Method for Calculating the Edge Moisture Variation Distance
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 130, Issue 9
Abstract
A three-dimensional moisture diffusion and volume change model was developed for determining the distribution of soil suction and the associated volume changes in an expansive soil mass under a covered area (e.g., slab foundations or pavements) with respect to time. The model was used to determine a relationship among the edge moisture variation distance, the amplitude of surface suction change, and the diffusion coefficient of the soil, α. The edge moisture variation distance calculation is based on the change in soil suction beneath the covered area as a result of climate changes. The edge moisture variation distance is considered to be the distance between the edge of the covered area and the point beneath the covered area where suction change is no more than 0.12 kPa (0.1 pF). Comparison between the predicted values of edge moisture variation distance by using the proposed relationship to that measured in the field or predicted by other methods is also presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
Aitchison, G. D., and Richards, B. G. (1969). “The fundamental mechanisms involved in heave and soil moisture movement and the engineering properties of soils which are important in such movement.” Proc., 2nd Int. Conf. on Expansive Soils, College Station, Tex., 66–84.
Bratton, W. L. (1991). “Parameters for predicting shrink/heave beneath slab-on-ground foundations over expansive clays.” PhD dissertation, Dept. of Civil Engineering, Texas Tech Univ., Lubbock, Tex.
Building Research Advisory Board (BRAB). (1968). “Criteria for selection and design of residential slabs-on-ground.” Publication 1571, National Academy of Sciences.
Champra, S. C., and Canale, R. P. (1998). Numerical methods for engineers with programming and software applications, 3rd Ed., WCB/McGraw-Hill, New York.
El-Garhy, B. M. (1999). “Soil suction and analysis of raft foundation resting on expansive soils,” PhD dissertation, Civil Engineering Dept., Minufiya Univ., Egypt.
El-Garhy, B. M., Wray, W. K., and Youssef, A. A. (2000a). “Using soil diffusion to design raft foundation on expansive soils.” Proc., Sessions of Geo-Denver 2000, Geotechnical Special Publication No. 99, ASCE, Reston, Va., 586–602.
El-Garhy, B. M., Youssef, A. A., and Wray, W. K. (2000b). “Comparison of field measured and predicted soil suction and volume changes in expansive soil.” Proc., 1st Int. Conf. and Exhibition on Geotechnical, Geoenvironmental Engineering and Management in Arid Lands, Al Ain, UAE.
Holland, J. E., and Lawrance, C. E. (1980). “Seasonal heave of Australian clay soil.” Proc., 4th Int. Conf. on Expansive Soils, Denver, Vol. 1, 302–321.
Jones, D. E., and Holtz, W. G. (1973). “Expansive soils the hidden disaster.” Civ. Eng., Mag. 43(8), 49–51.
Krohn, J. P., and Slosson, J. E. (1980). “Assessment of expansive soils in the United States.” Proc., 4th Int. Conf. on Expansive Soils, Colo Vol. 1, 596–608.
Lytton, R. L. (1994). “Prediction of movement in expansive clay,” Proc., Vertical and Horizontal Deformations of Foundations and Embankments, ASCE Geotechnical Special Publication No. 40, Vol. 2, ASCE, New York, 1827–1845.
Lytton, R. L., and Woodburn, J. A. (1973). “Design and performance of mat foundations on expansive clay.” Proc., 3rd Int. Conf. on Expansive Soils, Haifa, Vol. 1, 301–307.
McKeen, R. G. (1980). “Field studies of airport pavements on expansive clay,” Proc., 4th Int. Conf. on Expansive Soils, Denver, Vol. 1, 242–261.
McKeen, R. G., and Johnson, L. D.(1990). “Climate-controlled soil design parameters for mat foundations.” J. Geotech. Eng., 116(7), 1073–1094.
Mitchell, P. W. (1980). “The concepts defining the rate of swell in expansive soils.” Proc., 4th Int. Conf. on Expansive Soils, Denver, Vol. 1, 106–116.
Post-Tensioning Institute (PTI) (1980). Design and construction of post-tensioned slabs-on-ground, 1st Ed., Post-Tensioning Institute, Phoenix.
Post-Tensioning Institute (PTI) (1996). Design and construction of post-tensioned slabs-on-ground, 2nd Ed., Post-Tensioning Institute, Phoenix.
Richards, D. G., and Chan, C. Y.(1971). “Theoretical analysis of subgrade moisture under Australian environmental conditions and their practical implications.” Aust. Road Res., 4(6), 32–49.
Russam, K., and Coleman, J. D.(1961). “The effect of climatic factors on subgrade moisture conditions.” Geotechnique, 11(1), 22–28.
Standards Association of Australia (1990). “Residential slabs and footings, Part 2: Guide to design by engineering principles.” AS 2870.2 Standard House, Sydney NSW, Australia.
Thornthwaite, C. W. (1948). “An Approach Toward a Rational Classification of Climate,” Geogr. Rev., Vol. 38, pp. 55–94.
Wray, W. K. (1978). “Development of a design procedure for residential and light commercial slabs-on-ground constructed over expansive soils.” Geogr. Rev., PhD dissertation, Texas A&M University, College Station, Tex.
Wray, W. K. (1989a). “Mitigation of damage to structures supported on expansive soils.” Final Rep., National Science Foundation, Grant No. EKE-8320493, Vol. 1.
Wray, W. K. (1989b). “Field measurement of edge moisture variation distance.” Proc., 12th Int. Conf. on Soil Mechanics and Foundation Engineering, Rio de Janeiro, Vol. 1, 663–666.
Wray, W. K. (1997). “Using soil suction to estimate differential soil shrink or heave.” Proc., Unsaturated Soil Engineering Practice, Geotechnical Special Publication No. 68, ASCE, Reston, Va., 66–87.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Nov 6, 2001
Accepted: Jun 2, 2003
Published online: Aug 16, 2004
Published in print: Sep 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.