Measuring the Hydraulic Conductivity of Soil–Bentonite Backfill
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 130, Issue 12
Abstract
The hydraulic conductivity of soil–bentonite backfill in three pilot-scale cutoff walls was measured using laboratory tests on disturbed samples, laboratory tests on undisturbed samples, piezocone dissipation tests, and piezometer tests (also known as slug tests or single-well tests). In addition, a global measurement of the average hydraulic conductivity of the soil–bentonite backfill in one of the cutoff walls was made using the pilot-scale test facility. Two main factors distinguish these five different methods of measuring hydraulic conductivity: remolding and sample size. Remolding of samples tested in American Petroleum Institute filter press equipment significantly reduced their hydraulic conductivity compared to the hydraulic conductivity of undisturbed samples, which were of similar size. For the other tests, where the degree and extent of remolding were less significant, hydraulic conductivity was found to increase as sample size increased, with the global measurement producing the highest value. The existence of bentonite filter cakes on trench walls reduces the influence of sample size on the equivalent hydraulic conductivity of the barrier. Findings regarding locating defects with a piezocone and hydraulic fracture in piezometer tests are also presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Baligh, M.M., and Levadoux, J.N. ( 1980). “Pore pressure dissipation after cone penetration.” Rep. No. R80-11, Dept. of Civil Engineering, Massachusetts Institute of Technology, Cambridge, Mass.
2.
Barvenik, M.J., and Ayres, J.E. ( 1987). “Construction quality control and post-construction performance verification for the Gilson Road Hazardous Waste Site cutoff wall.” Rep. No. EPA/600/2–87/065, U. S. Environmental Protection Agency, Cincinnati.
3.
Benson, C. H., Gunter, J. A., Boutwell, G. P., Trautwein, S. J., and Berzanskis, P. H. (1997). “Comparison of four methods to assess hydraulic conductivity.” J. Geotech. Geoenviron. Eng. 123(10), 929–937.
4.
Brigham Young University ( 1994). GMS, version 3.1, Provo, Utah.
5.
Britton, J.P. ( 2001). “Soil–bentonite cutoff walls: Hydraulic conductivity and contaminant transport.” PhD dissertation, Virginia Polytechnic Institute & State Univ., Blacksburg, Va., http://scholar.lib.vt.edu/theses/available/etd-08132001-175622/.
6.
Britton, J.P., Filz, G.M., Little, J.C., and Herring, W. ( 2002). “Shape factors for single-well tests in soil–bentonite cutoff walls.” Proc., 4th Int. Congress on Environmental Geotechnics, ISSMGE, Congress in Rio de Janeiro, Swets and Zeittinger, Lisse, The Netherlands, 639–644.
7.
Butler, J. J. (1996). “Slug tests in site characterization: some practical considerations.” Envir. Geosciences 3(2), 154–163.
8.
Daniel, D. E. (1984). “Predicting hydraulic conductivity of clay liners.” J. Geotech. Eng. 110(2), 285–300.
9.
Daniel, D.E., and Choi, H. ( 1999). “Hydraulic conductivity evaluation of vertical barrier walls.” Geo-engineering for underground facilities, GSP No. 90, Proc., 3rd National Conference of the Geo-Institute of ASCE, Reston, Va., 140–161.
10.
D‘Appolonia, D. J. (1980). “Soil-bentonite slurry trench cutoffs.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng. 106(4), 399–417.
11.
Evans, J.C. ( 1991). “Geotechnics of hazardous waste control systems.” Foundation engineering handbook, 2nd Ed., H.-Y. Fang, ed., Chapman and Hall, New York, 750–777.
12.
Evans, J.C. ( 1994). “Hydraulic conductivity of vertical cutoff walls.” Hydraulic conductivity and waste contaminant transport in soil, ASTM STP 1142, D. E. Daniels and S. J. Trantwein, Eds, American Society for Testing and Materials, Philadelphia.
13.
Evans, J.C. ( 1995). “Soil- and cement-based vertical barriers with focus on materials.” Assessment of barrier containment technologies - A comprehensive treatment for environmental remediation applications, R. Rumer and J. Mitchell, eds., U. S. Dept. of Energy, Washington, D.C., 5–43.
14.
Evans, J.C., Costa, M.J., and Cooley, B. ( 1995). “The state-of-stress in soil-bentonite slurry trench cutoff walls.” Proc., Geoenvironment 2000, GSP No. 46, ASCE, New York, 1173–1191.
15.
Filz, G.M. ( 1996). “Consolidation stresses in soil-bentonite backfilled trenches.” Proc., 2nd Int. Congress on Environmental Geotechnics, Osaka, Japan, 497–502.
16.
Filz, G. M., Henry, L. B., Heslin, G. M., and Davidson, R. R. (2001). “Determining hydraulic conductivity of soil-bentonite using the API filter press.” Geotech. Test. J. 24(1), 61–71.
17.
Filz, G.M., Little, J.C., and Britton, J.P. ( 1998). “A pilot-scale subsurface barrier test facility.” Proc., 4th Int. Symp. on Environmental Geotechnology and Global Sustainable Development, Danvers, Mass., 1511–1520.
18.
Filz, G.M., and Mitchell, J.K. ( 1995). “Design, construction, and performance of soil- and cement-based vertical barriers.” Assessment of barrier containment technologies - A comprehensive treatment for environmental remediation applications, R. Rumer and J. Mitchell, eds., U. S. Dept. of Energy, Washington, D.C., 45–75.
19.
Henry, L.B., Filz, G.M., and Davidson, R.R. ( 1998). “Formation and properties of bentonite filter cakes.” Proc., Filtration and Drainage in Geotechnical/Geoenvironmental Engineering, GSP No. 78, ASCE, Reston, Va., 69–88.
20.
Houlsby, G.T., and Teh, C.I. ( 1988). “Analysis of the piezocone in clay.” Proc., Int. Symp. on Penetration Testing ISOPT-1, Balkema, Rotterdam, The Netherlands.
21.
Hvorslev, M.J. ( 1951). “Time lag and soil permeability in ground-water observations.” Bulletin No. 36, U.S. Army Corps of Engineers Waterways Experiment Station, Vicksburg, Miss.
22.
Lunne, T., Robertson, P.K., and Powell, J.J. M. ( 1997). Cone penetration testing in geotechnical practice, Chapman and Hall, London.
23.
Manassero, M. (1994). “Hydraulic conductivity assessment of slurry wall using piezocone test.” J. Geotech. Eng. 120(10), 1725–1746.
24.
Olson, R.E., and Daniel, D.E. ( 1981). “The measurement of the hydraulic conductivity of fine grained soils.” Permeability and ground water contaminant transport, ASTM STP 746, T. F. Zimmie and C. O. Riggs, eds., American Society for Testing and Materials, Philadelphia, 18–64.
25.
Schneider, J. ( 1994). “Soil bentonite cut-off walls.” Proc., Specialty Symp. on Slurry Trench Cut-Offs, Australian National Committee on Large Dams, Singleton, New South Wales.
26.
Shackelford, C. D., and Javed, F. (1991). “Large-scale laboratory permeability testing of a compacted clay soil.” Geotech. Test. J. 14(2), 171–179.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 130 • Issue 12 • December 2004
Pages: 1250 - 1258
Copyright
Copyright © 2004 ASCE.
History
Published online: Nov 15, 2004
Published in print: Dec 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.