Practical Model of Frost Heave in Clay
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 132, Issue 1
Abstract
Freezing behavior of clay differs from that of silt. This difference stems primarily from the low permeability or hydraulic conductivity of clay, and the higher water content of saturated clay. Freezing effects include simultaneous heave and consolidation. Six small physical model columns of clay were frozen: one at ; and five on a centrifuge at various scales and with corresponding accelerations, to bring self-weight stresses into similarity with a full scale column of clay in height. The experimental results demonstrated the importance of replicating the prototype stress conditions in a model. They demonstrated the importance of local water content on development of heave in clay, and the relative insensitivity of heave to location of the phreatic surface. Low permeability caused the clay to behave essentially as a closed system with regard to water flow. A simple analytical model was developed to explain observed soil response. Further research is recommended to provide more guidance in selecting input parameters.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported in part by both research and equipment funding from the Terrestrial Sciences Program of the Mechanical and Environmental Sciences Division in the Engineering Sciences Directorate U.S. Army Research Office. Their support is greatly appreciated. Interactions with research engineers at the U.S. Army Cold Regions Research and Laboratory were also very helpful in this work.USARO
References
Andersland, O. B., and Ladanyi, B. (1994). An introduction to frozen ground engineering, Chapman & Hall, New York.
Chamberlain, E. J. (1981). “Over-consolidation effects of ground freezing.” Eng. Geol. (Amsterdam), 18, 97–110.
Chamberlain, E. J., and Gow, A. J. (1979). “Effect of freezing and thawing on the permeability and structure of soils.” Eng. Geol. (Amsterdam), 13, 73–92.
Han, S. J. (2005). “Modelling freezing response in clays.” PhD Dissertation, Univ. of Maryland.
Harlan, R. L., and Nixon, J. F. (1978). “Ground thermal regime.” Geotechnical engineering for cold regions, O. B. Andersland and D. M. Anderson, eds., Chap. 3, McGraw–Hill, New York, 103–163.
Ketcham, S. A., Black, P. B., and Pretto, R. (1997). “Frost heave loading of constrained footing by centrifuge modeling.” J. Geotech. Geoenviron. Eng., 123(9), 874–880.
Konrad, J.-M. (1988). “Influence of freezing mode on frost heave characteristics.” Cold Regions Sci. Technol., 15, 161–175.
Konrad, J.-M., and Morgenstern, N. R. (1980). “A mechanistic theory of ice lens formation in fine-grained soils.” Can. Geotech. J., 17, 473–486.
Konrad, J.-M., and Seto, J. T. C. (1993). “Frost heave characteristics of undisturbed sensitive Champlain Sea clay.” Can. Geotech. J., 31, 285–298.
Miller, E. E., and Miller, R. D. (1956). “Physical theory for capillary flow phenomena.” J. Appl. Phys., 27(4), 324–332.
Nixon, J. F. (1992). “Discrete ice lens theory for frost heave beneath pipelines.” Can. Geotech. J., 29(3), 487–497.
Sharratt, B. S. (1993). “Freeze-thaw and winter temperature of agricultural soils in interior Alaska.” Cold Regions Sci. Technol., 22, 105–111.
Shoop, A. S., and Bigl, R. S. (1997). “Moisture migration during freeze and thaw of unsaturated soils: Modeling and large scale experiments.” Cold Regions Sci. Technol., 25, 33–45.
Sundberg, J. (1988). “Thermal properties of soils and rocks.” Rep. No. 35, Swedish Geotechnical Institute, Linköping, Sweden.
Washburn, A. L. (1980). Geocrylogy, Wiley, New York.
Yang, D., and Goodings, D. J. (1998a). “Climatic soil freezing modeled in centrifuge.” J. Geotech. Geoenviron. Eng., 124(12), 1186–1194.
Yang, D., and Goodings, D. J. (1998b). “Predicting frost heave using FROST model with Centrifuge models.” J. Cold Reg. Eng., 12(2), 64–83.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Feb 25, 2003
Accepted: May 23, 2005
Published online: Jan 1, 2006
Published in print: Jan 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.