Coupled Mechanical and Chemical Behavior of Bentonite Engineered with a Controlled Organic Phase
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 132, Issue 11
Abstract
This experimental investigation quantified the physical and chemical behavior of two organoclays, synthesized using the quaternary ammonium organic cations hexadecyltrimethylammonium bromide (HDTMA) and benzyltriethylammonium chloride (BTEA). The organic cations were exchanged onto montmorillonite at increasing percentages of the clay’s cation exchange capacity in order to increase the packing density of the organic cations on the clay surfaces. Increasing the organic content of the organoclays, and the cation packing density, decreased the specific gravity, -BET surface area, liquid limit in water, and clay compressibility in the consolidation test for both organoclays. However, the liquid limit in methanol and sorptive capacity for benzene increased for HDTMA organoclay but decreased for BTEA organoclay as the density of organic cation packing was increased. Additionally, the measured friction angle for HDTMA organoclay decreased, while the friction angle for BTEA organoclay increased as a function of increasing organic cation packing density. The creation of an organic phase on the soil created a hydrophobic, rather than hydrophilic, clay that demonstrated reduced interaction with water. The nature of the organic phase in the long chain HDTMA was a fluid-like phase that demonstrated partitioning uptake of organic compounds, and reduced (lubricating) frictional interaction in the direct shear test. In contrast, the organic phase in the BTEA clay formed an adsorptive phase that interacted specifically with organic compounds (that is, not through dissolution), and increased the frictional interaction as the organic cation packing density was increased.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers gratefully acknowledge support of the program director, Dr. Cliff Astill, at the National Science Foundation (Grant No. NSF9984206) through which this work was partially funded.
References
Alther, G. A. (1995). “Organically modified clay removes oil from water.” Waste Manage., 12(8), 623–628.
Bartelt-Hunt, S. L., Burns, S. E., and Smith, J. A. (2003). “Nonionic organic solute sorption onto two organobentonites as a function of organic-carbon content.” J. Colloid Interface Sci., 266(2), 251.
Bartelt-Hunt, S. L., Smith, J. A., Burns, S. E., and Rabideau, A. J. (2005). “Evaluation of granular activated carbon, shale and two organoclays for use as sorptive amendments in clay landfill liners.” J. Geotech. Geoenviron. Eng., 131(7), 848–856.
Chen, N., Maeda, N., Tirrell, M., and Israelachvili, J. (2005). “Adhesion and friction of polymer surfaces: The effect of chain ends.” Macromolecules, 38(8), 3491.
Evans, J. C., Pancoski, S. E., and Alther, G. (1989). “Organic waste treatment with organically modified clays.” Proc., 3rd Int. Conf. on New Frontiers for Hazardous Waste Management, EPA, Pittsburgh, 48–58.
Gao, J., Luedtke, W. D., Gourdon, D., Ruths, M., Israelachvili, J. N., and Landman, U. (2004). “Frictional forces and Amontons’ law: From the molecular to the macroscopic scale.” J. Phys. Chem. B, 108(11), 3410.
Houston, W. N., and Mitchell, J. K. (1969). “Property interrelationships in sensitive clays.” J. Soil Mech. and Found. Div., 95(4), 6666.
Jaynes, W. F., and Boyd, S. A. (1991). “Clay mineral type and organic compound sorption by hexadecyltrimethylammonium-exchanged clays.” Soil Sci. Soc. Am. J., 55, 43–48.
Lee, J. W., Kim, M. H., Choi, W. M., and Park, O. O. (2006). “Effects of organoclay modification on microstructure and properties of polypropylene-organoclay nanocomposites.” J. Appl. Polym. Sci., 99(4), 1752.
Li, Z., Alessi, D., Zhang, P., and Bowman, R. (2002). “Organo-illite as a low permeability sorbent to retard migration of anionic contaminants.” J. Environ. Eng., 128(7), 583–587.
Li, Z., and Bowman, R. S. (1997). “Counterion effects on the sorption of cationic surfactant and chromate on natural clinoptilolite.” Environ. Sci. Technol., 31(8), 2407–2412.
Lin, Q., Meyer, E. E., Tadmor, M., Israelachvili, J. N., and Kuhl, T. L. (2005). “Measurement of the long- and short-range hydrophobic attraction between surfactant-coated surfaces.” Langmuir, 21(1), 251.
Lo, I. M.-C. (2001). “Organoclay with soil-bentonite admixture as waste containment barriers.” J. Environ. Eng., 127(8), 756–759.
Lo, I. M. C., Mak, R. K. M., and Lee, S. C. H. (1997). “Modified clays for waste containment and pollutant attenuation.” J. Environ. Eng., 123(1), 25–32.
Lo, I. M.-C., and Yang, X. Y. (2001a). “Laboratory investigation of the migration of hydrocarbons in organobentonite.” Environ. Sci. Technol., 35(3), 620–625.
Lo, I. M.-C., and Yang, X. (2001b). “Use of organoclay as a secondary containment for gasoline storage tanks.” J. Environ. Eng., 127(2), 154–161.
Lorenzetti, R. J., Bartelt-Hunt, S. L., Burns, S. E., and Smith, J. A. (2005). “Hydraulic conductivities and effective diffusion coefficients of geosynthetic clay liners with organobentonite amendments.” Geotext. Geomembr., 23(5), 385.
Perret, D., Guaillard, J.-F., Dominik, J., and Atteia, O. (2000). “The diversity of natural hydrous iron oxides.” Environ. Sci. Technol., 34(17), 3540–3546.
Redding, A. Z., Burns, S. E., Upson, R. T., and Anderson, E. F. (2002). “Organoclay sorption of benzene as a function of total organic carbon content.” J. Colloid Interface Sci., 250, 261–264.
Ruths, M., Alcantar, N. A., and Israelachvili, J. N. (2003). “Boundary friction of aromatic silane self-assembled monolayers measured with the surface forces apparatus and friction force microscopy.” J. Phys. Chem. B, 107(40), 11149.
Say, R., Birlik, E., Denizli, A., and Ersoz, A. (2006). “Removal of heavy metal ions by dithiocarbamate-anchored polymer/organosmectite composites.” Appl. Clay Sci., 31(3–4), 298.
Seung Bae, O., Young Jun, K., and Ji Heung, K. (2006). “Preparation and properties of polyimide nanocomposites via a soluble polyisoimide precursor.” J. Appl. Polym. Sci., 99(3), 869.
Smith, J. A., Bartelt-Hunt, S. L., and Burns, S. E. (2002). “Sorption and permeability of gasoline hydrocarbons in organobentonite porous media.” J. Hazard. Mater., in press.
Smith, J. A., and Jaffe, P. R. (1994). “Benzene transport through landfill liners containing organophilic bentonite.” J. Environ. Eng., 120(6), 1559–1577.
Soule, N. M. (1999). Mechanical properties of organobentonites as function of organic cation structure, Civil engineering, University of Virginia Press, Charlottesville, Va., 133.
Soule, N. M., and Burns, S. E. (2001). “Effects of organic cation structure on behavior of organobentonites.” J. Geotech. Geoenviron. Eng., 127(4), 363–370.
Sposito, G. (1989). The chemistry of soils, Oxford University Press, New York.
Stumm, W., and Morgan, J. J. (1996). Aquatic chemistry: Chemical equilibria and rates in natural waters, Wiley, New York.
Yang, X. Y., and Lo, I. M. C. (2004). “Flow of gasoline through composite liners.” J. Environ. Eng., 130(8), 886–890.
Yeung, A. T., Viswanathan, R., and Briaud, J.-L. (1996). “Field investigation of potential contamination by bitumen-coated piles.” J. Geotech. Engrg., 122(9), 736–744.
Yoshizawa, H., Chen, Y.-L., and Israelachvili, J. (1993). “Fundamental mechanisms of interfacial friction. I: Relation between adhesion and friction.” J. Phys. Chem., 97, 4128–4140.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Dec 16, 2005
Accepted: Jun 13, 2006
Published online: Nov 1, 2006
Published in print: Nov 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.