Settlement of Footing on Compacted Ash Bed
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 133, Issue 11
Abstract
Compacted coal ash fills exhibit capillary stress due to contact moisture and preconsolidation stress due to the compaction process. As such, the conventional methods of estimating settlement of footing on cohesionless soils based on penetration tests become inapplicable in the case of footings on coal ash fills, although coal ash is also a cohesionless material. Therefore, a method of estimating load-settlement behavior of footings resting on coal ash fills accounting for the effect of capillary and preconsolidation stresses is presented here. The proposed method has been validated by conducting plate load tests on laboratory prepared compacted ash beds and comparing the observed and predicted load-settlement behavior. Overestimation of settlement greater than 100% occurs when capillary and preconsolidation stresses are not accounted for, as is the case in conventional methods.
Get full access to this article
View all available purchase options and get full access to this article.
References
ASTM. (2002). “Standard test method for measurement of soil potential (suction) using filter paper.” Annual book of ASTM standards, ASTM D-5298-94, Vol. 04.08, Philadelphia, 1123–1128.
Becker, D. E., Crooks, J. H. A., Been, K., and Jefferies, M. G. (1987). “Work as a criterion for determining in situ and yield stresses in clays.” Can. Geotech. J., 24, 549–564.
Bobe, R., and Pietsch, C. (1981). “Settlement calculation by a new strength theory.” Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, Vol. 1, 53–56.
Burland, J. B., Broms, B. B., and De Mello, V. F. B. (1977). “Behavior of foundation and structures.” State of the Art Rep., Proc., 9th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 2, 495–546.
Chapman, C. A., and Donald, I. B. (1981). “Interpretation of static penetration tests on sands.” Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, Vol. 2, 455–458.
Dahlberg, R. (1975). “Settlement characteristics of preconsolidated natural sands.” Document D1, Swedish Council for Building Research, Stockholm, Sweden.
D’Appolonia, D. J. D., D’Appolonia, E., and Brissette, R. F. (1968). “Settlement of spread footings on sand.” J. Soil Mech. and Found. Div., 94(3), 735–760.
Dayal, U., and Sinha, R. (2000). “Technology demonstration of structural filling of ash: Results from ICO Bottling Plant Site at Badarpur.” Proc., 2nd Int., Conf. on Fly Ash Disposal and Utilization, CBIP, New Delhi, India, VII, 43–50.
DiGioia, A. M., Meyers, J. F., and Niece, J. E. (1977). “Design and construction of bituminous fly ash disposal sites.” Proc., Conf. on Geotechnical Practice for Disposal of Solid Waste Materials, Ann Arbor, Mich., 267–284.
Grozic, J. L. H., Lunne, T., and Pande, S. (2003). “An oedometer test study on the preconsolidation stress of glaciomarine clays.” Can. Geotech. J., 40, 857–872.
Kaushik, N. P. (2000). “Performance of compacted ash and sand fills under load.” Ph.D. thesis, Univ. of Roorkee, Roorkee, India.
Leonards, G. A., and Bailey, B. (1982). “Pulverized coal ash as structural fill,” J. Geotech. Engrg. Div., 108(4), 517–531.
Martin, J. P., Collins, R. A., Browning, J. S., and Biehl, F. J. (1990). “Properties and use of fly ashes for embankments.” J. Energy Eng., 116(2), 71–86.
Onitsuka, K., Jong, Z., Hara, Y., and Yoshitake, S. (1995). “Interpretation of oedometer test data for natural clays.” Soils Found., 35, 61–70.
Ramasamy, G., Rao, A. S. R., and Singh, P. S. (1986). “Influence of capillary zone on settlement of footings on sand.” Indian Geotech. J., 16(4), 384–389.
Schmertmann, J. H. (1970). “Static cone to compute static settlement over sand.” J. Soil Mech. and Found. Div., 96(3), 1011–1043.
Seals, R. K., Moulton, L. K., and Kinder, D. L. (1977). “In-situ testing of a compacted fly ash fill.” Proc., Conf. on Geotechnical Practice for Disposal of Solid Waste Material, Ann Arbor, Mich., 493–516.
Toth, P. S., Chan, H. T., and Cragg, C. B. (1988). “Coal ash as structural fill, with special reference to Ontario experience.” Can. Geotech. J., 25, 694–704.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: May 17, 2005
Accepted: Mar 16, 2007
Published online: Nov 1, 2007
Published in print: Nov 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.