engineering, in press.
Persoff, P., Apps, J., Moridis, G., and Whang, J. M. (1999). “Effect of dilution and contaminants on sand grouted with colloidal silica.” J. Geotech. Geoenviron. Eng., 125(6), 461–469.
Persoff, P., Moridis, G. J., Apps, J., Pruess, K., and Muller, S. J. (1994). “Designing injectable colloidal silica barriers for waste isolation at the Hanford site.” In Situ Remediation: Scientific Basis for Current and Future Technologies, Proc., 33rd Hanford Symp. on Health and the Environment, Vol. 1, Pasco, Wash., 87–101.
Rollins, K. M. (2004). “Liquefaction mitigation using vertical composite drains: Full-scale testing.” NCHRP-IDEA Program Project Final Rep., Transportation Research Board, Washington, D.C., 107.
Taboada, V. M. (1995). “Centrifuge modeling of earthquake-induced lateral spreading in sand using a laminar box.” Ph.D. thesis, Dept. of Civil Engineering, Rensselaer Polytechnic Institute, Troy, N.Y.
Welch, N., and Smith, L. (2001). “Saline water intrusion adjacent to the Fraser River, Richmond, British Columbia.” Cognition, 38, 67–82.
Whang, J. M. (1995). “Section 9—Chemical-based barrier materials.” Assessment of barrier containment technologies for environmental remediation applications, R. R. Rumer and J. K. Mitchell, eds., NTIS, Springfield, Va., 211–247.
Wride, C. E., et al. (2000). “Interpretation of in-situ test results from the CANLEX sites.” Can. Geotech. J., 37, 505–529.
Youd, T. L., and Idriss, I. M. (2001). “Liquefaction resistance of soils: Summary report from the 1996 NCEER and 1998 NCEER/NSF workshops on evaluation of liquefaction resistance of soils.” J. Geotech. Geoenviron. Eng., 127(4), 297–313.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Feb 2, 2006
Accepted: Jul 18, 2006
Published online: Feb 1, 2007
Published in print: Feb 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.