Properties and Performance of a Pulverized Fly Ash Grout
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 128, Issue 8
Abstract
A laboratory investigation was conducted in order to develop a new grout based on fly ash produced in Greece. Ptolemaida fly ash was selected because of its hydraulic properties and was pulverized (Blaine specific surface over 8,300 cm2/gr, and in order to improve its groutability and its hydraulic activity. Pulverized fly ash (PFA) suspensions with selected additives have properties comparable to those of ordinary and microfine cement suspensions. Clean sands were injected using two specially constructed devices. Hydraulic conductivity, unconfined compression, and UU and CU-PP triaxial compression tests were conducted on grouted sand specimens. Coarse sands can be grouted effectively with PFA suspensions. Conventional groutability ratios were found to overestimate the groutability of these suspensions. Grouting with PFA suspensions reduces sand hydraulic conductivity by up to seven orders of magnitude and yields unconfined compression strength values up to 3,000 kPa. The Mohr–Coulomb failure criterion represents the behavior of grouted sand with cohesion values ranging from 280 to 450 kPa and angle of internal friction slightly higher than that of the sands.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bishop, A. W., and Eldin, G.(1950). “Undrained triaxial tests on saturated sands and their significance in the general theory of shear strength.” Geotechnique, 11(1), 13–32.
Christopher, B. R., Atmatzidis, D. K., and Krizek, R. J.(1989). “Laboratory testing of chemically grouted sand.” Geotech. Test. J., 12(2), 109–118.
Clarke, W. J., Boyd, M. D., and Helal, M. (1992). “Ultrafine cement tests and dam test grouting.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 626–638.
De Paoli, B., Bosco, B., Granata, R., and Bruce, D. A. (1992a). “Fundamental observations on cement based grouts (1): Traditional material.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 474–485.
De Paoli, B., Bosco, B., Granata, R., and Bruce, D. A. (1992b). “Fundamental observations on cement based grouts (2): Microfine cements and Cemill® process.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 486–499.
Deere, D. U., and Lombardi, G. (1985). “Grout slurries—Thick or thin?” Proc., Issues in Dam Grouting, W. H. Baker, ed., ASCE, Denver, 156–164.
Hausmann, M. R. (1990). Engineering principles of ground modification, McGraw-Hill, Singapore.
Head, K. H. (1982). Manual of soil laboratory testing, Pentech, London, 2.
Head, K. H. (1986). Manual of soil laboratory testing, Pentech, London, 3.
Helal, M., and Krizek, R. J. (1992). “Preferred orientation of pore structure in cement-Grouted sand.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 526–540.
Karol, R. H. (1982). “Chemical grouts and their properties.” Proc., Conf. on Grouting in Geotech. Engineering, W. H. Baker, ed., ASCE, New Orleans, 1, 359–377.
Karol, R. H. (1985). “Grout penetrability.” Proc., Issues in Dam Grouting, W. H. Baker, ed., ASCE, Denver, 27–33.
Krizek, R. J., Atmatzidis, D. K., and Wu, Z. H. (1986). “Behavior of grouted Erksak sand.” Dept. of Civil Engineering, Northwestern Univ., Evanston, Ill.
Krizek, R. J., Benltayf, M. A., and Atmatzidis, D. K. (1982). “Effective stress–strain–strength behavior of silicate-grouted sand.” Proc., Conf. on Grouting in Geotech. Eng., W. H. Baker, ed., ASCE, New Orleans, 1, 482–497.
Krizek, R. J., and Helal, M. (1992). “Anisotropic behavior of cement-grouted sand.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 541–550.
Krizek, R. J., Liao, H. J., and Borden, R. H. (1992). “Mechanical properties of microfine cement/sodium silicate grouted sand.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 688–699.
Lau, D., and Crawford, A. (1986). “Grouting for the underground containment of radioactive waste.” Rep. for Atomic Energy of Canada Ltd., Dept. of Civil Eng., Univ. of Toronto, Toronto.
Legendre, Y., Hery, Ph., and Vattement, H. (1987). “Microsol grouting, a method for grouting fine alluvium.” Proc., 6th Int. Offshore Mech. and Arctic Eng. Symp., ASME, Houston, 1, 433–440.
Liao, H. J., Borden, R. H., and Krizek, R. J. (1992). “Microfine cement/sodium silicate grout.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 676–687.
Littlejohn, G. S. (1982). “Design of cement based grouts.” Proc., Conf. on Grouting in Geotech. Eng., W. H. Baker, ed., ASCE, New Orleans, 1, 35–48.
Mc Laren, R. J., and Di Gioia, A. M., Jr. (1987). “The typical engineering properties of fly ash.” Proc., Geotech. Practice for Waste Disposal ’87, Spec. Conf., R. D. Woods, ed., ASCE, Ann Arbor, Mich., 683–697.
Mehta, P. K. (1983). “Pozzolanic and cementitious by-products as mineral admixtures for concrete—A critical review.” Proc., Fly Ash, Silica Fume, Slag and other Mineral By-Products in Concrete, 1st Int. Conf., V. M. Malhotra, ed., ACI, Montebello, Calif., 1, 1–46.
Mehta, P. K. (1989). “Pozzolanic and cementitious by-products in concrete—Another look.” Proc., Fly Ash, Silica Fume, Slag, and Natural Pozzolans in Concrete, 3rd Int. Conf., V. M. Malhotra, ed., ACI, Trondheim, Norway, 1, 1–43.
Mitchell, J. K. (1981). “Soil improvement—State of the art report.” Proc., 10th Int. Conf. on Soil Mech. and Foundation Eng., A. A. Balkema, Stockholm, Sweden, 4, 509–565.
NAVFAC, DM-7.3 (1983). Soil dynamics, deep stabilization, and special geotechnical construction, Dept. of the Navy, Naval Facilities Eng. Command, Alexandria, Va., U.S. Government Printing Office, Washington D.C.
Nonveiller, E. (1989). “Grouting theory and practice.” Developments in Geotechnical Engineering, Elsevier Science, Amsterdam, The Netherlands, 57.
O’Connor, K. M., Krizek, R. J., and Atmatzidis, D. K.(1978). “Microcharacteristics of chemically stabilized granular materials.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 104(7), 939–952.
Paillere, A. M., Buil, M., Miltiadou, A., Guinez, R., and Serrano, J. J. (1989). “Use of silica fume and superplasticizers in cement grouts for injection of fine cracks.” Proc., Fly Ash, Silica Fume, Slag, and Natural Pozzolans in Concrete, 3rd Int. Conf., V. M. Malhotra, ed., ACI, Trondheim, 2, 1131–1157.
Papayianni, J. (1986). “Strength and bond data for Greek high-lime fly ash concrete.” Proc., Fly Ash, Silica Fume, Slag, and Natural Pozzolans in Concrete, 2nd Int. Conf., V. M. Malhotra, ed., ACI, Madrid, 1, 367–386.
Papayianni, J.(1987). “An investigation of the pozzolanicity and hydraulic reactivity of a high-lime fly ash.” Mag. Concrete Res., 39(138), 19–27.
Schwarz, L. G., and Krizek, R. J. (1992). “Effects of mixing on rheological properties of microfine cement grout.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 512–525.
Shimoda, M., and Ohmori, H. (1982). “Ultrafine grouting material.” Proc., Conf. on Grouting in Geotech. Eng., W. H. Baker, ed., ASCE, New Orleans, 1, 77–91.
Verfel, J. (1989). “Rock grouting and diaphragm wall construction.” Developments in Geotech. Eng., Elsevier Science, Amsterdam, The Netherlands, 55.
Vipulanandan, C., and Ata, A. (1992). “Bonding strength of grouts and behavior of silicate grouted sand.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 700–711.
Vipulanandan, C., and Shenoy, S. (1992). “Properties of cement grouts and grouted sands with additives.” Proc., Conf. on Grouting, Soil Improvement and Geosynthetics, R. H. Borden, R. D. Holtz, and I. Juran, eds., ASCE, New Orleans, 1, 500–511.
Weaver, K. D., Evans, J. C., and Pancoski, S. E.(1990). “Grout testing for a hazardous waste application.” Concr. Int.: Des. Constr., 12(7), 45–47.
Zebovitz, S. (1986). “Injection of microfine cement grout into various gradations of sands.” MSc thesis, Dept. of Civil Eng., Northwestern Univ., Evanston, Ill.
Zebovitz, S., Krizek, R. J., and Atmatzidis, D. K.(1989). “Injection of fine sands with very fine cement grout.” J. Geotech. Eng., 115(12), 1717–1733.
Ziming, W., Daneng, H., and Yaosheng, X. (1990). “Investigation of the rheological properties and groutability of fresh cement pastes.” Proc., Rheology of Fresh Cement and Concrete, Int. Conf., P. F. G. Banfill, ed., E. & F. N. Spon, Liverpool, 207–213.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Dec 21, 2000
Accepted: Apr 9, 2001
Published online: Jul 15, 2002
Published in print: Aug 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.