Bearing Capacity of Piled Rafts on Soft Clay Soils
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 132, Issue 12
Abstract
The conventional design of a piled foundation is based on a bearing capacity approach, and neglects the contribution of the raft. As a consequence, piled foundations are usually designed by overconservative criteria. With respect to the conventional approach, a more rational and economical solution could be obtained by accounting for the contribution of the raft toward the overall bearing capacity, but this potential is not exploited due to the lack of theoretical and experimental research on the behavior of piled rafts at failure. Based on both experimental evidence and three-dimensional finite element analyses, a simple criterion is proposed to evaluate the ultimate vertical load of a piled raft as a function of its component capacities, which can be simply evaluated by the conventional bearing capacity theories. The results presented in the paper thus provide a guide to assess the safety factor of a vertically loaded piled raft.
Get full access to this article
View all available purchase options and get full access to this article.
References
Borel, S. (2001). “Comportement et dimensionnement des fondations mixtes.” Ph.D. thesis de ENPC, Spécialité Géotechnique, Paris.
Brand, E. W., Muktabhant, C., and Taechathummarak, A. (1972). “Load tests on small foundation in soft clay.” Proc., ASCE Conf. on Performance of Earth and Earth Supported Structures, Purdue Univ., Ind., Vol. 1, Part 2, 903–928.
Briaud, J. L., Tucker, L. M., and Ng, E. (1989). “Axially loaded 5 pile group and single pile in sand.” Proc., XII ICSMFE, Vol. 2, 1121–1124.
Brinch Hansen, J. (1970). “A revised and extended formula for bearing capacity.” Bull no. 2, Danish Geotechnical Institute, Copenhagen, Denmark.
Burland, J. B., and Kalra, J. C. (1986). “Queen Elizabeth II Conference Centre: Geotechnical aspects.” Proc. ICE, 80, 1479–1505.
Calabresi, G., and Manfredini, G. (1976). “Terreni coesivi poco consistenti in Italia.” Riv. Ital. Geotec., 10(1), 49–64.
Conte, G., Mandolini, A., and Randolph, M. F. (2003). “Centrifuge modeling to investigate the performance of piled rafts.” Proc., Geotech. Int. Seminar on Deep Foundations on Bored and Auger Piles, Van Impe and Haegeman, eds., 379–386.
Cooke, R. W. (1986). “Piled raft foundations on stiff clays: A contribution to design philosophy.” Geotectonics, 36(2), 169–203.
De Mello, V. F. B. (1969). “Foundations of buildings on clay.” State-of- the-Art Report, Proc. VII ICSMFE, Vol. 1, 49–136.
Desai, C. S., Zaman, M. M., Lightner, J. G., and Siriwardane, H. J. (1984). “Thin layer element for interfaces and joints.” Int. J. Numer. Analyt. Meth. Geomech., 8, 19–43.
de Sanctis, L., and Mandolini, A. (2003). “On the ultimate vertical load of piled rafts on soft clay soils.” Proc., Geotech. Int. Seminar Deep Foundation on Bored and Auger Piles, BAP IV, Van Impe and Haegeman, eds., 379–386.
de Sanctis, L., Mandolini, A., Russo, G., and Viggiani, C. (2002). “Some remarks on the optimum design of piled rafts.” Proc., ASCE Deep Foundations 2002: An International Perspective on Theory, Design, Construction, and Performance, Reston, Va., 405–425.
Ekström, J. (1989). “A field study model pile group behaviour in noncohesive soils.” Ph.D. thesis, Dept. of Geotechnical Engineering, Chalmers Univ. of Technology, Göteborg, Sweden.
Faruque, M. O., and Desai, C. S. (1982). “3D material and geometric nonlinear analysis of piles.” Proc., 2nd Int. Conf. Num. Meth. Offshore Piling, 553–576.
Fleming, W. G. K., Weltman, A. J., Randolph, M. F., and Elson, W. K. (1992). Piling engineering, 2nd Ed., Blackie Academic, Glasgow, U.K.
Hansbo, S., and Kallstrom, R. (1983). “Creep piles—A cost effective alternative to conventional friction piles.” Vag-och Vattenbyggaren, 8(7), 29–31.
Katzenbach, R., Arslan, U., and Moormann, C. (2000). “Piled raft foundations projects in Germany. Design applications of raft foundations.” J. A. Hemsley, ed., Thomas Telford, London, 323–392.
Kezdi, A. (1957). “Bearing capacity of piles and pile groups.” Proc., IV ICSMFE, Vol. 2.
Liu, J., Yuan, Z. L., and Shang, P. K. (1985). “Cap-pile-soil interaction of bored pile groups.” Proc., XI lCSMFE, Vol. 3, 1433–1436.
Liu, J., Huang, Q., Li, H., and Hu, W. L. (1994). “Experimental research on bearing behaviour of pile groups in soft soil.” Proc., 13th ICSMFE, Vol. 2, 535–538.
Mandolini, A. (2003). “Design of piled rafts foundations: Practice and development.” Proc., Geotech. Int. Seminar Deep Foundation on Bored and Auger Piles, BAP IV, Van Impe and Haegeman, eds., 59–80.
Mandolini, A., Russo, G., Viggiani, C. (2005). “Piled foundations: Experimental investigations, analysis and design.” State-of-the-Art Rep. Proc., 16th ICSMGE, Osaka, Japan, Vol. 1, 177–213.
Meyerhof, G. G. (1951). “The ultimate bearing capacity of foundations.” Geotechnique, 2(2), 301–302.
Meyerhof, G. G. (1953). “The bearing capacity of foundations under eccentric and inclined loads.” Proc., III ICSMFE, Zurich, Vol. 1.
O’Neill, M. W., Hawkins, R. A., and Mahar, L. (1982). “Load transfer mechanisms in piles and pile groups.” J. Geotech. Engrg. Div., 108(12), 1605–1623.
Phung, D. (1993). “Footings on settlements reducing piles.” Ph.D. thesis, Dept. of Geotechnical Engineering, Chalmers Univ. of Technology, Göteborg, Sweden.
Potts, D. M., and Zdravkovic, L. (2001). Finite element analysis in geotechnical engineering. Application, Thomas Telford, London.
Potts, D. M. (2003). “Numerical analysis: A virtual dream or reality?” Geotechnique, 53(6), 635–573.
Poulos, H. G. (2000). “Practical design procedures for piled raft foundations.” Design applications of raft foundations, J. A. Hemsley, ed., Thomas Telford, London, 425–467.
Poulos, H. G. (2001). “Piled raft foundations: Design and applications.” Geotechnique, 51(2), 95–113.
Randolph, M. F. (1994). “Design methods for pile groups and piled rafts.” State of the Art Rep., Proc., 13th ICSMFE, Vol. 5, 61–82.
Randolph, M. F., Jamiolkowski, M. B., and Zdravkovic, L. (2004). “Load carrying capacity of foundations.” Keynote Lecture, Proc., Skempton Conf. on Advances in Geotechnical Engineering, Thomas Telford, London, Vol. 1, 207–240.
Russo, G., and Viggiani, C. (1998). “Factors controlling soil-structure interaction for piled rafts.” Proc., Int. Conf. on Soil-Structure Interaction in Urban Civil Engineering, 297–322.
Russo, G., Viggiani, C., and de Sanctis, L. (2004). “Piles as settlement reducers: A case history.” Advances in geotechnical engineering, The Skempton conference, Thomas Telford, London, Vol. 2, 1143–1154.
Sales, M. M. (2000). “Anàlise do comportamento de sapatas estaqueadas.” Ph.D. thesis em Geotecnia, Univ. de Brasilia.
Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.
Terzaghi, K., and Peck, R. B. (1948). Soil mechanics in engineering practice, Wiley, New York.
Van Langen, H., and Vermeer, P. A. (1991). “Interface elements for singular plasticity points.” Int. J. Numer. Analyt. Meth. Geomech., 15, 301–315.
Vesic, A. S. (1969). “Experiments with instrumented pile groups in sand.” Performance of deep foundations, ASTM special technical publication no. 444, ASTM, West Conshohocken, Pa., 177–222.
Vesic, A. S. (1973). “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. and Found. Div., 99(SM3), 45–73.
Vesic, A. S. (1975). “Bearing capacity of shallow foundations.” Foundation engineering handbook, Van Nostrand-Reinhold, N.Y., 121–147.
Viggiani, C. (2001). “Analysis and design of piled foundation.” Proc., 1st Arrigo Croce Lecture, Rivista Italiana di Geotecnica, (I), 47–75.
Whitaker, T. (1957). “Experiments with model piles in group.” Geotechnique, 7(4), 147–167.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: May 31, 2005
Accepted: Jun 2, 2006
Published online: Dec 1, 2006
Published in print: Dec 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.