Effect of Penetration Rate on Penetrometer Resistance in Clay
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 132, Issue 9
Abstract
This paper discusses the effects of penetration rate on the penetration resistance in soft clay for various shaped penetrometers (cone, T-bar, ball, and plate) and for T-bars with different aspect ratios. Constant rate (“normal”) and variable rate (“twitch”) penetration tests, where the penetration rate was successively halved over eight steps with the penetrometer advanced by one or two diameters in each step, were undertaken in the beam centrifuge at the University of Western Australia. The tests were conducted on samples reconstituted from clay collected from the Burswood site in Western Australia. The twitch tests showed higher penetration resistance than the corresponding normal tests after the penetration rate had been reduced by a factor of 16 due to cumulative effects of partial consolidation. The penetration rate at which the resistance started to increase due to partial consolidation was used to estimate the consolidation coefficient, , of the reconstituted clay. The interpreted values were similar to values estimated from other consolidation data, both in the centrifuge and from laboratory Rowe cell and constant rate of strain consolidation tests. In addition, results from in situ twitch tests at the Burswood site were examined to evaluate viscous effects on the penetration resistance.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work forms part of the activities of the Center for Offshore Foundation Systems (COFS), established and supported under the Australian Research Council’s Research Centers Program. The first and third authors hold International Postgraduate Research Scholarships and University Postgraduate Awards from the University of Western Australia. Acknowledgment is made of the excellent technical support for the centrifuge and field penetrometer tests, principally Mr. Don Herley and Mr. Alex Duff, and also of the advice provided by Professor Marcio Almeida of the Federal Univ. of Rio de Janeiro in the planning and execution of the centrifuge tests.
References
Baligh, M. M., Azzouz, A. S., Wissa, A. Z. E., Matyin, R. T., and Morrison, M. H. (1981). “The piezocone penetrometer.” Proc., Cone penetration testing and experience, ASCE, New York, 247–263.
Bemben, S. M., and Myers, H. J. (1974). “The influence of rate of penetration on static cone resistance in Connecticut River Valley varved clay.” Proc., European Symp. on Penetration Testing, ESOPT, National Swedish Building Research, Stockholm, 2.2, 33–34.
Campanella, R. G., Robertson, P. K., and Gillespie, D. (1982). “Pore pressure during cone penetration.” Proc., 34th Canadian Geotechnical Conf., Canadian Geotechnical Society, 5.2.1-14 .
Chung, S. F., (2005). “Characterisation of soft soils for deep water developments.” Ph.D. thesis, Univ. of Western Australia, Crawley, Australia.
Chung, S. F., and Randolph, M. F. (2004). “Penetration resistance in soft clay for different shaped penetrometers.” Proc., ISC-2 on Geotechnical and Geophysical Site Characterization, A. Viana da Fonseca and P. W. Mayne, eds., Millpress, Rotterdam, 671–677.
Davis, E. H., and Poulos, H. G. (1972). “Rate of settlement under two- and three-dimensional conditions.” Geotechnique, 22(1), 95–114.
Einav, I., and Randolph, M. F. (2005). “Combining upper bound and strain path methods for evaluating penetration resistance.” Int. J. Numer. Methods Eng., 63(14), 1991–2016.
Finnie, I. M. S., and Randolph, M. F. (1994). “Punch-through and liquefaction induced failure of shallow foundations on calcareous sediments.” Proc., Int. Conf. on Behavior of Offshore Structures, Boston, 217–230.
House, A. R., Oliveira, J. R. M. S., and Randolph, M. F. (2001). “Evaluating the coefficient of consolidation using penetration tests.” Int. J. of Physical Modelling in Geotechnics, 1(3), 17–25.
Mitchell, J. K. (1976). Fundamentals of soil behavior, Wiley, New York.
Randolph, M. F. (2004). “Characterization of soft sediments for offshore applications.” Proc., ISC-2 on Geotechnical and Geophysical Site Characterization, A. Viana da Fonseca and P. W. Mayne, eds., Millpress, Rotterdam, 209–232.
Randolph, M. F., and Hope, S. (2004). “Effect of cone velocity on cone resistance and excess pore pressures.” Proc., Int. Symp. on Engineering Practice and Performance of Soft Deposits, Osaka, Japan, 147–152.
Randolph, M. F., and House, A. R. (2001). “The complementary roles of physical and computational modelling.” Int. J. of Physical Modelling in Geotechnics, 1(1), 1–8.
Randolph, M. F., Jewell, R. J., Stone, K. J. L., and Brown, T. A. (1991). “Establishing a new centrifuge facility.” Proc., Int. Conf. on Centrifuge Modelling, Boulder, Colo., 2–9.
Robertson, P. K., and Campanella, R. G. (1983). “Interpretation of cone penetrometer tests. Part II: Clay.” Can. Geotech. J., 20, 734–745.
Roy, M., Tremblay, M., Tavenas, F., and La Rochelle, P. (1982). “Development of pore pressures in quasi-static penetration tests in sensitive clay.” Can. Geotech. J., 19(2), 124–138.
Schneider, J. A., Randolph, M. F., and Chung, S. F. (2004). “Characterization of soft soils for deep water developments.” Report on variable rate penetration tests at Burswood site, Centre for Offshore Foundation Systems, Univ. of Western Australia, Crawley, Australia.
Stewart, D. P., and Randolph, M. F. (1991). “A new site investigation tool for the centrifuge.” Proc., Int. Conf. on Centrifuge Modelling, 531–538, Balkema, Rotterdam.
Watson, P. G., Newson, T. A., and Randolph, M. F. (1998). “Strength profiling in soft offshore soils.” Geotechnical site characterization, P. K. Robertson and P. W. Mayne, eds., Balkema, Rotterdam, 1389–1394.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Dec 21, 2005
Accepted: Feb 2, 2006
Published online: Sep 1, 2006
Published in print: Sep 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.