Shape Factors for Limit Loads on Square and Rectangular Footings
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 131, Issue 2
Abstract
Earlier proposals for shape factors used in calculations of bearing capacity of square and rectangular footings are examined. These proposals are based on empirical data for small footings, whereas a new suggestion for these factors presented in this paper is based on the elasto-plastic model of the soil and finite element analysis. The earlier factors modifying the contribution of cohesion and overburden were found to be conservative, but acceptable in design. However, the earlier proposals for the shape factor that affects the contribution of the soil weight to the bearing capacity indicate contradictory trends, and the factor calculated in this paper is suggested as an alternative.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgment
The work presented in this paper was carried out while both writers were supported by the Army Research Office, Grant No. DAAD19-03-1-0063. This support is greatly appreciated.
References
ABAQUS. (2003). Standard user’s manual, Version 6.3-1, Pawtucket, R.I.
Bolton, M. D., and Lau, C. K. (1993). “Vertical bearing capacity factors for circular and strip footings on Mohr–Coulomb soil.” Can. Geotech. J., 30, 1024–1033.
Buisman, A. S. K. (1940). Grondmechanica, Waltman, Delft, The Netherlands.
Caquot, A. I. (1934). “Équilibre des massifs á frottement interne,” Stabilité des terres pulvérulentes et cohérentes, Gauthier-Villars, Paris.
Caquot, A., and Kerisel, J. (1953). “Sur le terme de surface dans le calcul des fondations en milieu pulverulent.” Proc., 3rd Int. Conf. Soil Mechanics Foundation Engineering, Vol. 1, Zürich, Switzerland, 336–337.
De Beer, E. E. (1970). “Experimental determination of the shape factors and the bearing capacity factors of sand.” Geotechnique, 20, 387–411.
Erickson, H. L., and Drescher, A. (2002). “Bearing capacity of circular footings.” J. Geotech. Geoenviron. Eng., 128(1), 38–43.
Frydman, S., and Burd, H. J. (1997). “Numerical studies of bearing capacity factor .” J. Geotech. Geoenviron. Eng., 123(1), 20–29.
Golder, H. Q. (1941). “The ultimate bearing pressure of rectangular footings.” J. Inst. Civ. Eng., 17(2), 161–174.
Hansen, J. B. (1970). “A revised and extended formula for bearing capacity.” Geoteknisk Inst., Bulletin 28, 5–11.
Itasca Consulting Group. (1997). , Fast Lagrangian analysis of continua in 3 dimensions, user’s manual, Minneapolis.
Menétrey, Ph., and Willam, K. J. (1995). “Triaxial failure criterion for concrete and its generalization.” ACI Struct. J., 92(3), 311–318.
Meyerhof, G. G. (1963). “Some recent research on the bearing capacity of foundations.” Can. Geotech. J., 1(1), 16–26.
Michalowski, R. L. (1997). “An estimate of the influence of soil weight on bearing capacity using limit analysis.” Soils Found., 37(4), 57–64.
Michalowski, R. L. (2001a). “Rule of equivalent states in limit state analysis of soils.” J. Geotech. Geoenviron. Eng., 127(1), 76–83.
Michalowski, R. L. (2001b). “Upper-bound load estimates on square and rectangular footings.” Geotechnique, 51(9), 787–798.
Michalowski, R. L., and Dawson, E. M. (2002). “Ultimate loads on square footings.” Proc., 8th Int. Symp. on Numerical Models in Geomechanics (NUMOG VIII), Rome, Balkema, Rottderdam, The Netherlands, 415–418.
Michalowski, R. L., and Shi, L. (1995). “Bearing capacity of footings over two-layer foundation soils.” J. Geotech. Eng., 121(5), 421–428.
Prandtl, L. (1920). “Über die Härte plastischer Körper.” Nachr. Ges. Wiss. Goettingen, Math.-Phys. Kl., 74–85.
Reissner, H. (1924). “Zum Erddruckproblem.” Proc., 1st Int. Congress for Applied Mechanics, C. B. Biezeno and J. M. Burgers, eds., Delft, The Netherlands, 295–311.
Shield, R. T. (1954). “Plastic potential theory and Prandtl bearing capacity solution.” J. Appl. Mech., 21(2), 193–194.
Shield, R. T., and Drucker, D. C. (1953). “The application of limit analysis to punch-indentation problems.” J. Appl. Mech., 20, 453–460.
Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.
Vesic, A. S. (1973). “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. Found. Div., 99(1), 45–76.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Oct 28, 2003
Accepted: May 18, 2004
Published online: Feb 1, 2005
Published in print: Feb 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.